Advertisement

Journal of Materials Science

, Volume 5, Issue 12, pp 1078–1086 | Cite as

Electrical and tensile properties of Cu-ThO2, Au-ThO2, Pt-ThO2 and Au-Al2O3, Pt-Al2O3 alloys

  • N. Fuschillo
  • M. L. Gimpl
Papers

Abstract

Dispersion-strengthened alloys of Pt, Au and Cu containing ThO2 and Al2O3 were prepared by precipitating the elements from a solution containing a suspension of the oxide phase. The precipitate deposited on the oxide particles of 0.05μm average diameter and produced dispersions of good homogeneity on compaction. Alloys containing less than 2 vol% oxide phase had sufficient ductility to permit fabrication of wire. Tensile strength and elongation, hardness, and electrical resistivity were measured as a function of temperature up to 1000°C. The dispersion-strengthening caused a relatively small increase in the resistivity of the alloys compared to the resistivity of the metals. The alloys are useful where high electrical or thermal conductivity combined with superior tensile strength, hardness and oxidation resistance at elevated temperatures, are desirable.

Keywords

Polymer Thermal Conductivity Al2O3 Tensile Strength Ductility 
These keywords were added by machine and not by the authors. This process is experimental and the keywords may be updated as the learning algorithm improves.

Preview

Unable to display preview. Download preview PDF.

Unable to display preview. Download preview PDF.

References

  1. 1.
    G. M. Ault andH. M. Burte, “Oxide Dispersion Strengthening” (Gordon and Breach, New York, 1968), p. 3.Google Scholar
  2. 2.
    G. S. Ansell, “Oxide Dispersion Strengthening” (Gordon and Breach, New York 1968), p. 61;G. S. Ansell in “Physical Metallurgy” (R. W. Cahn ed. North-Holland Publ. Co., Amsterdam, 2nd edition, 1970) ch. 18.Google Scholar
  3. 3.
    G. S. Ansell andF. V. Lenel,Acta Metallurgica 8 (1960) 612.Google Scholar
  4. 4.
    K. M. Zwilsky andN. S. Grant,J. Metals 9 (1957) 1197.Google Scholar
  5. 5.
    A. Kelly andR. B. Nicholson,Progr. Mat. Sci. 10 (1963) 338.Google Scholar
  6. 6.
    R. B. Dingle,Proc. Roy. Soc. A201 (1950) 545.Google Scholar
  7. 7.
    F. J. Blatt, “Physics of Electronic Conduction in Solids” (McGraw-Hill, New York, 1968), p. 235.Google Scholar

Copyright information

© Chapman and Hall Ltd. 1970

Authors and Affiliations

  • N. Fuschillo
    • 1
    • 2
  • M. L. Gimpl
    • 1
    • 2
  1. 1.Department of Electrical EngineeringRutgers UniversityNew BrunswickUSA
  2. 2.Department of Electrical EngineeringThe State University of New JerseyNew BrunswickUSA

Personalised recommendations