Advertisement

Experimental Investigations on LHR Single Cylinder Air Cooled Diesel Engine using Simarouba Biodiesel and its Blends as Alternate to Diesel Fuel

  • Anjaneya Gorkal
  • C. Prabhakar Reddy
  • M. Udaya Ravi
Original Contribution

Abstract

Experiments are conducted to study the performance, exhaust emissions and combustion characteristics of a conventional and LHR diesel engine running with simarouba biodiesel (100%) and its blends (10, 20 and 30% by volume) with diesel as an alternate fuel to neat diesel. The conventional engine is modified as LHR engine by coating 300 μm of PSZ on the piston crown which acts as thermal barrier and reduces heat loss to cooling medium and increases in-cylinder temperature by 50 to 100°C. Conventional and LHR engine are tested with neat diesel, biodiesel and biodiesel blends at an injection pressure of 200 bar and injection timing of 23° btdc. The load is applied in steps of 25% from no load to full load and results obtained are analyzed. LHR engine performed better compared to conventional engine; improved performance, significant reductions in exhaust emissions (except NOX) and improved combustion characteristics for all the blends tested. The percentage increase in brake thermal efficiency of neat diesel, SBD10, SBD20, SBD30 and SBD100 in LHR engine is 1.98, 5.61, 6.0, 3.98 and 2.98, respectively compared to conventional engine at 75% of full load. Amongst the blends tested, SBD20 proved to be better in both the engines. In LHR engine with SBD20 the percentage increase in brake thermal efficiency, pressure rise and heat release rates are 11.28, 6.35 and 14.0, respectively compared to diesel in conventional engine. Percentage decrease in carbon monoxide, hydrocarbon and smoke opacity is 50.0, 46.43 and 40.0, respectively as compared to diesel in conventional engine.

