Advertisement

Performance of Multi-Helix Pile Embedded in Organic Soil Under Pull-out Load

  • Majid HamedEmail author
  • Hanifi Canakci
  • Omar Khaleel
Technical Paper
  • 19 Downloads

Abstract

The performance of multi-helix plate piles under pull-out load in organic soils is tested through an experimental investigation on helical piles. On the basis of experimental tests, this study presents the feasibility of multi-helix pile behavior installed in organic soil. Tests were carried out on two different densities of organic soil. The helix piles were made of 16-mm-diameter mild steel shafts to which mild steel plates of 50 mm for both diameter and pitch were welded. Tests were performed on single-, double-, triple-, and quadruple-helix cylindrical screw piles with helix spacing to diameter ratios varying from 0.1 to 0.5. A set of tests was also performed to evaluate efficiency. The results of the tests are used to illustrate the difference in ultimate capacity for the different geometry anchors. The results showed that the helical pile behavior depends essentially on pile geometric characteristics and soil density. According to the achievements, pull-out load capacity of helical piles depends on spacing ratio (S/D) and number of plates.

Keywords

Helical pile Organic soil Pull-out capacity Pile efficiency 

Notes

References

  1. 1.
    Khazaei, J., Eslami, A.: Geotechnical behavior of helical piles via physical modeling by frustum confining vessel (FCV). Int. J. Geogr. Geol. 5(9), 167–181 (2016)CrossRefGoogle Scholar
  2. 2.
    Prasad, V.S.N., Rao, S.N.: Lateral capacity of helical piles in sand. J. Geotech. Eng. ASCE. 122(11), 938–941 (1996)CrossRefGoogle Scholar
  3. 3.
    Spagnoli, G., Gavin K.: Helical piles as a novel foundation system for offshore piled facilities. Abu Dhabi International Petroleum Exhibition and Conference, (2015)Google Scholar
  4. 4.
    Rao, N.S., Prasad, Y.V.S.N.: Estimation of uplift capacity of helical anchors in clays. J. Geotech. Eng., ASCE. 119(2), 352–357 (1993)CrossRefGoogle Scholar
  5. 5.
    Ghaly, A.M., Clemence, S.P.: Pullout performance of inclined helical screw anchors in sand. J. Geotech. Geoenviron. Eng. ASCE. 124, 617–627 (1998)CrossRefGoogle Scholar
  6. 6.
    Merifield, R.S.: Uplift capacity of multiplate helical type anchors in clay. J. Geotech. Geoenviron. Eng.. ASCE. 137(7), 704–716 (2011)CrossRefGoogle Scholar
  7. 7.
    Mooney, J. S., Adamczak, S. J., Clemence, S. P.: Uplift capacity of helix anchors in clay and silt. Geotechnical Engineering Division of the American Society of Civil Engineers in Conjunction with the ASCE Convention. Proc. Session, Detroit. New York: ASCE (1985)Google Scholar
  8. 8.
    Mitsch, M. P., Clemence, S. P.: The uplift capacity of helix anchors in sand. Uplift behavior of anchor foundation in soil. ASCE. 26–47(1985)Google Scholar
  9. 9.
    Hoyt, R. M., Clemence, S. P.: Uplift capacity of helical anchors in soil. Proc. 12th Int. Conf. Soil Mechanics and Foundation Engineering. Rio de Janeiro, 1019–1022 (1989)Google Scholar
  10. 10.
    Ghaly, A., Hanna, A., Hanna, M.: Uplift behavior of screw anchors in sand. I: dry sand. J. Geotech. Eng. (1991).  https://doi.org/10.1061/(ASCE)0733-9410
  11. 11.
    Rao, N.S., Prasad, Y.V.S.N., Shetty, M.D.: The behavior of model screw piles in cohesive soils. Soils Found. 31(2), 35–50 (1991)CrossRefGoogle Scholar
  12. 12.
    Mittal, S., Mukherjee, S.: Behaviour of group of helical screw anchors under compressive loads. Geotech. Geol. Eng J. 33, 575–592 (2015)CrossRefGoogle Scholar
  13. 13.
    Amde, A.M., Chini, S.A., Mafi, M.: Model study of H-piles combined loading. Geotech. Geol. Eng. 15, 343–355 (1997)Google Scholar
  14. 14.
    El Naggar, M.H., Sakr, M.: Cyclic response of axially loaded tapered pile. Int. J. Phys. Model. Geotech. 4, 01–12 (2002)Google Scholar
  15. 15.
    Banerjee, S., Goh, S.H., Lee, F.H.: Earthquake-induced bending moment in fixed-head piles in soft clay. Géotechnique. 64(6), 431–446 (2014)CrossRefGoogle Scholar
  16. 16.
    ASTM D422, Standard test method for particle size analysis of soils. ASTM International, West Conshohocken, (2002)Google Scholar
  17. 17.
    ASTM D854, Standard test methods for specific gravity of soil solids by water pycnometer. ASTM International, West Conshohocken, (2014)Google Scholar
  18. 18.
    ASTM D2974, Standard test methods for moisture, ash, and organic matter of peat and other organic soils. ASTM International, West Conshohocken, (2014)Google Scholar
  19. 19.
    Stanier, S.A., Black, J.A., Hird, C.C.: Modelling helical screw piles in soft clay and design implications. Geotech. Eng. J. 167, 447–460 (2013)CrossRefGoogle Scholar
  20. 20.
    Hird, C., Stanier, S.: Modelling helical screw piles in clay using a transparent soil. In Proceedings of the 7th International Conference on Physical Modelling in Geotechnics: ICPMG 2010, Zurich, Switzerland (Seward L (ed.)). CRC Press. ASCE. Reston. 2, 769–774 (2010)Google Scholar
  21. 21.
    Tsuha, C.H.C., Aoki, N., Rault, G., Thorel, L., Garnier, J.: Evaluation of the efficiencies of helical anchor plates in sand by centrifuge model tests. Can. Geotech. J. 49(9), 1102–1111 (2012)CrossRefGoogle Scholar
  22. 22.
    Mittal, S., Ganjoo, B.S., Shekhar, S.: Static equilibrium of screw anchor pile under lateral load in sand. Geotech. Geol. Eng. 28, 717–725 (2010)CrossRefGoogle Scholar
  23. 23.
    Rao, S., Prasad, Y., Veeresh, C.: Behaviour of embedded model screw anchors in soft clays. Géotechnique. 43(4), 605–614 (1993)CrossRefGoogle Scholar
  24. 24.
    Lutenegger, A. J.: Behavior of multi-helix screw anchors in sand. In Proceedings of the 14thPan-American Conference on Soil Mechanics and Geotechnical Engineering. 126 (2011)Google Scholar
  25. 25.
    Elsherbiny, Z.H., El Naggar, M.H.: Axial compressive capacity of helical piles from field tests and numerical study. Can. Geotech. J. 50, 1191–1203 (2013)CrossRefGoogle Scholar

Copyright information

© Springer Science+Business Media, LLC, part of Springer Nature 2019

Authors and Affiliations

  1. 1.Department of Civil EngineeringKirkuk UniversityKirkukIraq
  2. 2.Department of Civil EngineeringGaziantep UniversityŞehitkamilTurkey

Personalised recommendations