References
G. M. Goodwin, Metallurgia Italiana. 60 (1968) 767.
S. P. Keeler, Sheet Metal Industries 42 (1965) 683.
Z. Marciniak, Inst. J. Mech. Sci. 9 (1967) 609.
A. K. Ghosh and W. A. Backofen, Met. Trans. 4 (1973) 1113.
P. Delayen and P. Parniere, Mem. Sci. Rev. Met. 71 (1974) 67.
P. Parniere, ibid 74 (1977) 129.
F. Ronde-Oustau and B. Baudelet, Acta. Met. 25 (1977) 1523.
G. Henry, L. Roesh and J. Plateau, “Deformation plastique des métaux et alliages” (Masson Edition, France, 1968) p. 191.
M. Arzin and W. A. Backofen, Met. Trans. 1 (1970) 2857.
P. D. Holmes, Ph.D. Thesis, University of Sheffield (1973).
J. D. Atkinson, Ph.D. Thesis, University of Cambridge (1973).
M. Entringer, G. De Kainlis, private communication (1977).
R. T. Ratcliffe, Brit. J. Appl. Phys. 16 (1965) 1193.
J. Lemaitre, J. P. Cordebois, J. Dufailly, private communication.
D. W. Wilson, “Effect of Second Phase Particles on Mechanical Properties of Steel” (Iron and Steel Institute, 1971) p. 28.
H. C. Rogers, “Metal Forming — Interaction between Theory and Practice” (Plenum Press, New York and London, 1971) p. 453.
J. R. Rice and D. M. Tracey, J. Mech. Phys. Solids. 17 (1969) 201.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Jalinier, J.M., Baudelet, B. & Argemi, R. Forming limit diagrams and damage in mild steel. J Mater Sci 13, 1142–1145 (1978). https://doi.org/10.1007/BF00544716
Received:
Accepted:
Issue Date:
DOI: https://doi.org/10.1007/BF00544716