Abstract
The sintering and crystallization behaviour was studied of a glass powder in the MgO-Al2O3-SiO2-ZrO2 system in which the main crystal phases to form are clino-enstatite (MgSiO3) and cubic zirconia (c-ZrO2). During isothermal, atmospheric sintering of the glass powder, a fine dispersion of c-ZrO2 particles, 50–100 nm diameter, was observed to form, but this did not appear to inhibit the sintering process. Nucleation of the main crystal phase, clino-enstatite, occurred both within the original glass powder particles and at the former particle surfaces, but the rate of crystallization was greater at the former particle surfaces. The c-ZrO2 precipitates are thought to act as nucleation sites for the crystallization of the clino-enstatite. Relative densities of up to 98% were attainable during sintering, and were reached at a stage where a significant degree of crystal phase development had already taken place, proving that completion of sintering prior to the commencement of crystallization is not always a pre-requisite for the attainment of high final densities. In the material studied, the large volume contraction (∼ 11%) on crystallization and the possible release of dissolved gases led to a decrease in relative density as crystallization proceeded. The relative density after complete crystallization was found to be 94%±1%, irrespective of the temperature and duration of the initial sintering stage of heat-treatment, and it appeared that most of the residual porosity was a result of the volume contraction on crystallization rather than poor densification during sintering.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
H. T. Sawhill, R. H. Jenson and K. R. Mikeska, in “Proceedings of the Symposium on Materials and Processes for Microelectronic Systems”, Anaheim, CA, 31 October–3 November 1989, Ceramic Transactions Vol. 15 (American Ceramic Society, 1990) pp. 611–28.
G. Partridge, C. A. Elyard and A. K. Datta, “Fabrication of glass-ceramics by tape casting”, in British Ceramic Proceedings no. 45, “Fabrication Technology” (The Institute of Ceramics, Stoke-on-Trent, UK, 1990) pp. 123–9.
E. M. Rabinovich, “Cordierite glass-ceramics produced by sintering”, Advances in Ceramics Vol. 4, “Nucleation and Crystallization in Glasses”, edited by J. H. Simmons, D. R. Uhlmann and G. H. Beall (American Ceramic Society, Columbus, Ohio, 1982) pp. 327–33.
M. N. Rahaman, in “Proceedings of the International Symposium on Advances in Processing of Ceramic and Metal Matrix Composites”, Halifax Nova Scotia, Canada, 20–24 August 1989, pp. 71–79.
V. S. R. Murthy and M. H. Lewis, Brit. Ceramic Trans. J. 89(5) (1990) 173.
H. S. Kim, R. D. Rawlings and P. S. Rogers, J. Mater. Sci. 24 (1989) 1025.
A. R. Hyde and G. Partridge, “Fabrication of particulate, platelet, whisker and continuous fibre reinforced glass, glass-ceramic and ceramic materials”, in British Ceramic Proceedings no. 45, “Fabrication Technology” (The Institute of Ceramics, Stoke-on-Trent, UK, 1990) pp. 221–27.
T. J. Clark and J. S. Reed, J. Amer. Ceram. Soc. 69 (1986) 837.
P. C. Panda and R. Raj, ibid. 72 (1989) 1564.
B. H. Mussler and M. W. Shafer, Amer. Ceram. Soc. Bull. 64 (1985) 1459.
P. W. McMillan, “Glass-ceramics” (Academic Press. London, 1979) p. 32.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Budd, M.I. Sintering and crystallization of a glass powder in the MgO-Al2O3-SiO2-ZrO2 system. Journal of Materials Science 28, 1007–1014 (1993). https://doi.org/10.1007/BF00400887
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/BF00400887