Abstract
Cost-effective hotspot identification is an important issue in hazardous waste site characterization and evaluation. Composite sampling techniques are known to be cost effective when the cost of measurement is substantially higher than the cost of sampling. Although compositing incurs no loss of information on the means, information on individual sample values is lost due to compositing. In particular, if the interest is in identifying the largest individual sample value, the composite sampling techniques are not able to do so. Under certain assumptions, it may be possible to satisfactorily predict individual sample values using the composite sample data, but it is not generally possible to identify the largest individual sample value. In this paper, we propose two methods of identifying the largest individual sample value with some additional measurement effort. Both methods are modifications of the simple sweep-out method proposed earlier. Since analytical results do not seem to be feasible, performance of the proposed methods is assessed via simulation. The simulation results show that both the proposed methods, namely the locally sequential sweep-out and the globally sequential sweep-out, are better than the simple sweep-out method.
Similar content being viewed by others
References
Aragon, M.E.D., Patil, G.P. and Taillie, C. (1994) Extreme individual observations from one-dimensional composite sampling designs. Technical Report Number 94-0101, Center for Statistical Ecology and Environmental Statistics, Pennsylvania State University, University Park, PA 16802.
Casey, D., Nemetz, P.N. and Uyeno, D. (1985) Efficient search procedures for extreme pollution values. Environmental Monitoring and Assessment, 5, 165–76.
Gore, S.D. and Patil, G.P. (1994) Identifying extremely large values with composite sample data. Environmental and Ecological Statistics, 1, 227–45. With discussion by John Warren, Henry Kahn and Katherine Campbell.
Patil, G.P., Boswell, M.T. and Ratnaparkhi, M.V. (1984) Dictionary and Classified Bibliography of Statistical Distributions in Scientific Work, Vol 2: Continuous Univariate Models. International Co-operative Publishing House, Fairland, MD.
Patil, G.P., Gore, S.D. and Taillie, C. (1994) Design and analysis with composite samples: a novel method to accomplish observational economy in environmental studies. A draft monograph. Technical Report Number 94-0410, Center for Statistical Ecology and Environmental Statistics, Pennsylvania State University, University Park, PA 16802.
Author information
Authors and Affiliations
Additional information
Prepared with partial support from the Statistical Analysis and Computing Branch, Environmental Statistics and Information Division, Office of Policy, Planning, and Evaluation, United States Environmental Protection Agency, Washington, DC under a Cooperative Agreement Number CR-821531. The contents have not been subjected to Agency review and therefore do not necessarily reflect the views of the Agency and no official endorsement should be inferred.
Rights and permissions
About this article
Cite this article
Gore, S.D., Patil, G.P. & Taillie, C. Identification of the largest individual sample value using composite sample data and certain modifications of the sweep-out method. Environ Ecol Stat 3, 219–234 (1996). https://doi.org/10.1007/BF00453011
Received:
Revised:
Issue Date:
DOI: https://doi.org/10.1007/BF00453011