Literature cited
V. I. Ivanov and K. A. Osipov, Recovery and Recrystallization in Metals during Rapid Heating [in Russian], Nauka, Moscow (1964).
M. N. Bodyako, S. A. Astapchik, and G. B. Yaroshevich, Thermokinetics of Recrystallization [in Russian], Nauka i Tekhnika, Minsk (1968).
M. N. Bodyako, S. A. Astapchik, and G. B. Yaroshevich, Recovery — Polygonization [in Russian], Nauka i Tekhnika, Minsk (1970).
G. Pomey, "Comparaison de quelques essais d'emboutissage", Rev. Metall.,63, 823–841 (1966).
W. T. Lankford, S. C. Snyder, and J. A. Bauscher, "New criteria for predicting the press performance of deep drawing sheets", Trans. Am. Soc. Metall.,42, 1197–1225 (1950).
R. H. Heyer and R. L. Solter, "Written discussion", Trans. Am. Soc. Metall.,42, 1226–1229 (1950).
P. Hroch, "Anizotropie medenych plechu", Hutnik,12, 466–470 (1973).
J. H. Hollomon, "Tensile deformation", AIMME, Met. Techn.,12, 1879–1883 (1945).
Z. Jasienski, T. Kozubowski, G. Zaborowski, et al., "Wplyw procesu technologicznego na wlasnosci i strukture tasm praeznaczonych do glebokiego tolczenia," in: Mat. Konf. "Obrobka Plastyczna 79," Vol. 1 (1979), pp. 73–85.
A. Turno, "Normalna anizotropia plastyczna blach. Jej pomiar i wykorzystanie do przewidywania tlocznosci", Obrobka Plastyczna, Vols. 3–4 (1969), pp. 385–433.
Z. Jasienski and S. Wierzbinski, "Wplyw wielkosci ziarna na przebieg umocnienia metali ukladu Al poddanych probie rozciagania", Archiwum Hutnictwa,15, 27–54 (1970).
Additional information
Polish People's Republic. Translated from Metallovedenie i Termicheskaya Obrabotka Metallov, No. 7, pp. 33–36, July, 1985.
Rights and permissions
About this article
Cite this article
Wierzbinski, S. Anisotropy of the plasticity of copper strips after anisotropic recrystallization heat treatment. Met Sci Heat Treat 27, 517–521 (1985). https://doi.org/10.1007/BF00699583
Issue Date:
DOI: https://doi.org/10.1007/BF00699583