Advertisement

Horticulture, Environment, and Biotechnology

, Volume 60, Issue 6, pp 895–911 | Cite as

Influence of physical properties of peat-based potting mixes substituted with parboiled rice hulls on plant growth under two irrigation regimes

  • Seunghyun Choi
  • Lizhen Xu
  • Hye-Ji KimEmail author
Research Report
  • 93 Downloads

Abstract

This study was conducted to investigate the effects of physical properties of peat-based substrate mixtures partially substituted with parboiled rice hulls (PRH) on plant growth and performance. Thirteen substrate mixtures were formulated by substituting 0, 20, 30, 40, 50, 60, or 70% peat with either parboiled ground rice hulls (GRH) or whole rice hulls (WRH) (by volume) in commercial potting mix (CPM) containing 70% peat, 20% perlite, and 10% vermiculite. All substrate mixtures consisted of mainly medium-sized (2.0–0.25 mm) particles. However, regardless of the mixing ratio, GRH significantly increased the medium-sized particles especially with diameters of 2.0–0.71 mm, while WRH increased both the medium- and coarse-sized (> 2.0 mm) particles. A higher mixing ratio of PRH increased air space and decreased container capacity but to a greater extent by WRH compared to GRH. Similarly, bulk density was increased with a higher mixing ratio of both types of PRH, but to a greater degree by GRH. Total porosity of GRH-containing substrates was similar to that of CPM within the range of 30–70%. The substrate mixtures containing PRH did not have the same physical properties as the CPM at any mixing ratio, but the values of some GRH-containing mixtures were within or close to the suggested ranges for greenhouse substrates. Considering the maximum substitution of PRH for peat, the substitution with 40% GRH (GRH-40) was selected for a plant growth study in comparison to CPM. Petunia (Petunia × hybrida) ‘Easy Wave Neon Rose’ and zinnia (Zinnia elegans) ‘Benary’s Giant Golden Yellow’ were grown in pots containing CPM and GRH-40 at two irrigation levels: high (25–30%, by volume) and low (20–25%). Overall, shoot DW of both plant species was reduced in GRH-40, but root DW was maintained similar to those in CPM. The low irrigation level more significantly reduced shoot DW of petunia grown in CPM than in GRH-40, relative to their counterparts with the high irrigation level (20 and 7%, respectively); however, root growth of plant species grown in GRH-40 was either maintained or tended to be maintained even at the low irrigation level compared to their high irrigation counterparts. The water use efficiency of plants grown in GRH-40 was not significantly different from those in CPM regardless of irrigation level. These results indicate that GRH-40 provides desirable physical properties and water release characteristics, allowing more available water for plants under low irrigation levels than CPM. We concluded that substituting peat with 40% GRH in a commercial potting mix is a sustainable approach to produce petunia and zinnia.

Keywords

Alternative substrates Soilless growing media Greenhouse Container production Water holding capacity 

Notes

Acknowledgements

This research was supported by the USDA National Institute of Food and Agriculture, Hatch/Multi State Project NE-1835 Resource Optimization in Resource Optimization in Controlled Environment Agriculture; Purdue University Research Funds. We are grateful to Rob Eddy, Michael Russell, Nathan Deppe, and Dan Little for their technical assistance; Dr. Jong-Myung Choi for his support on constructing porometer systems.

Author’s contribution

SC conducted the experiments, collected data, undertook data analysis and interpretation, and drafted the manuscript. LX conducted the experiments, collected data, assisted in data analysis and interpretation, and contributed to the manuscript. HK coordinated and supervised the research, performed critical revisions, and completed the final version of the manuscript.

Compliance with ethical standards

Conflict of interest

The authors declare that they have no conflicts of interest.

