Experimental investigation of copper nanofluid based minimum quantity lubrication in turning of H 11 steel
- 56 Downloads
Plentiful supply of coolant might enhance the machining cost and also generates environmental hazard. As a result, substitute methods are required to eliminate the problems encountered during use of coolant. In this investigation, the impact of cutting speed, feed and lubrication conditions (dry: no lubrication, oil: machining is performed with groundnut oil and nano fluid: machining performed with copper nano fluid) on surface roughness, tool wear and chip morphology in turning of H 11 steel with minimum quantity lubrication (MQL) were examined. Experiments were conducted using L18 orthogonal array. The results reveal that copper nanofluids with MQL provide a substitute for dry and oil machining. Response surface methodology has been used to derive optimal values and mathematical models. Tool wear was reduced by 66% and surface roughness by 40% while machining with copper nano fluids. The surface roughness and tool wear were decreased under optimal machining conditions. Generation of large notched tooth in chips has been minimised with copper nano fluids. Furthermore, the morphology of the chips were analysed for dry, oil and nano fluid under scanning electron microscope to observe the texture created.
KeywordsCopper Nano fluids Minimum quantity lubrication Response surface method
Compliance with ethical standards
Conflict of interest
The authors declare no potential conflicts of interest with respect to the research, authorship and/or publication of this article.
- 10.Vasu V, Pradeep Kumar Reddy G (2011) Effect of minimum quantity lubrication with Al2O3 nanoparticles on surface roughness, tool wear and temperature dissipation in machining Inconel 600 alloy. Proc IMech E Part N J Nano Eng Nanosyst 225:3–16Google Scholar
- 16.NarayanaRao S, Satyanarayana B, Venkatasubbaiah K (2011) Experimental estimation of tool wear and cutting temperatures in MQL using cutting fluids with CNT inclusion. Int J Eng Sci Technol 3:2928–2931Google Scholar
- 18.Huang WT, Wu DH, Lin SP, Chen JT (2014) Robust design of using MWCNTs in minimum quantity lubrication. Appl Mech Mater 670–671:11–21Google Scholar
- 21.Prasad M, Srikant R (2013) Performance evaluation of nano graphite inclusions in cutting fluids with MQL technique in turning of AISI 1040 Steel. Int J Res Eng Tech 2:381–393Google Scholar
- 37.Vasu V, Pradeep Kumar Reddy G (2011) Effect of minimum quantity lubrication with Al2O3 nanoparticles on surface roughness, tool wear and temperature dissipation in machining Inconel 600 alloy. Proc IMech E Part N J Nanoeng Nanosyst. https://doi.org/10.1177/1740349911427520
- 44.Kalaimathi M, Venkatachalam G, Sivakumar M (2014) Experimental investigations on the electrochemical machining characteristics of monel 400 alloys and optimization of process parameters. Jordan J Mech Ind Eng 8:143–151Google Scholar