Abstract
A quantitative measure of the effect of processing variables on the shear strength of solid state diffusion bonds is often difficult to obtain because of the scatter in test data. This may be reduced by improving the bonding and testing techniques. Two jigs for bonding and testing small Al-alloy lap shear test pieces are described. These jigs enabled the precise measurement of shear stress-strain curves for lap joints and led to reproducible shear strength values. Results obtained for diffusion bonded lap joints between clad Al-Zn-Mg (7010) alloy are described.
Similar content being viewed by others
References
E. L. Ruff andW. L. Franklin,Amer. Soc. Mech. Eng. Nov (1981) 33.
J. R. Williamson, in Proceedings of the Conference of the Metals Society of the AIME, June 1982, edited by N. E. Paton and C. H. Hamilton (1982) p. 291.
R. Sawle,ibid. p. 307.
F. T. McQuilkin, C. H. Hamilton andJ. Waldman,Amer. Soc. Mech. Eng. Nov (1981) 19.
P. G. Partridge andA. J. Shakesheff, RAE Technical Report 82117, Dec (1982).
C. L. Clune,Welding J. Suppl. 45 (1966) 481.
I. M. Barta,Welding Res. Suppl. 43 (1964) 241.
D. Hauser, P. A. Kammer andJ. H. Dedrick,ibid. 46 (1967) 11.
M. M. Schwartz, “Metals Joining Manual” (McGraw-Hill, New York, 1979).
E. Lugscheider, H. Reimaun andO. Knotek,Welding Res. Suppl. 56 (1977) 189s.
J. F. Lancaster, “Metallurgy of Welding” (Allen and Unwin, London, 1980) p. 105.
A. J. Kinloch,J. Mater. Sci. 17 (1982) 617.
T. R. Guess, R. E. Allred andF. P. Gerstle,J. Testing Evaluation 5 (1977) 84.
R. Blickensderfer andJ. F. Burrus,ibid. 12 (1984) 3.
T. S. Baker andP. G. Partridge, RAE Technical Report 83015, Feb (1983).
BS 1134 Part I, British Standards Institute (1972).
O. Ohashi andT. Hashimoto,Trans. Nat. Res. Inst. Metals 21 (1979) 121.
“Source Book on Selection and Fabrication of Aluminium Alloys” (American Society for Metals, Metals Park, Ohio, 1978) p. 1.
E. W. Thrall,Adhesion 4 (1980) 1.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Harvey, J., Partridge, P.G. & Snooke, C.L. Diffusion bonding and testing of Al-alloy lap shear test pieces. J Mater Sci 20, 1009–1014 (1985). https://doi.org/10.1007/BF00585745
Received:
Accepted:
Issue Date:
DOI: https://doi.org/10.1007/BF00585745