Advertisement

Numerical modeling approach for design of water-retaining dams in underground hard rock mines—a case example

  • John Loui Porathur
  • Minnie Jose
  • Rana Bhattacharjee
  • Subashish Tewari
Original Paper
  • 18 Downloads

Abstract

During transition from open pit extractions to underground mining of an orebody, often both the open pit and the underground workings operate simultaneously, before the former is closed. To avoid the risk of inundation, the underground workings connecting or driven closer to the open pit are isolated using bulkheads. In this paper, the authors reviewed some of the theoretical equations and norms followed worldwide for determining the safe dimensions of a bulkhead to withstand water pressure. It is found that the theoretical equations are insufficient to represent the actual mode of failure and the ultimate pressure–bearing capacity of a bulkhead, as they were developed based on only one mode of failure of the dam construction material. For better representation of the bulkhead failure and its strength determination, it is found prudent to conduct strain-softening numerical modeling simulating a real mining scenario. Mode of dam failure and effect of parameters such as dam thickness and roadway dimensions on the ultimate pressure–bearing capacity of an arched bulkhead are studied. Numerical modeling studies show that the failure initiates with tensile cracking of the dam surface, but the bulkhead ultimately fails in a combination of tension and shear yielding. On comparison, it is found that the tensile failure theories underestimate the pressure-bearing capacity of a dam, while the shear strength– and crushing strength–based equations overestimate the same. Further, an application of the numerical modeling technique for design of water-retaining dams at an underground mine for its safe isolation from the open pit is presented.

Keywords

Bulkhead design Water-retaining dam Numerical modeling Strain softening Underground mining 

Notes

Acknowledgements

The authors would like to thank the Director of CSIR-Central Institute of Mining and Fuel Research for the permission to publish this work. The help and support provided by the officials of Hindustan Zinc Ltd. during the study are gratefully acknowledged.

Compliance with ethical standards

Disclaimer

The views expressed in this paper are those of the authors and not necessarily of the institute to which they belong.

References

  1. Bieniawski ZT (1976) Rock mass classifications in rock engineering. Exploration for Rock Engineering, Rotterdam, Balkema; 1976:97–106Google Scholar
  2. Choi S, Thienel K, Shah SP (1996) Strain softening of concrete in compression under different end constraints. Mag Concr Res 48(175):103–115CrossRefGoogle Scholar
  3. Das MN (1986) Influence of width/height ratio on post-failure behaviour of coal. Int J Min Geol Eng 4:79–87CrossRefGoogle Scholar
  4. Gajer G, Dux PF (1989) Strain-softening analysis of concrete structures. Comput Struct 33(2):575–582, ISSN 0045-7949.  https://doi.org/10.1016/0045-7949(89)90031-X CrossRefGoogle Scholar
  5. Garrett WS, Campbell Pitt LT (1958) Tests on experimental underground bulkhead for high pressures. J Southern Afr Instit Min Metallurgy 1958:123–143Google Scholar
  6. Gupta RN, Mukherjee KP, Singh B (1987) Design of underground artificial dams for mine water storage. Int J Mine Water 6(2):1–14CrossRefGoogle Scholar
  7. Harteis SP, Dolinar DR (2006) Water and slurry bulkheads in underground coal mines: design, monitoring and safety concerns. Min Eng 58:41–47Google Scholar
  8. Hoek E, Brown ET (1980) Empirical strength criterion for rock masses. J Geotech Eng Div ASCE 106(GT9):1013–1035Google Scholar
  9. Kaku LC (2012) D.G.M.S circulars. Lovely Prakashan publications, India, p 1156Google Scholar
  10. Kalmykov EP (1968) Methodology to compute underground water impermeable dams. Ugol 1968:43–51Google Scholar
  11. Mitchel DW (1971) Explosion-proof bulkheads, present practices. BuMines RI 7581:16Google Scholar
  12. Peele, R and Church J A (1918), Mining engineers handbook, John Willey and Sons, Inc., Vol 1, 1918 p 1306–1307Google Scholar
  13. Porathur JL, Karekal S, And Palroy P (2013) Web pillar design approach for highwall mining extraction. Int J Rock Mech Min Sci 64:73–83CrossRefGoogle Scholar
  14. Rajpura Dariba Mine VRM disaster (1994), Wikipedia, https://en.wikipedia.org/wiki/Rajpura_Dariba_Mine_VRM_disaster
  15. Reddiar M K M (2009) Stress-strain model of unconfined and confined concrete and stress-block parameters. Dissertation, Graduate Studies of Texas A&M UniversityGoogle Scholar
  16. Rice GS, Greenwald HP, Howarth HC (1930) Tests of the strength of concrete stoppings designed to resist the pressure of explosions in coal mines. BuMines RI 3036:11Google Scholar
  17. Van Vliet MRA, Van Mier JGM (1995) Softening behavior of concrete in uniaxial compression. Delft University of Technology, The NetherlandsGoogle Scholar
  18. Whitney CS, Anderson BG, Cohen E (1995) Design of blast resistant structures for atomic explosions. J Am Concrete Instit 51:94Google Scholar

Copyright information

© Saudi Society for Geosciences 2018

Authors and Affiliations

  • John Loui Porathur
    • 1
  • Minnie Jose
    • 1
  • Rana Bhattacharjee
    • 2
  • Subashish Tewari
    • 2
  1. 1.CSIR-Central Institute of Mining and Fuel Research, Regional CenterNagpurIndia
  2. 2.CSIR-Central Institute of Mining and Fuel ResearchDhanbadIndia

Personalised recommendations