Supplementary material

13580_2019_179_MOESM1_ESM.docx (67 kb)
Supplementary material 1 (DOCX 66 kb)

References

  1. Altland JE, Krause C (2009) Use of switchgrass as a nursery container substrate. HortScience 44:1861–1865Google Scholar
  2. Altland JE, Owen JS Jr, Jackson BE, Fields JS (2018) Physical and hydraulic properties of commercial pine-bark substrate products used in production of containerized crops. HortScience 53:1883–1890Google Scholar
  3. Arnold Bik R (1983) Substrates in floriculture. In: Proceedings of the XXI international horticultural congress, Hambourg, Germany vol 2, pp 811–822Google Scholar
  4. Barkham JP (1993) For peats sake: conservation or exploitation. Biodivers Conserv 2:556–566Google Scholar
  5. Barrett GE, Alexander PD, Robinson JS, Bragg NC (2016) Achieving environmentally sustainable growing media for soilless plant cultivation systems: a review. Sci Hortic 212:220–234Google Scholar
  6. Beeson RC Jr (1996) Composted yard waste as a component of container substrates. J Environ Hortic 14:115–121Google Scholar
  7. Boertje GA (1984) Physical laboratory analyses of potting composts. Acta Hortic 150:47–50Google Scholar
  8. Bohne H, Gunther C (1997) Physical properties of peat determined with different methods. Acta Hortic 450:271–276Google Scholar
  9. Boyer CR, Fain GB, Gilliam CH, Gallagher TV, Torbert HA, Sibley JL (2008) Clean chip residual: a substrate component for growing annuals. HortTechnology 18:423–432Google Scholar
  10. Buamscha MG, Altland JE, Sullivan DM, Horneck DA, Cassidy J (2007) Chemical and physical properties of Douglas fir bark relevant to the production of container plants. HortScience 42:1281–1286Google Scholar
  11. Buck JS, Evans MR (2010) Physical properties of ground parboiled fresh rice hulls used as a horticultural root substrate. HortScience 45:643–649Google Scholar
  12. Bunt AC (1988) Media and mixes for container grown plants: a manual on the preparation and use of growing media for growing pot plants, vol 13. Unwyn Hyman, LondonGoogle Scholar
  13. Evans MR (2011) Physical properties of and plant growth in peat-based root substrates containing glass-based aggregate, perlite, and parboiled fresh rice hulls. HortTechnology 21:30–34Google Scholar
  14. Evans MR, Gachukia M (2004) Fresh parboiled rice hulls serve as an alternative to perlite in greenhouse crop substrates. HortScience 39:232–235Google Scholar
  15. Evans MR, Gachukia MM (2007) Physical properties of sphagnum peat-based root substrates amended with perlite or parboiled fresh rice hulls. HortTechnology 17:312–315Google Scholar
  16. Evans MR, Gachukia MM (2008) Secondary macro- and microelements in sphagnum peat-based substrates amended with parboiled fresh rice hulls or perlite. HortTechnology 18:650–655Google Scholar
  17. Evans MR, Stamps RH (1996) Growth of bedding plants in sphagnum peat and coir dust-based substrates. J Environ Hortic 14:187–190Google Scholar
  18. Evans MR, Buck JS, Sambo P (2011) The ph, electrical conductivity, and primary macronutrient concentration of sphagnum peat and ground parboiled fresh rice hull substrates over time in a greenhouse environment. HortTechnology 21:103–108Google Scholar
  19. Fain GB, Gilliam CH, Sibley JL, Boyer CR (2008) WholeTree substrates derived from three species of pine in production of annual vinca. HortTechnology 18:13–17Google Scholar
  20. Fonteno WC (1996) Growing media: types and physical/chemical properties. A grower’s guide to water, media, and nutrition for greenhouse crops. Ball Publishing, BataviaGoogle Scholar
  21. Fonteno WC, Hardin CT, Brewster JP (1995) Procedures for determining physical properties of horticultural substrates using the NCSU porometer. Horticultural Substrates Laboratory, North Carolina State University, RaleighGoogle Scholar
  22. Gomez C, Robbins J (2011) Pine bark substrates amended with parboiled rice hulls: physical properties and growth of container-grown spirea during long-term nursery production. HortScience 46:784–790Google Scholar
