UV light-induced photocatalytic, antimicrobial, and antibiofilm performance of anodic TiO2 nanotube layers prepared on titanium mesh and Ti sputtered on silicon
- 126 Downloads
The potential use of TiO2 nanotube layers as a self-sterilizing and self-cleaning material for environmental application is presented. Antimicrobial, antibiofilm and photocatalytic performance of anodic TiO2 nanotube layers under UV irradiation was investigated on titanium mesh and on Ti sputtered on silicon substrates. The nanotubes were prepared in fluoride containing ethylene glycol-based electrolyte to obtain ~ 4 µm thick nanotube layers, which were subsequently annealed at 450 °C. Structural and morphological properties of prepared TiO2 layers were characterized using X-ray diffraction, scanning electron microscopy and atomic force microscopy. In addition, their surface wettability, before and after UV irradiation, was investigated. Their photoactivity was compared to TiO2 sol–gel films of similar thickness. The highest efficiency in photocatalytic degradation of organic dye and removal of free-floating bacteria of Gram-positive Staphylococcus epidermidis was observed for TiO2 nanotube layers on titanium mesh. The highest antibiofilm performance in impairments of biofilms was reached using the TiO2 nanotubes on silicon. The obtained results on silicon substrate are promising for the development of medical devices covered by TiO2 nanotubes that would decrease the risk of infection. On the other hand, the mesh substrate covered by TiO2 nanotubes could find environmental applications such as filters in flowing photocatalytic reactors.
KeywordsTiO2 Nanotubes Photocatalytic Antimicrobial Antibiofilm
This work was supported by Scientific Grant Agency of the Slovak Republic (Project VEGA 1/0276/15), by Statutory research of Wrocław Medical University (ST.A.130.16.032); by Ministry of Education, Youth and Sports of the Slovak republic in the framework of the targeted support of the project LO1201 “National Programme for Sustainability I”; by the OPR&DI project Centre for Nanomaterials and by Operational Program Research; by the Grant Agency for Science and Development (APVV 17-0324) and Development (Project ITMS26210120010 and ITMS 26240220027). Assistance of Alicja Seniuk in microbiological experiments is highly acknowledged.
Compliance with ethical standards
Conflict of interest
On behalf of all authors, the corresponding author states that there is no conflict of interest.
- Afsari M, Youzbashi AA, Nuranian H, Zahraee SM (2017) Remarkable improvement of visible light photocatalytic activity of TiO2 nanotubes doped sequentially with noble metals for removing of organic and microbial pollutants. Mater Res Bull 94:15–21. https://doi.org/10.1016/j.materresbull.2017.05.026 CrossRefGoogle Scholar
- Donlan RM (2003) Medical biofilms. Detection, prevention and control—chapter 2.1 Problems of biofilms associated with medical devices and implants. Wiley ISBN 978-0-471-98867-0Google Scholar
- Faraji M, Mohaghegh N, Abedini A (2018) Ternary composite of TiO2 nanotubes/Ti plates modified by g-C3N4 and SnO2 with enhanced photocatalytic activity for enhancing antibacterial and photocatalytic activity. J Photochem Photobiol B 178:124–132. https://doi.org/10.1016/j.jphotobiol.2017.11.009 CrossRefGoogle Scholar
- Gaya UI (2014) Heterogeneous photocatalysis using inorganic semiconductor solids. Springer ISBN 978-94-007-7775-0Google Scholar
- Gaya UI, Abdullah AH (2008) Heterogeneous photocatalytic degradation of organic contaminants over titanium dioxide: a review of fundamentals, progress and problems. J Photochem Photobiol C 9:1–12. https://doi.org/10.1016/j.jphotochemrev.2007.12.003 CrossRefGoogle Scholar
- Jalvo B, Faraldos M, Bahamonde A, Rosal R (2017) Antimicrobial and antibiofilm efficacy of self-cleaning surfaces functionalized by TiO2 photocatalytic nanoparticles against Staphylococcus aureus and Pseudomonas putida. J Hazard Mater 340:160–170. https://doi.org/10.1016/j.jhazmat.2017.07.005 CrossRefGoogle Scholar
- Michal R, Dworniczek E, Caplovicova M, Gregor M, Caplovic L, Seniuk A, Kus P, Plesch G (2014) Photocatalytic and photodisinfectant activity of sulfated and Eu doped anatase against clinically important microorganisms. Ceram Int 40:5745–5756. https://doi.org/10.1016/j.ceramint.2013.11.013 CrossRefGoogle Scholar
- Motola M, Satrapinskyy L, Roch T, Subrt J, Kupcik J, Klementova M, Jakubickova M, Peterka F, Plesch G (2017) Anatase TiO2 nanotube arrays and titania films on titanium mesh for photocatalytic NOx removal and water cleaning. Catal Today 287:59–64. https://doi.org/10.1016/j.cattod.2016.10.011 CrossRefGoogle Scholar
- Motola M, Satrapinskyy L, Caplovicova M, Roch T, Gregor M, Grancic B, Gregus J, Caplovic L, Plesch G (2018) Enhanced photocatalytic activity of hydrogenated and vanadium doped TiO2 nanotube arrays grown by anodization of sputtered Ti layers. Appl Surf Sci 434:1257–1265. https://doi.org/10.1016/j.apsusc.2017.11.253 CrossRefGoogle Scholar
- Park H, Park Y, Kim W, Choi W (2013) Surface modification of TiO2 photocatalyst for environmental applications. J Photochem Photobiol C 15:1–20. https://doi.org/10.1016/j.jphotochemrev.2012.10.001 CrossRefGoogle Scholar
- Vereb G, Manczinger L, Bozso G, Sienkiewicz A, Forro L, Mogyorosi K, Hernadi K, Dombi A (2013) Comparison of the photocatalytic efficiencies of bare and doped rutile and anatase TiO2 photocatalysts under visible light for phenol degradation and E. coli inactivation. Appl Catal B-Environ 129:566–574. https://doi.org/10.1016/j.apcatb.2012.09.045 CrossRefGoogle Scholar