Abstract
When a polystyrene-polybutadiene-polystyrene (SBS) block copolymer undergoes microphase separation, the resulting morphology is dependent on the chemical nature, component ratio, and molecular weights of the constituent molecules. Transmission electron microscopy studies have revealed that the morphology of block copolymers cast in various solvents is determined also by the selectivity of the preparatory solvent. This work compares the morphologies produced by thin-film casting of a toluene-SBS solution on water, with subsequent solvent evaporation, and those produced in bulk, without the use of any solvents. To obtain ultrathin sections of the latter, a new technique using cryo-ultramicrotomy is introduced. The technique utilizes sub-zero temperatures to harden the samples and allow reproducible sectioning; the optimal temperature is accurately predicted as the glass transition temperature for a hypothetical homogeneous blend of the same composition. Difficulties with the trough liquid necessary in wet sectioning are overcome by coating the surface of the glass knives with Teflon. Morphological differences arising from the two preparative methods are identified, and image-enhancing techniques are used to emphasize the interphase region described by various theories.
Similar content being viewed by others
References
G. E. Molau, in “Block Copolymers” edited by S. L. Aggarwal (Plenum Press, New York, 1970) p. 79.
D. J. Meier, in “Block and Graft Copolymers” edited by J. J. Burke and V. Weiss (Syracuse University Press, New York, 1973) p. 105.
D. J. Meier, in Proceedings of the Polymer Colloquium, Kyoto, Japan, September, 1977.
D. F. Leary andM. C. Williams,J. Polym. Sci. Polym. Phys. Ed. 11 (1973) 345.
Idem, ibid. 12 (1974) 265.
E. Helfand, in “Recent Avances in Polymer Blends, Grafts and Blocks” edited by L. H. Sperling (Plenum Press, New York, 1974) p. 141.
E. Helfand, in “Developments in Block Copolymers, Vol. I” edited by I. Goodman (Applied Science, London, 1982).
C. P. Henderson andM. C. Williams,J. Polym. Sci., Polym. Phys. Ed. 23 (1985) 1001.
J. Diamant, PhD thesis, University of California, Berkeley, 1982.
T. Hashimoto, A. Todo, H. Itoi andH. Kawai,Macromolecules 10 (1977) 377.
Y. Matshushita, K. Yamada, T. Hattori, T. Fujimoto, Y. Sawada, M. Nagasawa, andC. Matsui,ibid. 16 (1983) 10.
S. L. Aggarwal,Polymer 17 (1976) 938.
F. Annighofer andW. Gronski,Makromol. Chem. 185 (1984) 2213.
M. A. Hayat, “Principles and Techniques of Electron Microscopy: Biological Applications” (University Park Press, Baltimore, 1981) p. 211.
E. H. Andrews, M. W. Bennett andA. Markham,J. Polym. Sci. A2 5 (1967) 1235.
A. Persson, 7th International Congress on Electron Microscopy,1 (1970) p. 421.
N. Reid, in “Practical Methods in Electron Microscopy” edited by A. M. Glauert (North-Holland, Amsterdam, 1975) p. 332.
K. R. Porter, in “Modern Developments in Electron Microscopy” edited by B. M. Siegel (Academic Press, New York, 1964) p. 136.
S. J. Whicher andJ. L. Brash,J. Appl. Polym. Sci. 30 (1985) 2297.
J. A. Odell, J. Dlugosz andA. Keller,J. Polym. Sci. Polym. Phys. Ed. 14 (1976) 861.
G. A. Meek, “Practical Electron Microscopy for Biologists” (Wiley, Chichester, 1976) p. 431.
E. Hirata, T. Ijitsu, T. Soen, T. Hashimoto andH. Kawai,Polymer 16 (1975) 249.
J. F. Rabek, “Experimental Methods in Polymer Chemistry” (Wiley, Chichester, 1980) p. 473.
J. A. Rusnock andD. Hansen,J. Polym. Sci. A 3 (1965) 647.
F. Rodriguez, “Principles of Polymer Systems” (Hemisphere Publishing, Washington, 1982) p. 39.
H. Vascek, Dupont-Sorvall Group of the Dupont Biotechnology Systems Division, personal communication (1985).
S. Wischnitzer, “Introduction to Electron Microscopy” (Pergamon Press, New York, 1981) p. 154.
K. Kato,Polym. Lett. 4 (1966) 35.
C. K. Riew andR. W. Smith,J. Polym. Sci. A1 9 (1971) 2739.
T. Inoue, M. Mortitani, T. Hashimoto andH. Kawai,Macromolecules 4 (1971) 500.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Spontak, R.J., Williams, M.C. & Schooley, C.N. Morphology of bulk SBS block copolymers prepared by wet cryo-ultramicrotomy. J Mater Sci 21, 3173–3178 (1986). https://doi.org/10.1007/BF00553354
Received:
Accepted:
Issue Date:
DOI: https://doi.org/10.1007/BF00553354