Advertisement

Usage of fired wall tile wastes into fireclay sanitaryware products

  • Baran Tarhan
Research
  • 1 Downloads

Abstract

In the last decade, using the waste products generated in ceramic manufacturing has been one of the important issues. Reusing the waste products is not only an environmental responsibility but also a cost reduction issue. In this study, the possibility of using fired wall tile wastes as a raw material for sanitaryware fire clay compositions was investigated. Four sanitaryware fire clay compositions were prepared by adding fired wall tile waste (FWW) into the standard fireclay composition under industrial conditions at Canakkale Kalebodur Seramik San. A. S. The results showed that addition of FWW increased the strength and decreased the water absorption and thermal expansion coefficient of the fireclay products. The thermal expansion coefficient of the products can be controlled with the addition of FWW. High-temperature deformation decreased with the addition of FWW into the fireclay composition. It can be concluded that FWW can be used in the fireclay production compositions as a raw material.

Keywords

Ceramic sanitaryware Waste management Fire clay Wall tile High-temperature deformation 

References

  1. 1.
    Porte, F., Brydson, R., Rand, B., Riley, F.L.: Creep viscosity of vitreous China. J Am Ceram Soc. (2004).  https://doi.org/10.1111/j.1551-2916.2004.00923.x
  2. 2.
    D. Fortuna. Sanitaryware, first ed., Litografica Faenza S.r.l. Faenza, (2000)Google Scholar
  3. 3.
    Ceramic Technology Sanitaryware. first ed., Sacmi Imola, Imola, (2010).Google Scholar
  4. 4.
    Sacmi, Applied Ceramic Technology, first ed., Vol. 1 Sacmi Imola, Imola, (2006).Google Scholar
  5. 5.
    Baraldi, L.: World Production and Consumption of Ceramic Tiles. Tile International. 3, 48–54 (2016)Google Scholar
  6. 6.
    Mecs-Acimac research department, World Sanitaryware Production and Exports Tile International. (1) 68–75 (2016).Google Scholar
  7. 7.
    Penteado, C.S.G., Viviani De Carvalho, E., Lintz, R.C.C.: Reusing ceramic tile polishing waste in paving block manufacturing. J Clean Prod. 112, (2016).  https://doi.org/10.1016/j.jclepro.2015.06.142.
  8. 8.
    Tarhan, B., Tarhan, M., Aydin, T.: Reusing sanitaryware waste products in glazed porcelain tile production. Ceram Int. 43, (2017).  https://doi.org/10.1016/j.ceramint.2016.11.123
  9. 9.
    Tarhan, M., Tarhan, B., Aydin, T.: The effects of fine fire clay sanitaryware wastes on ceramic wall tiles. Ceram Int. 42, (2016).  https://doi.org/10.1016/j.ceramint.2016.07.222
  10. 10.
    İssi, A., Derin Coşkun, N., Tiryaki, V., Uz, V.: Casting and sintering of a sanitaryware body containing fine fire clay (FFC). J Aust Ceram Soc. 53, (2017).  https://doi.org/10.1007/s41779-016-0020-8
  11. 11.
    Stockley, D.: Fine fireclay – an overview of raw materials and body. Ceramic Forum International. 85(3), 19–22 (2008)Google Scholar
  12. 12.
    Kunduraci, N., Aydin, T.: The production of ultra-thin FFC sink by increasing resistance of FFC ceramic sanitaryware of semi-finished and finished cooked. Int J Eng Res Dev. 7(2), 30–33 (2015)Google Scholar
  13. 13.
    Escardino, A., García-Ten, J., Feliu, C., Moreno, A.: Calcium carbonate thermal decomposition in white-body wall tile during firing. I. Kinetic study. J Eur Ceram Soc. 30, (2010).  https://doi.org/10.1016/j.jeurceramsoc.2010.04.014
  14. 14.
    Sanchez, E., et al.: Raw material selection criteria for the production of floor and wall tiles. Tile Brick Int. 6(4), 15–21 (1990)Google Scholar
  15. 15.
    Kunduraci, N., Aydın, T., Akbay, A.: The effect of nepheline syenite addition on the sintering behaviour of sanitaryware bodies. J Aust Ceram Soc. 52(2), 82–86 (2016)Google Scholar
  16. 16.
    Kunduraci, N., Aydın, T.: The effect of nepheline syenite addition on sanitaryware body. Int J Eng Res Dev. 7, 2 (2015)Google Scholar
  17. 17.
    Kingrey, W.D., Bowen, H.K., Uhlmann, D.R.: Introduction to Ceramics, 2nd edn. Wiley Interscience Publication, Canada (1976)Google Scholar
  18. 18.
    Gilabert, F.A., Bó, M.D., Cantavella, V., Sánchez, E.: Fracture patterns of quartz particles in glass feldspar matrix. Mater Lett. 72, (2012).  https://doi.org/10.1016/j.matlet.2011.12.074
  19. 19.
    Gilabert, F.A., Cantavella, V., Dal Bó, M., Sánchez, E.: Modeling microstructural damage of silicate-based ceramics and its influence on macroscopic fracture strength. Acta Mater. 70, 30–44 (2014)Google Scholar
  20. 20.
    Zvezdin, D.F., Kir’yanov, A.V.: Moisture expansion of ceramic tiles in double firing. Glas Ceram. 63, 20–21 (2006)Google Scholar
  21. 21.
    Vasic, R., Vasic, M.: Phenomenon of moisture expansion and its influence on degradatıon, relıabılıty and durability of heavy clays products. Ceram/Ceram. 97 (2006)Google Scholar
  22. 22.
    Plesingerova, B., Klapac, M., Kovalcikova, M.: Moisture expansion of porous biscuit bodies -reason of glaze cracking. Ceram Silikáty. 46, 159–165 (2002)Google Scholar
  23. 23.
    Segadaes, A.M., Carvalho, M.A., Ferreira, H.C.: Using phase diagrams to deal with moisture expansion. Ceram Int. 29, 947–954 (2003)Google Scholar
  24. 24.
    Amorós, J.L., Orts, M.J., Mestre, S., Garcia-Ten, J., Feliu, C.: Porous single-fired wall tile bodies: influence of quartz particle size on tile properties. J Eur Ceram Soc. 30, (2010).  https://doi.org/10.1016/j.jeurceramsoc.2009.08.001
  25. 25.
    Tunçel, D.Y., Özel, E.: Evaluation of pyroplastic deformation in sanitaryware porcelain bodies. Ceram Int. 38, (2012).  https://doi.org/10.1016/j.ceramint.2011.09.019
  26. 26.
    Noirot, M.D., Carty, W.M.: Dynamic pyroplastic deformation study: digital time-lapse photography of porcelain firing. Ceram Eng Sci Proc. 24(2), 133–147 (2003)Google Scholar
  27. 27.
    Capoglu, A.: A novel low-clay translucent whiteware based on anorthite. J Eur Ceram Soc. 31, 321–329 (2011)Google Scholar
  28. 28.
    Carty, W.M.: Observations on the glass phase composition in porcelains. Ceram Eng Sci Proc. 23(2), 79–93 (2002)Google Scholar

Copyright information

© Australian Ceramic Society 2018

Authors and Affiliations

  1. 1.Fine Art Faculty, Ceramic DepartmentUsak University, Bir Eylul kampusuUsakTurkey

Personalised recommendations