Changes in the endurance of alloy D16AT after cyclic overloading
- 14 Downloads
The variation in the endurance of alloy D16AT at various fatigue stages after cyclic overloading in air and in a 3% NaCl solution was studied. It was shown that the endurance after a small number of overloading cycles (6–18% of the total number of cycles to fracture N1) is reduced; it increases to a maximum after a large number of overloading cycles (18–50% N1, and then decreases again when the number of overloading cycles is further increased. Increasing the number of overloading cycles in a 3% NaCl solution leads to a gradual decrease in the endurance of the alloy studied.
KeywordsFatigue Gradual Decrease Alloy D16AT Fatigue Stage Cyclic Overload
Unable to display preview. Download preview PDF.
- 1.K. Memler and K. Laute, VDI, H. 329, 1929.Google Scholar
- 2.J. Smith, Iron and Steel Institute, no. 120, 1910.Google Scholar
- 3.V. M. Bakharev, Trudy TsIAM, no. 19, NKAP, Oborongiz, 1945.Google Scholar
- 4.G. I. Pogodin-Alekseev, ZL, no. l, 1949.Google Scholar
- 5.N. I. Marin, collection: Strength and Wear of Mining Equipment [in Russian], Gosgortekhizdat, Moscow, 1959.Google Scholar
- 6.G. G. Maksimovich and G. V. Karpenko, AL, no. 1, 1962.Google Scholar
- 7.G. I. Pogdin-Alekseev, collection: Increasing the Endurange of Machine Parts [in Russian], GNTIML, Moscow, 1959.Google Scholar
- 7.aG. I. Pogodin-Alekseev, collection: Increasing the Endurance of Machine Parts [in Russian], GNTIML, Moscow, 1959.Google Scholar