Advertisement

Improvement of PMa-SynRM Output Characteristics by Optimizing the Rib Structure

  • Jae-Kwang Lee
  • Dong-Hoon Jung
  • Sooyoung Cho
  • Ki-Doek Lee
  • Ju Lee
  • Ye Jun OhEmail author
Original Article
  • 5 Downloads

Abstract

In this paper, we have studied the optimization of the rib thickness in the design of a Permanent Magnet assisted Synchronous Reluctance Motor (PMa-SynRM). In the case of PMa;-SynRM, mechanical stress is concentrated on the rib structure supporting the segment at high rotation speeds, and the stiffness analysis results in the largest mechanical stress on the rib of the q-axis. On the other hand, it was confirmed that relatively low mechanical stresses were distributed in the case of the d-axis rib. Therefore, it is confirmed that the thickness of the whole rib should be equal to the thickness that can support the maximum stress. In addition, we find that it increases the magnetic flux leakage and is an inappropriate design method for reducing the output power. To prevent this phenomenon, concentrations of mechanical stress on each of the ribs were investigated, and a method was developed for designing the ribs with the optimized rib thickness. In addition, the thickness of the ribs that satisfies both the electromagnetic output and the mechanical safety factor was derived using the response surface method. Finally, we confirmed the improvement of the output using FEM analysis.

Keywords

PMa-SynRM Rib structure Efficiency Response surface method Minimum energy performance standards (MEPS) 

Notes

Acknowledgements

This work was supported by the Human Resources Program in Energy Technology of the Korea Institute of Energy Technology Evaluation and Planning (KETEP), granted financial resource from the Ministry of Trade, Industry & Energy, Republic of Korea. (No. 20174030201750). This work was supported by the Korea Institute of Energy Technology Evaluation and Planning (KETEP) and the Ministry of Trade, Industry & Energy (MOTIE) of the Republic of Korea (No. 20162010104100).

References

  1. 1.
    Kim K-C, Ahn J-S, Won SH, Hong J-P, Lee J (2007) A study on the optimal design of SynRM for the high torque and power factor. IEEE Trans Magn 43(6):2543–2546CrossRefGoogle Scholar
  2. 2.
    Lee J-K, Jung D-H, Lim JS, Lee K-D, Lee J (2018) A study on the synchronous reluctance motor design for high torque by using RSM. IEEE Trans Magn 54(3):8103005Google Scholar
  3. 3.
    Kim W-H, Kim K-S, Kim S-J, Kim D-W, Go S-C, Chun Y-D, Lee J (2009) Optimal PM design of PMA-SynRM for wide constant-power operation and torque ripple reduction. IEEE Trans Magn 45(10):4660–4663CrossRefGoogle Scholar
  4. 4.
    Lee K-D, Lee H-W, Lee J, Kim W-H (2015) Analysis of motor performance according to the inductance design of IPMSM. IEEE Trans Magn 51(3):8201204CrossRefGoogle Scholar

Copyright information

© The Korean Institute of Electrical Engineers 2019

Authors and Affiliations

  • Jae-Kwang Lee
    • 1
  • Dong-Hoon Jung
    • 1
  • Sooyoung Cho
    • 1
  • Ki-Doek Lee
    • 2
  • Ju Lee
    • 1
  • Ye Jun Oh
    • 1
    Email author
  1. 1.Department of Electrical EngineeringHanyang UniveritySeoulSouth Korea
  2. 2.Intelligent Mechatronics Research CenterKorea Electronics Technology InstituteBucheonSouth Korea

Personalised recommendations