Advertisement

Journal of Phase Equilibria and Diffusion

, Volume 40, Issue 1, pp 45–52 | Cite as

Partial Experimental Isothermal Section of Al-Pd-Co Phase Diagram for Al-Rich Corner at 1020 °C

  • Libor Ďuriška
  • Ivona Černičková
  • Pavol Priputen
  • Jozef JanovecEmail author
Article
  • 46 Downloads

Abstract

Ten alloys with metal compositions (at.%) ranging between (61-75)Al, (7-30)Pd, and (9-22)Co were investigated after annealing at 1020 °C for 500 h. In the investigation, both scanning electron microscopy including energy dispersive x-ray spectroscopy and x-ray diffraction were used. Various combinations of phases F, εn (shortcut for ε-family), U, V, Z-Al3Co, Al5Co2, δ, and β were identified in studied alloys. Partial experimental isothermal section of the Al-Pd-Co phase diagram for Al-rich corner at 1020 °C was proposed, containing homogeneity ranges of eight solid phases (F, εn, U, V, Z-Al3Co, Al5Co2, δ, and β) and liquid.

Keywords

experimental study isothermal section metallic alloys ternary phase diagram 

Notes

Acknowledgments

The authors wish to thank the European Regional Development Fund (ERDF) for financial support of the project ITMS:26220120048 “Center for Development and Application of Advanced Diagnostic Methods in Processing of Metallic and Non-metallic Materials” funded within the Research & Development Operational Programme, the Grant Agency VEGA for the financial support under the contracts 1/0018/15, and the Slovak Research and Development Agency for the financial support under the contract APVV-15-0049.

