Advertisement

Electrostatic Discharge Characteristics of Cable Discharge Event

  • Yu Zhang
  • Yafei YuanEmail author
  • Xiaoqing Li
  • Ming Yang
  • Na Feng
  • Ziwei Lu
  • Jihao He
  • Qizheng Ji
Original Article

Abstract

The characteristics of cable electrostatic discharge event are investigated, which has been proved to be a hazard leading to ESD damage. The electrostatic voltage under operations on cable is measured and the effects of the discharge parameters including electrostatic voltage, cable length, cable type and the distance to the ground on cable discharge event (CDE) are studied experimentally. The CDE current waveform appears as a sequence of oscillating rectangular pulses with fast rising time, short pulse width but high amplitude. The current amplitude linearly increases with the electrostatic voltage, while the pulse width is mainly determined by the cable length. The distance to the ground and the cable type has little influence once the distance is relatively large. The discharge by cable with multiple cores is also investigated. Theoretical discussion is made to explain the phenomenon and its mechanism.

Keywords

Cable discharge event Electrostatic discharge Current waveform Pulse width Plateau amplitude 

Notes

Acknowledgements

This work was partly supported by the Elitist Foundation of China Academy of Space Technology.

References

  1. 1.
    Gan Y, Xu X, Maghlakelidze G, Yang S, Huang W, Seol B, Pommerenke D (2016) System-level modeling methodology of ESD cable discharge to Ethernet transceiver through magnetics. IEEE Trans Electromagn Compat 58(5):1407–1416CrossRefGoogle Scholar
  2. 2.
    Brennan CJ, Chatty K, Sloan J, Dunn P, Muhammad M, Gauthier R (2007) Design automation to suppress cable discharge event (CDE) induced latchup in 90 nm CMOS ASICs. Microelectron Reliab 47(7):1069–1073CrossRefGoogle Scholar
  3. 3.
    Ke MD, Lai TH (2008) Investigation on robustness of CMOS devices against cable discharge event (CDE) under different layout parameters in a deep-submicrometer CMOS technology. IEEE Trans Electromagn Compat 50(4):810–821CrossRefGoogle Scholar
  4. 4.
    Lai TX, Ker MD (2006) Method to evaluate cable discharge event (CDE) reliability of integrated circuits in CMOS technology. In: Proceedings of the 7th international symposium on quality electronic design, pp 597–602Google Scholar
  5. 5.
    Lin Y, Park J, Isachar O, Chaikin S, Chundru R, Duvvury C, Matum S, Diep T (2008) The challenges of on-chip protection for system level cable discharge events (CDE). In: 30th electrical overstress/electrostatic discharge symposium, pp 125–131Google Scholar
  6. 6.
    Iben ET (2008) A study of cable discharge events and other short time pulses of cabled MR sensors. In: 30th electrical overstress/electrostatic discharge symposium, pp 262–271Google Scholar
  7. 7.
    Iben ET (2010) ESD events of cabled GMR sensors. In: 32nd electrical overstress/electrostatic discharge symposium, pp 1–6Google Scholar
  8. 8.
    Stadler W, Brodbeck T, Gartner R, Gossner H (2006) Cable discharges into communication interfaces. In: 28th electrical overstress/electrostatic discharge symposium, pp 144–151Google Scholar
  9. 9.
    Lai TX, Ker MD (2005) Methodology to evaluate the robustness of integrated circuits under cable discharge event. IEEE Conf Electron Devices Solid-State Circuits 2005:499–502Google Scholar
  10. 10.
    Han Y, Li W, Pommerene D, Dai L, Xu S (2015) Charged cable discharge events model and performance measurement. Chin J Radio Sci 30(6):1064–1068Google Scholar
  11. 11.
    Arndt B, zur Nieden F, Pohmerer R, Edenhofer J, Frei S (2009) Comparing cable discharge events to IEC 61000-4-2 or ISO 10605 discharges. In: 20th international Zurich symposium on electromagnetic compatibility, pp 157–160Google Scholar
  12. 12.
    Poon SS, Maloney TJ (2007) Shielded cable discharge induces current on interior signal lines. In: 29th electrical overstress/electrostatic discharge symposium, p 5B-2Google Scholar
  13. 13.
    Stadler W, Brodbeck T, Niemesheim J, Gaertner R, Muhonen K (2009) Characterization and simulation of real-world cable discharge events. In: 31st electrical overstress/electrostatic discharge symposium, pp 1–8Google Scholar
  14. 14.
    Lu Z, Ji Q, Song B, Yuan Y (2016) Design and verification of equivalent circuit for cable electrostatic discharge. J Appl Math Phys 4(2):195–201CrossRefGoogle Scholar
  15. 15.
    Stadler W, Niemesheim J, Stadler A, Koch S, Gossner H (2017) Risk assessment of cable discharge events. In: 39th electrical overstress/electrostatic discharge symposium, pp 1–9Google Scholar

Copyright information

© The Korean Institute of Electrical Engineers 2019

Authors and Affiliations

  • Yu Zhang
    • 1
  • Yafei Yuan
    • 1
    Email author
  • Xiaoqing Li
    • 1
  • Ming Yang
    • 1
  • Na Feng
    • 1
  • Ziwei Lu
    • 1
  • Jihao He
    • 1
  • Qizheng Ji
    • 1
  1. 1.Beijing Orient Institute of Measurement and TestBeijingChina

Personalised recommendations