Conclusions
The suggested method for determining wear in spinning or twisting rings makes it possible to establish with adequate accuracy the magnitude of wear in any previously selected point of the ring working surface, and also the change in profile of the frictional surface of the ring in one or several sections, marked off by basis marks.
The use of the examined method is advisable in tests of new rings under various conditions, for technological control of the geometric parameters of rings during fabrication, and for determining the profile form of the working surface of rings after operations of repair restoration.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
Literature cited
R. M. Dzhurabekov, Candidate's Dissertation, KTI, Kostroma (1974).
G. I. Kurganov, Candidate's Dissertation, LITLP, Leningrad (1979).
Inventor's Certificate 151087 (1962) (USSR).
K. P. Chudakov, I. K. Dombrovskaya, and Yu. V. Boldov, Vestnik Mashinostroeniya, No. 1, 27 (1962).
Additional information
Translated from Khimickeskie Volokna, No. 2, pp. 39–40, March–April, 1987.
Rights and permissions
About this article
Cite this article
Gerdov, V.E. Method of determining wear of the working profile of spinning and twisting rings. Fibre Chem 19, 132–134 (1987). https://doi.org/10.1007/BF00552613
Received:
Issue Date:
DOI: https://doi.org/10.1007/BF00552613