Effects of fulvic acids and electrolytes on colloidal stability and photocatalysis of nano-TiO2 for atrazine removal
- 28 Downloads
The colloidal stability and photocatalysis of nano-TiO2 particles were investigated in the presence of fulvic acids (FA) and electrolytes (NaNO3, Na2SO4, Na3PO4) at different pH. Results showed that increasing FA concentration, the absolute value of zeta potential of nano-TiO2 increased and particle size decreased at all pH which promoted the colloidal stability of nano-TiO2. Particle size of nano-TiO2 was larger with the coexistence of FA and electrolytes than with FA only as the concentration of electrolytes was greater than or equal to 0.01 mol/L. The largest particle size occurred in the presence of Na3PO4, followed by Na2SO4 and NaNO3. Particle size of nano-TiO2 decreased with higher pH and stability further increased in the presence of FA and/or electrolytes. Nano-TiO2 stabilization was enhanced by increasing FA concentration when the solution pH was 7.0. However, the removal efficiency of atrazine by nano-TiO2 decreased with the increase in FA concentration. Adding electrolytes (0.01 mol/L), atrazine removal by nano-TiO2 further decreased, albeit slightly. The inhibitory effect of electrolytes on nano-TiO2 removal of atrazine was highest for Na3PO4, followed by Na2SO4, and NaNO3, which were consistent with the results of colloidal stability of nano-TiO2. These findings help to better understand the mechanisms and correlation between colloidal stability and photocatalysis of nano-TiO2 in the presence of FA and electrolytes.
KeywordsNano-TiO2 Fulvic acids Electrolytes Colloidal stability Photocatalysis Atrazine
The authors gratefully acknowledge the financial support by the International S&T Cooperation Program of China (Project Contract No. 2015DFG92750), the National Natural Science Foundation of China (Grant Nos. 51478172, 51508538, 51278464 and 51521006), the Natural Science Foundation of Zhejiang Province of China (Grant Nos. LY17E080002) and the Department of Science and Technology of Hunan Province of China (Contract Nos. 2017JJ2029 and 2017SK2362). They also thank Dr. Zhiqiang Shen for his valuable comments during the preparation and revising procedure of the manuscript.
Compliance with ethical standards
Conflict of interest
There are no conflicts to declare.
- Borthakur P, Das MR (2018) Hydrothermal assisted decoration of NiS2 and CoS nanoparticles on the reduced graphene oxide nanosheets for sunlight driven photocatalytic degradation of azo dye: effect of background electrolyte and surface charge. J Colloid Interface Sci 516:342–354CrossRefGoogle Scholar
- He HJ, Xiang ZH, Chen XJ, Chen H, Huang H, Wen M, Yang CP (2018) Biosorption of Cd(II) from synthetic wastewater using dry biofilms from biotrickling filters. Int J Environ Sci Technol 15:1491–1500Google Scholar
- Lin D, Cai P, Peacock CL, Wu YC, Gao CH, Peng WX, Huang QY, Liang W (2018b) Towards a better understanding of the aggregation mechanisms of iron (hydr) oxide nanoparticles interacting with extracellular polymeric substances: role of pH and electrolyte solution. Sci Total Environ 645:372–379CrossRefGoogle Scholar
- Wu Y, Wang H, Sun YM, Xiao T, Tu WG, Yuan XZ, Zeng GM, Li SZ, Chew JW (2018b) Photogenerated charge transfer via interfacial internal electric field for significantly improved photocatalysis in direct Z-scheme oxygen-doped carbon nitrogen/CoAl-layered double hydroxide heterojunction. Appl Catal B Environ 227:530–540CrossRefGoogle Scholar
- Wu Y, Wang H, Tu WG, Wu SY, Liu Y, Tan YZ, Luo HJ, Yuan XZ, Chew JW (2018c) Petal-like CdS nanostructures coated with exfoliated sulfur-doped carbon nitride via chemically activated chain termination for enhanced visible-light–driven photocatalytic water purification and H2 generation. Appl Catal B Environ 229:181–191CrossRefGoogle Scholar