Abstract
Absorbing or emitting elements generate noise waves. The main purpose of this paper is to determine from first principles the spectral density of noise waves relating to nonlinear elements. This was done by considering the combination of linear elements (whose noise properties are well understood) and lossless circuits that are nonlinear because of the Kerr effect. Lossless nonlinear circuits transform noise waves but do not generate noise. A semiclassical theory shows that noise waves remain at the shot noise level (for full population inversion) if the optical gain is considered a function of photon rate (rather than optical intensity). This result, in exact agreement with an independent theory of spectral-hole burning, is conjectured to be general. Intensity fluctuations of a Kerr oscillator are squeezed below the shot-noise level for large Kerr constants.
Similar content being viewed by others
References
G. J. Milburn, M. D. Levenson, R. M. Shelby, S. H. Perlmutter, R. G. Devoe and D. F. Walls, J. Opt. Soc. Am. B 4 (1987) 1476.
J. Arnaud, Phys. Rev. A (in press).
J. Arnaud, Phys. Rev. A 45 (1992) 1775.
A. Siegmann, Lasers (University Science Books, Mill Valley, CA, 1986).
Y. Yamamoto (ed.), Coherence, Amplification, and Quantum Effects in Semiconductor Lasers (Wiley, New York, 1991).
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Arnaud, J. Intensity noise of Kerr oscillators. Opt Quant Electron 25, 509–515 (1993). https://doi.org/10.1007/BF00308306
Received:
Revised:
Accepted:
Issue Date:
DOI: https://doi.org/10.1007/BF00308306