This is a preview of subscription content, log in via an institution to check access.
Literature cited
C. J. Beevers, “Threshold ΔK values and nonclosure of fatigue crack,” in: Advances in Fracture: Research Reports of the 5th International Conference on Fracture (Cannes, 1981), Vol. 3, Oxford (1981), pp. 1335–1342.
P. E. Irving, J. L. Robinson, and C. J. Beevers, “A study of the effects of mechanical and environmental variables on fatigue crack closure,” Eng. Fract. Mech.,7, No. 4, 619–630 (1975).
K. Minakawa, J. C. Newman, and A. J. McEvily, “A critical study of the crack closure effect on near-threshold fatigue crack growth,” Fatigue Eng. Mater. Struct.,6, No. 4, 359–366 (1983).
O. N. Romaniv, G. N. Nikiforchin, and B. N. Andrusiv, “The effect of crack closure and determination of the cyclic crack resistance of constructional alloys,” Fiz.-Khim. Mekh. Mater., No. 3, 47–61 (1983).
W. Elber, “Fatigue crack closure under cyclic tension,” Eng. Fract. Mech.,2, No. 1, 37–45 (1970).
W. Elber, “The significance of fatigue crack closure,” in: Damage Tolerance in Aircraft Structures. ASTM STP 486, ASTM, Philadelphia (1971), pp. 230–262.
D. Benoit, R. Namdar-Irani, and R. Tixier, “Oxidation of fatigue fracture surface at low crack growth rate,” Mater. Sci. Eng.,45, No. 1, 1–7 (1980).
S. Suresh, G. F. Zamiski, and R. O. Ritchie, “Oxide-induced crack closure: an explanation for near-threshold corrosion fatigue crack growth behavior,” Met. Trans.,12A, No. 8, 1435–1443 (1981).
K. Minakawa and A. J. McEvily, “On crack closure in the near-threshold region,” Scr, Met.,15, No. 6, 633–636 (1981).
RD 50-345-82. Method Instructions. Calculations and Tests for Strength. Methods of Mechanical Tests of Metals. Determination of the Characteristics of Crack Resistance (Fracture Toughness) in Cyclic Loading [in Russian], Standartov, Moscow (1983).
A. Otsuka, K. Mori, and T. Miyata, “The condition of fatigue crack growth in mixed mode conditions,” Eng. Fract. Mech.,7, No. 3, 429–439 (1975).
S. Suresh and R. O. Ritchie, “Some considerations on the modelling of oxide-induced fatigue crack closure using solutions for a rigid wedge inside a linear elastic crack,” Scr. Met.,17, No. 4, 575–580 (1983).
A. T. Stewart, “The influence of environment and stress ratio on fatigue crack growth at near-threshold stress intensities in low-alloy steels,” Eng. Fract. Mech.,13, No. 3, 468–478 (1980).
S. Suresh and R. O. Ritchie, “On the influence of fatigue underloads on cyclic crack growth at low stress intensities,” Mater. Sci. Eng.,51, No. 1, 61–70 (1981).
V. T. Troshchenko, V. V. Pokrovskii, V. G. Kaplunenko, et al., “The influence of specimen dimensions on the crack resistance of heat-resistant shell steels,” Probl. Prochn., No. 10, 3–10 (1982).
A. J. Cadman, R. Brook, and C. E. Nichelson, “Effect of test technique on fatigue threshold (AK),” in: Preliminary Proceedings from the International Symposium of Fatigue Threshold (Stockholm, Sweden), Vol. 2 (1981), pp. 33/1–33/24.
S. Suresh and R. O. Ritchie, “On the influence of environment on the load ratio dependence of fatigue thresholds in pressure vessel steel,” Eng. Fract. Mech.,18, No. 4, 785–800 (1983).
J. A. Lewis, “Fatigue threshold in medium strength steel,” in: Fatigue Threshold, Vol. 2, EMAS, Warley (1982), pp. 1127–1141.
Author information
Authors and Affiliations
Additional information
Translated from Fiziko-Khimicheskaya Mekhanika Materialov, Vol. 20, No. 6, pp. 62–70, November–December, 1984.
Rights and permissions
About this article
Cite this article
Romaniv, O.N., Tkach, A.N. & Lenets, Y.N. Possible disturbance of invariance of fatigue failure curves caused by the phenomenon of crack closure. Mater Sci 20, 562–569 (1985). https://doi.org/10.1007/BF00723556
Received:
Issue Date:
DOI: https://doi.org/10.1007/BF00723556