Advertisement

Metal Science and Heat Treatment

, Volume 27, Issue 4, pp 280–282 | Cite as

Effect of titanium on the structure and properties of cast molybdenum high-speed steel

  • A. N. Popandopulo
  • N. A. Pakhomova
Tool Steels

Conclusions

  1. 1.

    On adding 0.4–1.3% Ti to cast molybdenum steel M6 the secondary hardness does not exceed HRC 60, and the red hardness is reduced to HRC 44-50.

     
  2. 2.

    Alloying of cast molybdenum high-speed steel with 2.4–3.5% titanium leads to an even more marked reduction in secondary hardness and red hardness.

     
  3. 3.

    A positive effect of titanium on the properties of cast molybdenum high-speed steel may be expected on alloying it with up to 0.4% Ti.

     

Keywords

Titanium Molybdenum Marked Reduction Molybdenum Steel Secondary Hardness 
These keywords were added by machine and not by the authors. This process is experimental and the keywords may be updated as the learning algorithm improves.

Preview

Unable to display preview. Download preview PDF.

Unable to display preview. Download preview PDF.

Literature cited

  1. 1.
    A. P. Gulyaev, Low-Alloy Tungsten and Molybdenum High-Speed Steels [in Russian], GNTI, Moscow-Leningrad (1941).Google Scholar
  2. 2.
    Yu. A. Geller, Tool Steels [in Russian], Metallurgiya, Moscow (1983).Google Scholar
  3. 3.
    G. L. Kuruklis, M. P. Braun, et al., Modification of High-Speed Steel [in Russian], Mashgiz, Kiev-Moscow (1956).Google Scholar
  4. 4.
    L. A. Poznyak et al., Tool Steels [in Russian], Metallurgiya, Moscow (1977).Google Scholar

Copyright information

© Plenum Publishing Corporation 1985

Authors and Affiliations

  • A. N. Popandopulo
  • N. A. Pakhomova

There are no affiliations available

Personalised recommendations