Literature cited
V. A. Livdar, L. I. Savchenko, and A. A. Galasi, “A method of the optimum reinforcement of a hole in bending transversally isotropic sheets,” in: Proceedings of a Seminar of the Department of Differential Equations and Mathematical Physics of Uzhgorod State University, deposited at the All-Union Scientific-Research Institute of Technical Information, 01.06.87, No. 3 (185).
B. L. Pelekh and V. A. Livdar, “The effect of preliminary deformation of the reinforcement ring in bending a transversally isotropic sheet weakened with a circular hole,” Dokl. Akad. Nauk. Ukr. SSR, Ser. A, No. 4, 275–278 (1979).
V. V. Trofimovich and V. A. Permyakov, Optimum Design of Metallic Structures [in Russian], Budivel'nik, Kiev (1981).
M. P. Sheremet'ev, Plates with Reinforced Edge [in Russian], Lvov Univ., Lvov (1969).
I. A. Birger and Ya. G. Panovko (eds.), Strength, Stability, Oscillations (Handbook) [in Russian], Vol. 1, Mashinostroenie, Moscow (1968).
T. Schup, Solving Engineering Problems in a Computer [Russian translation], Mir, Moscow (1982).
Author information
Authors and Affiliations
Additional information
Translated from Fiziko-Khimicheskaya Mekhanika Materialov, No. 4, pp. 92–96, July–August, 1988.
Rights and permissions
About this article
Cite this article
Luchko, I.I., Livdar, V.A. Calculation and design of sheets with a circular hole with equal strength reinforcement and with minimum mass. Mater Sci 24, 415–418 (1989). https://doi.org/10.1007/BF00720656
Received:
Issue Date:
DOI: https://doi.org/10.1007/BF00720656