Advertisement

Metal Science and Heat Treatment

, Volume 16, Issue 7, pp 614–615 | Cite as

Boriding in pastes with furnace heating

  • M. I. Bayazitov
  • A. A. Aliev
Technical Information

Conclusions

  1. 1.

    The pastes recommended for boriding with use of accelerated heating cannot be used in furnace heating without protection of the steel against oxidation.

     
  2. 2.

    Boriding in paste occurs by way of the gaseous phase.

     
  3. 3.

    In boriding in vacuum it is necessary to create conditions preventing outflow of the boron-containing gas from the surface of the piece.

     
  4. 4.

    In order to use paste for boriding it is necessary to protect the metal against oxidation (with use of the binders tested) and prevent outflow of the boron-containing gas through the pores of the paste.

     

Keywords

Oxidation Furnace Gaseous Phase Furnace Heating Accelerate Heating 
These keywords were added by machine and not by the authors. This process is experimental and the keywords may be updated as the learning algorithm improves.

Literature cited

  1. 1.
    I. N. Kidin, Physical Basis of Electrotechnical Treatment of Metals and Alloys [in Russian], Metallurgiya, Moscow (1969), pp. 256–263.Google Scholar
  2. 2.
    A. N. Minkevich and N. G. Ulybin, "Chromizing and boriding of steel with heating by high-frequency current,", Metal. i Term. Obrabotka Metal., No. 4, 48–51 (1959).Google Scholar
  3. 3.
    A. A. Kats et al., in: Technology and Organization of Heat and Chemicothermal Treatment Processes [in Russian], NIIINFORMTYaZhMASh, No. 3, 13-67-3 (1967), p. 18.Google Scholar
  4. 4.
    G. V. Zemskov, N. G. Kaidash, and L. L. Praven'kaya, "Boriding of iron and steel in vacuum," Metal i Term. Obrabotka Metal., No. 3, 61–62 (1964).Google Scholar

Copyright information

© Plenum Publishing Corporation 1975

Authors and Affiliations

  • M. I. Bayazitov
  • A. A. Aliev

There are no affiliations available

Personalised recommendations