Finding space to grow urban hedges as a natural air filter along pedestrian paths: a GIS-based investigation of a UK urban centre
- 361 Downloads
Road vehicles are a significant source of air pollution in cities, with impacts on human health. Previous work has shown that hedges located between the road carriageway and pavement can help to mitigate the impact of vehicle emissions for pedestrians and residents. For continuous improvement of air quality around the city centre area, roadside hedges can be of value. This study has used UK government statistics to map the traffic emissions along major roads in an urban centre. Using appropriate geoprocessing techniques, suitable locations for planting roadside hedges have been identified along these roads. It is envisaged that planting suitable urban hedges at these locations can help further improve air quality.
KeywordsRoadside hedges Air quality Vehicle emissions Geographical information systems Urban geography
Road vehicles emit harmful pollutants in the form of particulate matter, nitrous oxides and carbon monoxide (Abhijith et al. 2017), all of which have adverse impacts on human health. Poor air quality is a cause of illness and premature death worldwide. Only in UK, air quality related health services costs around £20 billion per year (Welsh Air Quality Forum 2016).
Previous studies have shown that vegetation in urban areas can influence the dispersion of pollutants, and also help to remove urban pollutants from the atmosphere (Escobedo and Nowak 2009; Fantozzi et al. 2015; Janhäll 2015; Nowak 2006; Yin et al. 2011). Recently study by Abhijith et al. (2017) has shown that among, different types of vegetation, urban hedges are found to be extremely important since they divert airborne pollutants from reaching the pavement by generating local air vortices. Hedges with lower permeability and greater height showed more pollutant reduction. To achieve maximum pollutant reduction at breathing height, studies suggest an optimum hedge height of 2 m, though this will vary depending on the street layout (Gromke et al. 2016; Li et al. 2016). A review of studies by Abhijith et al. (2017) found that hedges reduced pollutant exposure on pavements by between 24 and 61%.
Literature on urban green spaces lacks any significant covering of urban hedges. Mostly the literature covers green belts, parks, forests, green roofs, streams, and community gardens (Wolch et al. 2014). Although a lot of research has been carried out on hedges in Britain, but emphasis has mostly remained on the rural hedges only (Gosling et al. 2016). This shows a significant gap in literature on the use or promotion of urban hedges as a mean to control traffic pollution and improve air quality.
Department of transport average annual daily flow
Comma separated values (CSV)
Department of transport vehicle licensing statistics
Open document spreadsheet (ods)
National atmospheric emissions inventory
Excel workbook (xlsx)
Ordnance survey MasterMap topography layer
Geography markup language (GML)
Ordnance survey open roads
Geography markup language (GML)
Getmapping aerial imagery
Average annual daily flow
The average annual daily flow (AADF) dataset, produced by the Department for transport (DfT), gives the number of vehicles that drive on a particular stretch of road, on an average day of a particular year. Figures are produced for major roads on a yearly basis, with each stretch of road defined from junction to junction (Department for Transport 2018a). This study made use of AADF figures for the year 2016.
Vehicle licensing statistics
The department for transport produces statistics on licensed road vehicles, derived from data held by the Driver and Vehicle Licensing Agency (DVLA). This study made use of statistics on the percentages of licensed cars and light goods vehicles (LGVs) propelled by petrol or diesel fuel, for the year 2016 (Department for Transport 2018b).
National atmospheric emissions inventory
The National atmospheric emissions inventory (NAEI) provides emissions factors for a range of pollutants relevant to road transport. This study made use of the NAEI’s fleet-weighted hot exhaust emission factors for nitrogen oxides (NOx), coarse particles (PM10), fine particles (PM2.5), and carbon monoxide (CO). Hot exhaust emissions are the tailpipe emissions in g/km from a vehicle with its engine warmed up to its normal operating temperature. The NAEI provides hot exhaust emissions factors for a combination of different vehicle types, fuel types and road types. These data are weighted to reflect the composition of the UK fleet and journeys made in the year 2014 (National Atmospheric Emissions Inventory 2018).
OS MasterMap topography layer
OS MasterMap topography layer is the most detailed topographic map produced by Great Britain’s national mapping agency, the Ordnance Survey (OS) (Ordnance Survey 2018a). Importantly for this study, OS MasterMap topography layer maps the locations of roadside features, such as verges or pavements. This study made use of OS MasterMap topography layer data for a 9 km2 area.
