Advertisement

The run management system for CSNS

  • Yuliang ZhangEmail author
  • Mingtao Kang
  • Dapeng Jin
  • Yongcheng He
  • Peng Zhu
  • Xuan Wu
  • Fengqin Guo
  • Lin Wang
  • Wenchun Gao
  • Gang Li
Original Paper
  • 14 Downloads

Abstract

Backgroud

The China Spallation Neutron Source (CSNS) accelerator consists of an 80-MeV H-linac, a 1.6-GeV rapid cycling synchrotron (RCS) and two beam transport lines. The designed proton beam power is 100 kW in Phase-I. The CSNS accelerator can operate in different beam modes and beam destinations, and for each beam destination, the beam power must be strictly restricted; meanwhile, the linac and the RCS may operate independently during the commissioning stage.

Purpose

To satisfy these operation requirements, the run management system (RMS) was designed and deployed for CSNS.

Method

The run management system, including a hardware layer and a software layer, operates on the top level of the global control system. RMS coordinates the machine protection system, personnel protection system, timing system and other systems, to set and publish the machine states and machine modes, to verify beam parameters and to permit the beam extraction from ion source.

Conclusion

The RMS has been operating for more than one and half years and has played an important role during the commissioning and operation of CSNS facility. This paper will introduce the design and implementation of the RMS for CSNS.

Keywords

CSNS Operation management Machine modes Machine states Beam permit 

Notes

Acknowledgements

This work was supported by the China Spallation Neutron Source project—the National Science Foundation of China (Grant No. 11575289), State Key Laboratory of Particle Detection and Electronics (Institute of High Energy Physics, CAS and University of Science and Technology of China) and Key Laboratory of Particle Acceleration Physics and Technology (Institute of High Energy Physics, CAS).

Compliance with ethical standards

Conflict of interest

On behalf of all authors, the corresponding author states that there is no conflict of interest.

References

  1. 1.
    J. Wei, S.N. Fu, S.X. Fang., China spallation neutron source accelerators: design, research, and development, in Proceedings of EPAC, 2006Google Scholar
  2. 2.
    S. Wang, S.X. Fang, Q. Qin, J.Y. Tang, J. Wei, Introduction to the overall physics design of CSNS accelerators. Chin. Phys. C 33, 1 (2009)ADSGoogle Scholar
  3. 3.
    Y.L. Ma, Q.B. Wang, Y.F. Wang, Q.B. Wu, J.G. Li, Design of CSNS radiation safety interlocking access control system. Nucl. Saf. 16, 85 (2017)Google Scholar
  4. 4.
    arXiv:ftp/physics/papers/0111/0111039. Retrieved 7th Mar 2019
  5. 5.
  6. 6.
    Y.C. He, C.H. Wang, Z. Zhao, M.T. Kang, J.C. Wang, Research and implementation of embedded EPICS IOC based on F3RP61. Nucl. Electron. Detect. Technol. 32, 17 (2012)Google Scholar
  7. 7.
  8. 8.

Copyright information

© Institute of High Energy Physics, Chinese Academy of Sciences; Nuclear Electronics and Nuclear Detection Society 2019

Authors and Affiliations

  1. 1.Institute of High Energy PhysicsBeijingChina
  2. 2.Dongguan Neutron Science CenterDongguanChina
  3. 3.University of Chinese Academy of SciencesBeijingChina

Personalised recommendations