References

  1. 1.
    J.M. Dubois, Quasicrystals, J. Phys., 2001, 13, p 7753-7762Google Scholar
  2. 2.
    J.M. Dubois, in Basics of Thermodynamics and Phase Transitions in Complex Intermetallics, Book Series on Complex Metallic Alloys, ed. by E. Belin-Ferré, World Scientific, Singapore (2008)Google Scholar
  3. 3.
    J. Delahaye, J.P. Brison, C. Berger, and G. Fourcaudot, Is There a Metal/Insulator Transition in the Quasicrystalline Phase i-Al-Pd-Re, Mater. Sci. Eng. A, 2000, 294-296, p 580-583CrossRefGoogle Scholar
  4. 4.
    T. Eisenhammer, A. Haugeneder, and A. Mahr, High-Temperature Optical Properties and Stability of Selective Absorbers Based on Quasicrystalline AlCuFe, Sol. Energy. Mater. Sol. C, 1998, 54, p 379-386CrossRefGoogle Scholar
  5. 5.
    T. Eisenhammer, A. Mahr, A. Haugeneder, and W. Assmann, Selective Absorbers Based on AlCuFe Thin Films, Sol. Energy Mater. Sol. C, 1997, 46, p 53-65CrossRefGoogle Scholar
  6. 6.
    J. Ledieu, E.J. Cox, R. McGrath, N.V. Richardson, Q. Chen, V. Fournée, T.A. Lograsso, A.R. Ross, K.J. Caspersen, B. Unal, J.W. Evans, and P.A. Thiel, Step Structure on the Fivefold Al-Pd-Mn Quasicrystal Surface and on Related Surface, Surf. Sci., 2005, 583, p 4-15ADSCrossRefGoogle Scholar
  7. 7.
    M. Erbudak, T. Fluckiger, A.R. Kortan, and R. Luscher, Crystal-Quasicrystal Interfaces on Al-Pd-Mn, Prog. Surf. Sci., 2004, 75, p 161-175ADSCrossRefGoogle Scholar
  8. 8.
    F. Samavat, M.J. Gladys, C.J. Jenks, T.A. Lograsso, B.V. King, and D.J. O’Connor, Surface Layer Self Diffusion in Icosahedral Al-Pd-Mn Quasicrystals, Surf. Sci., 2007, 601, p 5678-5682ADSCrossRefGoogle Scholar
  9. 9.
    D. Popović, D. Naumović, M. Bovet, C. Koitzsch, L. Schlapbach, and P. Aebi, Oxidation of Al-Pd-Mn Quasicrystal Surfaces, Surf. Sci., 2001, 492, p 294-304ADSCrossRefGoogle Scholar
  10. 10.
    D.A. Rabson, Toward Theories of Friction and Adhesion on Quasicrystals, Prog. Surf. Sci., 2012, 87, p 253-271ADSCrossRefGoogle Scholar
  11. 11.
    V.N. Balbyshev, D.J. King, A.N. Khramov, L.S. Kasten, and M.S. Donley, Investigation of Quaternary Al-based Quasicrystal Thin Films for Corrosion Protection, Thin Solid Films, 2004, 447-448, p 558-563ADSCrossRefGoogle Scholar
  12. 12.
    Y. Weisskopf, M. Erbudak, J.N. Longchamp, and T. Michlmayr, Ni Deposition on the Pentagonal Surface of an Icosahedral Al-Pd-Mn Quasicrystal, Surf. Sci., 2006, 600, p 2594-2599ADSCrossRefGoogle Scholar
  13. 13.
    L.H. Wearing, J.A. Smerdon, L. Leung, T.A. Lograsso, A.R. Ross, and R. McGrath, Iron Deposition on the Five Fold Surface of the Icosahedral Al-Pd-Mn Quasicrystal, Surf. Sci., 2007, 601, p 3450-3455ADSCrossRefGoogle Scholar
  14. 14.
    D. Reid, J.A. Smerdon, J. Ledieu, and R. McGrath, The Clean and Copper-Dosed Two Fold Surface of the Icosahedral Al-Pd-Mn Quasicrystal, Surf. Sci., 2006, 600, p 4132-4136ADSCrossRefGoogle Scholar
  15. 15.
    P.D. Bloom, K.G. Baikerikar, J.U. Otaigbe, and V.V. Sheares, Development of Novel Polymer/Quasicrystal Composite Materials, Mater. Sci. Eng., A, 2000, 294-296, p 156-159CrossRefGoogle Scholar
  16. 16.
    S. Kenzari, D. Bonina, J.M. Dubois, and V. Fournée, Quasicrystal-Polymer Composites for Selective Laser Sintering Technology, Mater. Des., 2012, 35, p 691-695CrossRefGoogle Scholar
  17. 17.
    T.P. Yadav, D. Singh, R.S. Tiwari, and O.N. Srivastava, Enhanced Microhardness of Mechanically Activated Carbon-Quasicrystal Composite, Mater. Lett., 2012, 80, p 5-8CrossRefGoogle Scholar
  18. 18.
    A. Sakly, S. Kenzari, D. Bonina, S. Corbel, and V. Fournée, A Novel Quasicrystal- Resin Composite for Stereolithography, Mater. Des., 2014, 56, p 280-285CrossRefGoogle Scholar
  19. 19.
    D. Lu, J.P. Celis, S. Kenzari, V. Fournée, and D.B. Zhou, Tribological Behavior of Aluminum Matrix Composites Containing Complex Metallic Alloys AlCuFeB or AlCuFeCr Particles, Wear, 2011, 270, p 528-534CrossRefGoogle Scholar
  20. 20.
    I. Černičková, L. Roščák, F. Ali, M. Kusý, S. Scudino, R. Čička, M. Drienovský, P. Priputen, and J. Janovec, Influence of Technological Parameters on Evolution of Phases in Al-CMA Composites Prepared by Powder Metallurgy, Kovove Mater.-Metallic Mater., 2012, 50, p 327-334Google Scholar
  21. 21.
    T. Tanabe, S. Kameoka, and A.P. Tsai, Microstructure of Leached Al-Cu-Fe Quasicrystal with High Catalytic Performance for Steam Reforming of Methanol, Appl. Catal. A, 2010, 384, p 241-251CrossRefGoogle Scholar
  22. 22.
    B.P. Ngoc, C. Geantet, M. Aouine, G. Bergeret, S. Raffy, and S. Marlin, Quasicrystal Derived Catalyst for Steam Reforming of Methanol, Int. J. Hydrogen Energy, 2008, 33, p 1000-1007CrossRefGoogle Scholar
  23. 23.
    M. Yurechko, B. Grushko, T. Velikanova, and K. Urban, Isothermal Sections of the Al- Pd-Co Alloy System for 50-100 at% Al, J. Alloys Compd., 2002, 337, p 172-181CrossRefGoogle Scholar
  24. 24.
    M. Yurechko and B. Grushko, A Study of the Al-Pd-Co Alloy System, Mater. Sci. Eng. A, 2000, 294-296, p 139-142CrossRefGoogle Scholar
  25. 25.
    I. Černičková, R. Čička, P. Švec, D. Janičkovič, P. Priputen, and J. Janovec, A Study of Phase Equilibria in the Al-Pd-Co System at 700 °C, Aperiodic Crystals (Cairns), S. Schmid, Ed., Springer, Berlin, 2013, p 133-139 Google Scholar
  26. 26.
    I. Černičková, L. Ďuriška, P. Priputen, D. Janičkovič, and J. Janovec, Isothermal Section of the Al-Pd-Co Phase Diagram at 850 °C Delimited by Homogeneity Ranges of Phases Epsilon, U, and F, J. Phase Equilib. Diffus., 2016, 37, p 301-307CrossRefGoogle Scholar
  27. 27.
    M. Heggen, M. Engel, S. Balanetskyy, H. Trebin, and M. Feuerbacher, Structural Variations in ε-Type Al-Pd-(Mn, Fe) Complex Metallic Alloy Phases, Philos. Mag., 2008, 88, p 507-521ADSCrossRefGoogle Scholar
  28. 28.
    S. Mi, M. Yurechko, J. Wu, and B. Grushko, Ternary Al-Pd-Co Monoclinic Phases, J. Alloys Compd., 2001, 329, p L1-L4CrossRefGoogle Scholar
  29. 29.
    P. Priputen, M. Kusý, M. Drienovský, D. Janičkovič, R. Čička, I. Černičková, and J. Janovec, Experimental Reinvestigation of Al-Co Phase Diagram in Vicinity of Al13Co4 Family of Phases, J. Alloys Compd., 2015, 647, p 486-497CrossRefGoogle Scholar
  30. 30.
    M. Yurechko, A. Fattah, T. Velikanova, and B. Grushko, A Contribution to the Al-Pd Phase Diagram, J. Alloys Compd., 2001, 329, p 173-181CrossRefGoogle Scholar
  31. 31.
    I. Černicková, L. Ďuriška, M. Drienovský, D. Janičkovič, and J. Janovec, Phase Transitions in Selected Al-Pd-Co Alloys During Continuous Cooling, Kovove Mater.- Metallic Mater, 2017, 55, p 403-411Google Scholar
  32. 32.
    H. Okamoto, Al-Pd (Aluminium-Palladium), J. Phase Equilib., 2003, 24, p 196CrossRefGoogle Scholar

Copyright information

© ASM International 2018

Authors and Affiliations

  • Libor Ďuriška
    • 1
  • Ivona Černičková
    • 1
  • Pavol Priputen
    • 1
  • Jozef Janovec
    • 2
    Email author
  1. 1.Slovak University of Technology in Bratislava, Faculty of Materials Science and Technology in TrnavaTrnavaSlovak Republic
  2. 2.Slovak University of Technology in BratislavaBratislavaSlovak Republic

Personalised recommendations