OS open roads
OS open roads is a digital representation of Great Britain’s road network, produced by the Ordnance Survey. It forms a topologically connected link and node network, where links represent the approximate central alignment of the road carriage way, and nodes represent road junctions (Ordnance Survey 2018b). This study made use of OS open roads data for a 9 km2 area.
Getmapping aerial imagery
Getmapping produces high resolution vertical aerial imagery (Getmapping 2018). This study made use of 25 cm resolution imagery for a 9 km2 area.
Mapping average annual daily flow data using OS open roads
The AADF dataset describes a particular stretch of road using its DfT road number, the junction at the start of that stretch of road, and the junction and the end of the stretch of road. Each stretch of road is also assigned a unique value for the attribute “CP”. QGIS was used to identify road links in the OS Open Roads dataset that match the description in the AADF dataset, and then assign the appropriate “CP” value to those road links in OS Open Roads. This allowed the datasets to be joined, and the AADF data to be mapped.
Estimating total emissions
For each stretch of road, the AADF dataset provides a breakdown of number of vehicles by vehicle type. For this study, the figures for different types of rigid Heavy Goods Vehicles (HGVs) were combined together, as were those for articulated HGVs. This resulted in six categories: motorcycles, cars and taxis, buses and coaches, light goods vehicles (LGVs), rigid HGVs, and articulated HGVs.
DfT vehicle licensing statistics were then used to proportionally split the cars and taxis, and LGV categories according to fuel type (either petrol or diesel). This resulted in eight categories of vehicle, matching those used in the NAEI road transport emissions factors: motorcycles, petrol cars, diesel cars, buses and coaches, petrol LGVs, diesel LGVs, rigid HGVs, and articulated HGVs.
For each of the eight vehicle types, the number of vehicles on each stretch of road was multiplied by the sum of the urban hot exhaust emission factors for NOx, PM2.5, PM10, and CO. This gave an estimate of the total emissions for each vehicle type on each stretch of road. By summing the estimates for each vehicle type, the total emissions from all vehicles were calculated for each stretch of road. The total emissions data was then joined to the OS Open Roads dataset to create a map of road vehicle emissions.
Estimating pavement widths
A map was created of pavement widths, with three classes: 0–2 m, 2–5 m, and > 5 m.
Identifying suitable locations for proposed hedges
Pavements categorised as 2–5 m and 5–11 m wide were considered for the analysis, where those 5–11 m wide are considered most suitable for planting hedges. In most cases the pavement wider than 5 m would be wide enough to accommodate a 1 m wide hedge, without too much impact on pedestrian traffic. However, pavement width is not the only constraint that can affect suitability for planting roadside hedges. For example, hedges cannot be planted where access from the pavement to the carriageway is required, such as at bus stops, pedestrian crossings, or parking bays. There were also some sections of pavement where hedges had already been planted.
Aerial imagery of sections of pavement wider than 5 m was examined to identify where hedges already existed, and where there were other constraints that would prevent the planting of hedges. Once these were taken into account, suitable locations for planting hedges were identified as discussed in results below.
Total road vehicle emissions
Suitable locations for proposed hedges
Methodology presented in this paper to map spatial variation of traffic emissions and locating space to grow urban hedges along these roads has been applied in the city centre area of Cardiff city. Pavements wider than 5 m are considered highly suitable for growing urban hedges. Twelve locations were identified where the pavement is wider than 5 m and these places are highly suitable for planting roadside hedges. Four locations were identified along Bute Terrace and Adam Street, where the total road vehicle emissions are 24.7 kg/km. Two locations were identified along Plas Dumfries and Newport Road (west of Fitzalan Place), where the total road vehicle emissions are 29.7 kg/km. The location identified on Newport Road also has relatively high volumes of pedestrian traffic, so may be a particularly beneficial location in terms of reducing the impact of road vehicle emissions on pedestrians.
Pavements between 2 and 5 m are proposed as moderately suitable for growing urban hedges. Several moderately suitable locations where identified for the purpose. However, none of these locations were alongside the roads having high vehicle emissions, e.g., Central Link and Heol Y. Castell. The central link does not have a pavement for pedestrians; therefore it could not be included in the analysis. Nevertheless, there is an unpaved area on both sides of Central Link with some vegetation. This area can be utilised for roadside hedge.
