Übersicht
Das Verhalten elastischer bzw. plastischer Wellen an den Knoten ebener Stabwerke wird unter-sucht. Die Aufteilung der Wellen wird durch Verteilungskoeffizienten beschrieben, die nicht nur von der Geometrie der Verzweigung, sondern auch vom Wellentyp und vom Sparmungszustand in den Stäben vor der einfallenden Welle abhängen. Zwei Anwendungsbeispiele sind gegeben. Sie zeigen, daß die Näherungsannahme starr-plastischen Materialverhaltens sowohl zu quantitativ als auch zu qualitativ falschen Ergebnissen führen kann.
Summary
The behaviour of elastic or plastic waves at the joints of trusses is investigated. The distribution of the waves is described with the aid of distribution factors which are not only dependent on the geometry of the joint but also on the type of the waves and on the state of stress in the bars in front of the incoming wave. Two illustrative examples are given. They show that an analysis based on the assumption of a rigidplastic material may lead to results which are quantitatively or even qualitatively erroneous.
Literatur
Boley, B. A.; Chao, Ch. Gh.: Impact on Pin-Jointed Trusses. Trans. Am. Soc. Civ. Eng. (1957) S. 39
Hauger, W.; Kullmann, G.; Lippmann, H.; Weber, H.: Plastische Wellen in Stabwerken. Ing.-Arch. 45 (1976) S. 291.
Lippmann, H.: Plastokinetics of Metal Forming. (In: Topics of Applied Continuum Mechanics. Hrsg.: Zeman J. L. und Ziegler F.). Wien 1974
Author information
Authors and Affiliations
Additional information
Der Deutschen Forschungsgemeinschaft (DFG) sei für ihre finanzielle Förderung gedankt (AZ: Li 115/9, 12 und 15).
Rights and permissions
About this article
Cite this article
Hauger, W., Lippmann, H. Über die Elastisch-plastische Aufteilung von Wellen an den Knoten ebener Stab werke. Ing. arch 47, 117–128 (1978). https://doi.org/10.1007/BF00536448
Received:
Issue Date:
DOI: https://doi.org/10.1007/BF00536448