Advertisement

Metal Science and Heat Treatment

, Volume 17, Issue 9, pp 776–779 | Cite as

Effect of hydroextrusion on mechanical properties and phase composition of Fe−Ni−Cr alloys

  • B. I. Beresnev
  • I. Ya. Georgieva
  • G. A. Pegushina
  • E. G. Ponyatovskii
Stainless Steels
  • 19 Downloads

Conclusions

  1. 1.

    It was shown on the basis of Fe−Ni−Cr−C alloys that hydroextrusion is an effective means of controlling the phase composition and mechanical properties of alloys in the metastable condition.

     
  2. 2.

    Warm hydroextrusion of stainless steels containing 0.15–0.35% C leads to a simultaneous and quite substantial improvement of the strength and ductile characteristics.

     

Keywords

Mechanical Property Stainless Steel Phase Composition Metastable Condition Substantial Improvement 
These keywords were added by machine and not by the authors. This process is experimental and the keywords may be updated as the learning algorithm improves.

Preview

Unable to display preview. Download preview PDF.

Unable to display preview. Download preview PDF.

Literature cited

  1. 1.
    D. K. Bulychev et al., "Relationship between the metastable phase diagram, phase composition, and properties of hydroextruded manganese alloys", Fiz. Metal. Metalloved.,32, No. 6, 1260 (1971).Google Scholar
  2. 2.
    T. P. Ershova, E. G. Ponyatovskii, and I. L. Aptekar, "Metastable equilibrium diagram of Fe−Mn alloys", in: Theoretical and Experimental Methods of Investigating Phase Diagrams [in Russian], Nauka, Moscow (1969), p. 276.Google Scholar
  3. 3.
    H. Schumann Neue Hütte, No. 9, 547 (1968).Google Scholar
  4. 4.
    J. Breedis and L. Kaufman, Met. Trans.,2, 2359 (1971).Google Scholar
  5. 5.
    H. Schumann, Tech. Univ. Dresden,19, No. 3, 575 (1970)Google Scholar
  6. 6.
    B. I. Beresnev et al., Ductility and Strength of Solids Under High Pressures [in Russian], Nauka, Moscow (1970), p. 12.Google Scholar
  7. 7.
    V. Zackay et al., TASM,60, 252 (1967).Google Scholar
  8. 8.
    Yu. G. Virakhovskii et al., "Use of the martensitic transformation induced by deformation to increase the ductility of austenitic steels hardened by warm strain hardening", Fiz. Metal. Metalloved.,32, No. 2, 348 (1971).Google Scholar
  9. 9.
    J. Skarek, F. Habrovec, and J. Kounicky, Sbornik Ved. pr. Vys. Škoby Baňske, Ostrava, XIII, No. 4, 368 (1967).Google Scholar
  10. 10.
    Nikon Kindzoku Gakkaisi,33, No. 2, 1383 (1969).Google Scholar

Copyright information

© Plenum Publishing Corporation 1976

Authors and Affiliations

  • B. I. Beresnev
  • I. Ya. Georgieva
  • G. A. Pegushina
  • E. G. Ponyatovskii

There are no affiliations available

Personalised recommendations