Conclusions
-
1.
Strengthening during cold working depends on the phase composition of the alloy. It is highest for the alloy with 15% Mo, with high plasticity in cold deformation.
-
2.
Cold working leads to greater reduction of uniform elongation than concentrated elongation.
-
3.
With increasing amounts of the alloying element the increase of strength resulting from MTT reaches a peak for the alloy with 15% Mo, which can be recommended for semifinished products and parts subjected to MTT.
Similar content being viewed by others
Literature cited
A. P. Gulyaev and A. S. Shigarev, Metal. i Term. Obrabotka Metal., No. 4 (1963).
S. G. Glazunov and A. I. Khorev, Metal. i Term. Obrabotka Metal., No. 8 (1964).
M. L. Bernshtein et al., Tsvetnye Metally, No. 12 (1964).
A. I. Khorev, Tsvetnye Metally, No. 4 (1965).
I. I. Novikov et al., in: Metal Science of Light Alloys [in Russian], Nauka, Moscow (1965).
M. Kh. Shorshorov et al., in: New Investigations of Titanium Alloys [in Russian], Nauka, Moscow (1965).
A. I. Khorev et al., Tsvetnye Metally, No. 9 (1966).
Ya. B. Fridman et al., A Study of Plastic Deformation by the Method of Printed Grids [in Russian], Oborongiz, Moscow (1962).
A. I. Khorev and L. V. Geras'kova, Metal. i Term. Obrabotka Metal., No. 5 (1965).
M. L. Bernshtein, Thermomechanical Treatment of Metals, Vol. 1 [in Russian], Metallurgiya, Moscow (1968).
Additional information
Deceased.
Translated from Metallovedenie i Termicheskaya Obrabotka Metallov, No. 9, pp. 43–46, September, 1971.
Rights and permissions
About this article
Cite this article
Khorev, A.I., Chinenov, A.M. & Martynova, M.M. Mechanicothermal treatment of Ti−Al−Mo alloys. Met Sci Heat Treat 13, 748–750 (1971). https://doi.org/10.1007/BF00650849
Issue Date:
DOI: https://doi.org/10.1007/BF00650849