Summary
Melt-extruded and subsequently injection molded polysulfone (PSF) and poly(phenylene sulfide) (PPS) blends exhibit very good tensile properties, at least up to 30–50% by weight of PPS. The tensile strength at the lower PPS contents shows additive effect or slightly better and materials fail in ductile mode. Tensile fracture surfaces were investigated using scanning electron microscopy (SEM). The 20% PPS blend shows no apparent voids between phases with some pull-out or elongation of the dispersed phase. At 35% PPS, phase boundaries were not clear and very rough surface profiles were observed. Blends with high PPS content (>50%) usually fail in the brittle mode. The fracture morphology of systems failing with a brittle mode revealed an interfacial debonding phenomenon.
Similar content being viewed by others
References
Zeng, H. and Mai, K. Makromol. Chem.187, 1787(1986)
Cheung, M.-F., Golovoy, A., Plummer, H.K., and vanOene, H., Polymer,31, 2299(1990)
Cheung, M.-F., Golovoy, A., vanOene, H., Polymer31, 2307(1990)
Murray, J., Hull, D., Polymer,10, 451(1969)
Murray, J., Hull, D., J. Polym. Sci., Part A-2.8 583(1970)
Golovoy, A., Cheung, M.-F., and Zinbo, M. Polym. Commun.30, 322(1989)
Barlow, J.W., and Paul, D., Polymer. Eng. Sci.,24, 525(1984)
Paul, D., “Multicomponent Polymer Materials”, ACS advances in Chemistry Series 211, 3(1986)
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Cheung, M.F., Plummer, H.K. Tensile fracture morphology of polysulfone-poly(phenylene sulfide) blends. Polymer Bulletin 26, 349–356 (1991). https://doi.org/10.1007/BF00587980
Accepted:
Issue Date:
DOI: https://doi.org/10.1007/BF00587980