The method of analysing together the high emission road segments and the available space to grow urban hedges provide an effective framework for the decision/policy makers to take realistic and evidence based decisions to increase urban green space. Along with other types of urban vegetation, such as parks, gardens and urban trees, these proposed urban hedges along busy traffic routs can be helpful to reduce air pollution by providing an air filter at the exhaust pipe level. This will help provide cleaner air to pedestrians and residents and will improve the aesthetics of the urban fabric. It will also help reduce urban heat island effects in summer months.
The study is the first of its kind with respect to proposing a methodology to identify space to grow urban hedges along major roads in urban centres. The proposed methodology has been successfully applied in the study area and several segments of pavements have been identified which are highly or moderately suitable to grow hedges. Urban hedges planted along these segments can be helpful in mitigating the impact of road vehicle emissions on pedestrians and to improve the overall air quality of the busy town centres. Study has also provided a methodology to map spatial variation of road vehicle emissions along different segments of roads in city centre area. The methodology has been applied in the study area which provides a good indication of which roads are the largest source of traffic pollutants.
The two outcomes, i.e., the spatial variation in traffic pollution and the most suitable places to grown urban hedges can complement each other and help the policy/decision makers for making informed decisions for the betterment of urban air quality. It is worth noting that there is a variety of transport and building projects either planned or under construction in and around the city centre. This will result in changes to the layout of many roads and pavements (Cardiff Council 2018). It is, therefore, recommend that the decision makers make use of the methodology and incorporate it into the design of pavements to spare more space for growing urban hedges in the city centre area of Cardiff.
The methodology presented in this study is not specific to the study area and can be equally applied in any urban centre. However, the methodology involves some visual inspection of segments for the identification of barriers, e.g., access required for bus stops. It is suggested that methodology can be improved in a future work by incorporation of an automated or semi-automated geoprocessing routine for this purpose. This will significantly improve the time required to implement the methodology and large urban centres like London can be covered with ease.
- Cardiff Council (2018) Cardiff’s transport & clean air green paper: changing how we move around a growing city. https://www.cardiff.gov.uk/ENG/resident/Parking-roads-and-travel/transport-and-clean-air-green-paper/Documents/Cardiff%27s%20Transport%20and%20Clean%20Air%20Green%20Paper.pdf. Accessed 13 Aug 2018
- Department for Transport (2018a) Traffic counts. http://www.dft.gov.uk/traffic-counts/about.php. Accessed 13 Aug 2018
- Department for Transport (2018b) Vehicles statistics. https://www.gov.uk/government/collections/vehicles-statistics#data-tables. Accessed 13 Aug 2018
- Getmapping (2018) aerial data—GB imagery. http://www.getmapping.com/products/aerial-data-high-resolution-imagery/aerial-data-gb-imagery. Accessed 13 Aug 2018
- National Atmospheric Emissions Inventory (2018) Emission factors for transport. http://naei.beis.gov.uk/data/ef-transport. Accessed 13 Aug 2018
- Ordnance Survey (2018a) OS MasterMap topography layer. https://www.ordnancesurvey.co.uk/business-and-government/products/topography-layer.html. Accessed 13 Aug 2018
- Ordnance Survey (2018b) OS Open Roads. https://www.ordnancesurvey.co.uk/business-and-government/products/os-open-roads.html. Accessed 13 Aug 2018
- Welsh Air Quality Forum (2016) Air pollution in Wales 2015. https://airquality.gov.wales/sites/default/files/documents/2016-12/507161019_AQ_wales_2015_v12_Press.pdf. Accessed 13 Aug 2018
- Welsh Air Quality Forum (2017) Air pollution in Wales 2016. https://airquality.gov.wales/sites/default/files/documents/2017-11/AQ_wales_2016_v5.pdf. Accessed 13 Aug 2018
Open AccessThis article is distributed under the terms of the Creative Commons Attribution 4.0 International License (http://creativecommons.org/licenses/by/4.0/), which permits unrestricted use, distribution, and reproduction in any medium, provided you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons license, and indicate if changes were made.