  23. Gruda N, Schnitzler WH (2004) Suitability of wood fiber substrate for production of vegetable transplants—I. Physical properties of wood fiber substrates. Sci Hortic 100:309–322Google Scholar
  24. Gruda N, Schnitzler WH (2006) Wood fiber substrates as a peat alternative for vegetable productions. Holz Als Roh-Und Werkstoff 64:347–350Google Scholar
  25. Handreck KA (1983) Particle-size and the physical-properties of growing media for containers. Commun Soil Sci Plant Anal 14:209–222Google Scholar
  26. Hartz TK, Costa FJ, Schrader WL (1996) Suitability of composted green waste for horticultural uses. HortScience 31:961–964Google Scholar
  27. Jackson BE, Wright RD, Seiler JR (2009) Changes in chemical and physical properties of pine tree substrate and pine bark during long-term nursery crop production. HortScience 44:791–799Google Scholar
  28. Jenkins JR, Jarrell WM (1989) Predicting physical and chemical-properties of container mixtures. HortScience 24:292–295Google Scholar
  29. Kamath SR, Proctor A (1998) Silica gel from rice hull ash: preparation and characterization. Cereal Chem 75:484–487Google Scholar
  30. Lopez RG, Currey CJ (2013) Using parboiled rice hulls in substrates to finish greenhouse crops, vol April. Greenhouse Grower, WilloughbyGoogle Scholar
  31. Marianthi T (2006) Kenaf (Hibiscus cannabinus L.) core and rice hulls as components of container media for growing Pinus halepensis M. seedlings. Bioresour Technol 97:1631–1639PubMedGoogle Scholar
  32. Nelson PV (2003) Greenhouse operation and management. Greenhouse operation and management, 6th edn. Prentice Hall, Upper Saddle RiverGoogle Scholar
  33. Owen JS Jr, Altland JE (2008) Container height and douglas fir bark texture affect substrate physical properties. HortScience 43:505–508Google Scholar
  34. Papafotiou M, Chronopoulos J, Kargas G, Voreakou M, Leodaritis N, Lagogiani O, Gazi S (2001) Cotton gin trash compost and rice hulls as growing medium components for ornamentals. J Hortic Sci Biotechnol 76:431–435Google Scholar
  35. Quintero MF, Ortega D, Valenzuela JL, Guzman M (2013) Variation of hydro-physical properties of burnt rice husk used for carnation crops: improvement of fertigation criteria. Sci Hortic 154:82–87Google Scholar
  36. Raviv M, Lieth JH (2008) Soilless culture: theory and practice. Elsevier, San DiegoGoogle Scholar
  37. Raviv M, Chen Y, Inbar Y (1986) Peat and peat substitutes as growth media for container-grown plants. In: Chen Y, Avnimelech Y (eds) The role of organic matter in modern agriculture. Springer, Dordrecht, pp 257–287Google Scholar
  38. Rhie YH, Kim J (2017) Changes in physical properties of various coir dust and perlite mixes and their capacitance sensor volumetric water content calibrations. HortScience 52:162–166Google Scholar
  39. Richards D, Lane M, Beardsell DV (1986) The influence of particle-size distribution in pinebark-sand-brown coal potting mixes on water-supply, aeration and plant-growth. Sci Hortic 29:1–14Google Scholar
  40. Robertson RA (1993) Peat, horticulture and environment. Biodivers Conserv 2:541–547Google Scholar
  41. Sambo P, Sannazzaro F, Evans MR (2008) Physical properties of ground fresh rice hulls and sphagnum peat used for greenhouse root substrates. HortTechnology 18:384–388Google Scholar
  42. Sharp RE, Davies WJ (1989) Regulation of growth and development of plants growing with a restricted supply of water. In: Jones HG, Flowers TJ, Jones MB (eds) Plants under stress: biochemistry, physiology and ecology and their application to plant improvement. Cambridge University Press, Cambridge, pp 131–157Google Scholar
  43. Vaughn SF, Deppe NA, Palmquist DE, Berhow MA (2011) Extracted sweet corn tassels as a renewable alternative to peat in greenhouse substrates. Ind Crops Prod 33:514–517Google Scholar

Copyright information

© Korean Society for Horticultural Science 2019

Authors and Affiliations

  1. 1.Department of Horticulture and Landscape ArchitecturePurdue UniversityWest LafayetteUSA

Personalised recommendations