Abstract
An analytical solution is presented for the calculation of the flow field in a concentric cylinder viscometer of non-ideal Bingham-fluids, described by the Worrall-Tuliani rheological model. The obtained shear rate distribution is a function of the a priori unknown rheological parameters. It is shown that by applying an iterative procedure experimental data can be processed in order to obtain the proper shear rate correction and the four rheological parameters of the Worrall-Tuliani model as well as the yield surface radius. A comparison with Krieger's correction method is made. Rheometrical data for dense cohesive sediment suspensions have been reviewed in the light of this new method. For these suspensions velocity profiles over the gap are computed and the shear layer thicknesses were found to be comparable to visual observations. It can be concluded that at low rotation speeds the actually sheared layer is too narrow to fullfill the gap width requirement for granular suspensions and slip appears to be unavoidable, even when the material is sheared within itself. The only way to obtain meaningfull measurements in a concentric cylinder viscometer at low shear rates seems to be by increasing the radii of the viscometer. Some dimensioning criteria are presented.
Similar content being viewed by others
Abbreviations
- A, B :
-
Integration constants
- C :
-
Dimensionless rotation speed = µ∞Φ/τy
- c :
-
= 2µ∞
- d :
-
= τ0 2−2cτy
- f(τ) :
-
= (τ−τ0)2+2c(τ−τy)
- r :
-
Radius
- r b :
-
Bob radius
- r c :
-
Cup radius
- r y :
-
Yield radius
- r 0 :
-
Stationary surface radius
- r Φ :
-
Rotating Stationary radius
- Y 0 :
-
Shear rate parameter = Δτ/Δµ
- \(\dot \gamma \) :
-
Shear rate
- ɛ:
-
= (r y /r b )2− 1
- µ∞ :
-
Bingham viscosity
- µ0 :
-
Initial differential viscosity
- Δµ:
-
µ0-µ∞
- Φ:
-
Rotation speed
- ω:
-
Angular velocity
- Ω:
-
Shear stress
- τ b :
-
Bob shear stress
- τ B :
-
Bingham stress
- τ y :
-
(True) yield stress
- τ0 :
-
Stress parameter = τ B +µ∞ Y 0
- Δτ:
-
τ B -τ y
References
Beyer WH (ed) (1978) CRC standard mathematical tables (25th ed). CRC Press, West Palm Beach
Bingham EC (1922) Fluidity and plasticity. McGraw-Hill, New York
Cross MM (1965) Rheology of non-Newtonian fluids: a new flow equation for pseudo-plastic systems. J Coll Sci 20:417–437
Darby R (1985) Couette viscometer data reduction for materials with a yield stress. J Rheol 29:369–378
Hunter RJ (1989) Foundations of colloid science, Vol II. Oxford Science Publications, Clarendon Press, Oxford, p 1042
Jones TER, Golden K (1990) Rheological behaviour of River Parrett mud. Report for HR Wallingford, Polytechnic South-West, Plymouth
Krieger IM, Elrod H (1953) Direct determination of the flow curves of non-Newtonian fluids. II. Shearing rate in the concentric cylinder viscometer. J Appl Phys 24:134–136
Krieger IM, Maron SH (1954) Direct determination of the flow curves of non-Newtonian fluids. III. Standardized treatment of viscometric data. J Appl Phys 25:72–75
Krieger IM (1968) Shear rate in the Couette viscometer. Trans Soc Rheol 12:5–11
Moore F (1959) The theology of ceramic slips and bodies. Trans Brit Ceramic Soc 58:470–492
Nguyen QD, Boger DV (1987) Characterisation of yield stress fluids using the concentric cylinder viscometer. Rheol Acta 26:508–515
Nguyen QD, Boger DV (1992) Measuring the flow properties of yield stress fluids. Ann Rev Fluid Mech 24:47–88
O'Brien JS (1986) Physical properties, rheology and modeling of mud flows. PhD Thesis, Civil Eng Dept, Colorado State University, Fort Collins
Reiner M (1929) The theory of plastic flow in the rotation viscometer. J Rheol 1:5–10
Pazwash H, Robertson JM (1971) Fluid-dynamic considerations of bottom materials. ASCE J Hydr Div 97:1317
Toorman EA, Berlamont JE (1992) Numerical simulation of high concentration suspension flow with free surface. In: Theoretical and applied rheology. Proc XIth Congr Rheol, Elsevier, pp 292–294
Williamson RV (1929) Ind Eng Chem 21:108 ff
Worrall WE, Tuliani S (1964) Viscosity changes during the ageing of clay-water suspensions. Trans Brit Ceramic Soc 63:167–185
Yang TMT, Krieger IM (1978) Comparison of methods for calculating shear rates in coaxial viscometers. J Rheol 22:413–421
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Toorman, E.A. An analytical solution for the velocity and shear rate distribution of non-ideal Bingham fluids in concentric cylinder viscometers. Rheola Acta 33, 193–202 (1994). https://doi.org/10.1007/BF00437304
Received:
Revised:
Issue Date:
DOI: https://doi.org/10.1007/BF00437304