Mechanics of Composite Materials

, Volume 26, Issue 1, pp 141–148 | Cite as

Simulation of nonisothermal curing processes and effect of design and technological factors on the integrity of components made of polymer composite materials

  • A. S. Zakhvatov
  • V. T. Tomashevskii
  • V. S. Yakovlev
Article

Keywords

Polymer Composite Material Cure Process Technological Factor Polymer Composite Material 

Preview

Unable to display preview. Download preview PDF.

Unable to display preview. Download preview PDF.

Literature cited

  1. 1.
    V. V. Bolotin, A. N. Vorontsov, and R. Kh. Murzakhanov, “Analysis of processing stresses in wound components of composite materials throughout the entire production process,” Mekh. Kompozit. Mater., No. 3, 500–508 (1980).Google Scholar
  2. 2.
    V. T. Tomashevskii, V. N. Shalygin, and V. S. Yakovlev, “Simulation of the conditions of formation of the processing defects in the structure of wound composite polymer materrials,” Mekh. Kompozit. Mater., No. 5, 895–900 (1980).Google Scholar
  3. 3.
    V. T. Tomashevskii and V. S. Yakovlev, “Technological problems of mechanics of composite materials,” Prikl. Mekh.,20, No. 11, 3–20 (1984).Google Scholar
  4. 4.
    V. V. Bolotin, A. N. Vorontsov and V. B. Antonov, “Theory of compression shaping components of composite materials,” Mekh. Kompozit. Mater., No. 6, 1034–1042 (1982).Google Scholar
  5. 5.
    V. G. Dedykhin, E. I. Isanov, and T. V. Stavrov, “Temperature conditions of pressing thick-walled components of glass-reinforced plastics,” Plast. Massy, No. 1, 39–41 (1969).Google Scholar
  6. 6.
    Yu. M. Tarnopol'skii and G. G. Portnov, “Examination of the process of compression shaping components of glass-reinforced plastics,” Plast. Massy, No. 11, 19–23 (1963).Google Scholar

Copyright information

© Plenum Publishing Corporation 1990

Authors and Affiliations

  • A. S. Zakhvatov
    • 1
  • V. T. Tomashevskii
    • 1
  • V. S. Yakovlev
    • 1
  1. 1.A. A. Grechko Naval Military AcademyLeningrad

Personalised recommendations