Keywords

Biodiesel blends LHR engine Injection pressure Performance Emissions 

Notations

D

Neat diesel

SBD10

10% simarouba biodiesel+90% diesel

SBD20

20% simarouba biodiesel+80% diesel

SBD30

30% simarouba biodiesel+70% diesel

SBD100

100% simarouba biodiesel

CE

Conventional engine

LHR

Low heat rejection

LHRE

Low heat rejection engine

PSZ

Partially stabilized zirconia

btdc

Before top dead centre

References

  1. 1.
    R. Altın, S. Çetinkaya, H.S. Yücesu, The potential of using vegetable oil fuels as fuel for diesel engines. Energy Convers. Manag. 42(5), 529–538 (2001)CrossRefGoogle Scholar
  2. 2.
    A.S. Ramadhas, S. Jayaraj, C. Muraleedharan, Use of vegetable oils as I.C. engine fuels—a review. Renew. Energy 29(5), 727–742 (2004)CrossRefGoogle Scholar
  3. 3.
    S.S. Sidibé, J. Blin, G. Vaitilingom, Y. Azoumah, Use of crude filtered vegetable oil as a fuel in diesel engines, state of the art: literature Review. Renew. Sustain. Energy Rev. 14(9), 2748–2759 (2010)CrossRefGoogle Scholar
  4. 4.
    A.K. Babu, G. Devaradjane, Vegetable oils and their derivatives as fuels for CI engines: an overview. SAE Technical Paper No. 2003-01-0767. doi:  10.4271/2003-01-0767
  5. 5.
    Jones et al, Used vegetable oil fuel blend comparisons using injector coking in a DI diesel engine. SAE Paper No. 01-6051, (2001)Google Scholar
  6. 6.
    D. Agarwal, A.K. Agarwal, Performance and emissions characteristics of Jatropha oil (preheated and blends) in a direct injection compression ignition engine. Appl. Therm. Eng. 27, 2314–2323 (2007)CrossRefGoogle Scholar
  7. 7.
    A. Demirbas, Biodiesel production from vegetable oils via catalytic and non-catalytic supercritical methanol transesterification methods. Prog. Energy Combust. Sci. 31, 466–487 (2005)CrossRefGoogle Scholar
  8. 8.
    S.R. Mishra, M.K. Mohanty, S.P. Das, A.K. Pattanaik, Production of bio-diesel (Methyl Ester) from Simarouba glauca Oil. Res. J. Chem. Sci. 2, 66–71 (2012)Google Scholar
  9. 9.
    J. Janaun, N. Ellis, Perspectives on biodiesel as a sustainable fuel. Renew. Sustain. Energy Rev. 14(4), 1312–1320 (2010)CrossRefGoogle Scholar
  10. 10.
    J. Xuea et al, Effect of biodiesel on engine performances and emissions. Renew. Sustain. Energy Rev. 15, 1098–1116 (2011)CrossRefGoogle Scholar
  11. 11.
    M. Mofijur, H.H. Masjuki, M.A. Kalam, A.E. Atabani, M. Shahabuddin, Effect of biodiesel from various feed stocks on combustion characteristics, engine durability and materials compatibility: a review. Renew. Sustain. Energy Rev. 28, 441–455 (2013)CrossRefGoogle Scholar
  12. 12.
    V.K. Domakonda, R.K. Puli, Application of thermal barrier coatings in diesel engines: a review. Energy Power 2, 9–17 (2012)CrossRefGoogle Scholar
  13. 13.
    M.J. Abedin, H.H. Masjuki, M.A. Kalam, A. Sanjid, A.M. Shraful, Combustion, performance, and emission characteristics of low heat rejection engine operating on various biodiesels and vegetable oils. Energy Convers. Manag. 85, 173–189 (2014)CrossRefGoogle Scholar
  14. 14.
    M.M. Musthafa, S.P. Sivapirakasam, M.U. Kumar, K.R. Bala Subramanian, Effects of Al2O3 coating on diesel engine performance, combustion and emission characteristics fueled by pongamia methyl ester and its blends with diesel. Environ. Prog. Sustain. Energy (2011). doi: 10.1002/ep.10534 CrossRefGoogle Scholar
  15. 15.
    B.R. Prasath, P.T. Porai, M.F. Shabir, An experimental comparison of combustion, performance and emission in a single cylinder thermal barrier coated diesel engine using diesel and biodiesel. Glob. J. Sci. Front. Res. 10(4), 2–8 (2010)Google Scholar
  16. 16.
    N.R. Banapurmath, P.G. Tewari, Performance studies of a low heat rejection engine operated on non-volatile vegetable oils with exhaust gas recirculation. Int. J. Sustain. Eng. 2(4), 265–274 (2009)CrossRefGoogle Scholar
  17. 17.
    N.R. Banapurmath, P. Tewari, Performance of a low heat rejection engine fuelled with low volatile Honge oil and its methyl ester (HOME). Proc. IMech E Part A Power Energy (2008). doi: 10.1243/09576509JPE514 CrossRefGoogle Scholar
  18. 18.
    P. Ramaswamy, S. Seetharamu, K.B.R. Varma, K.J.A. Rao, Simple method for the preparation of plasma sprayable powders based on ZrO2. J Mater Sci 31(23), 6325–6332 (1996)CrossRefGoogle Scholar
  19. 19.
    P. Ramaswamy, S. Seetharamu, K.B.R. Varma, N. Raman, K.J. Rao, Thermo-mechanical fatigue characterization of Zirconia (8% Y2O3–ZrO2) and mullite thermal barrier coatings on diesel engine components. Proc. Inst. Mech. Eng. Part C J. Mech. Eng. Sci. 214(5), 729–742 (2000)CrossRefGoogle Scholar
  20. 20.
    K. Birch, Measurement Good Practice Guide No. 36. An intermediate Guide to Estimating and Reporting Uncertainty of Measurement in Testing, British Measurement and Testing Association, Middlesex, pp. 6–11, 2003Google Scholar
  21. 21.
    J.P. Holman, Experimental Methods for Engineers, McGraw-Hill Series in Mechanical Engineering, 8th edn. (Avenue of the Americas, New York, 2012), pp. 63–72Google Scholar
  22. 22.
    A. Parlak, The effect of heat transfers on performance of the diesel cycle and exergy of the exhaust gas stream in a LHR diesel engine at optimum injection timing. Energy Convers. Manag. 46(2), 167–179 (2005)CrossRefGoogle Scholar
  23. 23.
    X. Sun, W. Wang, R. Bata, Performance evaluation of LHR engines. ASME Trans. 116(4), 758–764 (1994)Google Scholar
  24. 24.
    S.J. Chander, P. Tamilporai, LHR engines-an overview, Paper No. 2003-01-0405, (2003). doi:  10.4271/2003-01-0405
  25. 25.
    B. Challen, R. Baranescu, Diesel Engine Reference Book, 2nd edn. (Butter Worth Heinemann, Oxford, 1999)Google Scholar
  26. 26.
    M. Azadi, M. Baloo, G. Farrahi, S.M. Mirsalim, A review of TBC effects on diesel engine performance and components lifetime. Int. J. Automot. Eng. 3(1), 305–317 (2013)Google Scholar
  27. 27.
    S. Vedharaj et al, Experimental and finite element analysis of a coated diesel engine fuelled by cashew not shells liquid biodiesel. Int. J. Exp. Therm. Fluid Sci. 53, 259–268 (2014)CrossRefGoogle Scholar
  28. 28.
    B. Iscan et al, Improving usability of vegetable oils as fuels in low heat rejection diesel engine. Fuel Process Technol. 98, 59–64 (2012)CrossRefGoogle Scholar
  29. 29.
    H. Aydin, Combined effects of thermal barrier coating and blending with diesel fuel on usability of vegetable oils in diesel engine. Appl. Therm. Eng. 51(1–2), 623–629 (2013)CrossRefGoogle Scholar
  30. 30.
    V.K. Domakonda et al, Prediction of performance and emission of biodiesel fuelled lanthanum zirconate coated direct injection diesel engine. Procedia Eng. 64, 993–1002 (2013)CrossRefGoogle Scholar
  31. 31.
    M.M. Musthafa et al, Synthetic lubrication oil influences on performance and emission characteristic of coated diesel engine fuelled biodiesel blends. J. Appl. Therm. Energy 96, 607–612 (2016)CrossRefGoogle Scholar
  32. 32.
    B.R. Prasath et al, Analysis of combustion, performance and emission characteristics of LHR engine using biodiesel. Int. J. Therm. Sci. 49(12), 2483–2490 (2010)CrossRefGoogle Scholar

Copyright information

© The Institution of Engineers (India) 2017

Authors and Affiliations

  • Anjaneya Gorkal
    • 1
  • C. Prabhakar Reddy
    • 2
  • M. Udaya Ravi
    • 2
  1. 1.Department of Mechanical EngineeringR V College of EngineeringMysore Road, BengaluruIndia
  2. 2.School of EngineeringPresidency UniversityBengaluruIndia

Personalised recommendations