Wireless Personal Communications

, Volume 97, Issue 1, pp 397–416 | Cite as

Suitable Optical Fiber Communication Channel for Optical Nonlinearity Signal Processing in High Optical Data Rate Systems

  • Ahmed Nabih Zaki Rashed
  • Mohammed Salah F. Tabbour
Article
First Online:
  • 88 Downloads

Abstract

Our research presents best candidate different commercial optical fiber communication channel for optical nonlinearity signal processing in high optical transmission bit rate systems in the presence of traveling wave semiconductor optical amplifier (TW-OSA). These optical fibers that are namely dispersion flattened fiber (DFF), reverse dispersion fiber (RDF), non zero dispersion shifted fiber, dispersion compensated fiber, single mode fiber, and hybrid RDF + DFF. Wavelength division multiplexing (WDM) system is employed to benefit 80 users with the high transmission bit rates up to 160 Gb/s over optical fiber communication channel length up to 200 km with trying to reduce nonlinearity effects by choosing suitable channel spacing and first or second order Bessel, Gaussian WDM Mux./Demux filter. Maximum peak power, optical signal to noise ratio, and signal quality factor can be measured to test the system performance. It is evident that RDF and hybrid RDF + DFF has presented the highest signal quality factor and optical nonlinearity signal processing in compared with other optical fibers communication channel. The obtained results were done using optiwave system software simulation version 7.

Keywords

SMF RDF DDF NZDSF DCF Q-Factor OSNR Maximum peak power 
This is a preview of subscription content, log in to check access.

References

  1. 1.
    Anju, M. R., & Vipin, V. R. (2015). Simulation and performance analysis of FWM wavelength converter. International Journal of Science and Research (IJSR), 4(2), 501–504. ISSN (Online): 2319-7064.Google Scholar
  2. 2.
    Lekshmi, S. R., & Sindhu, N. (2014). Spectral response of FWM in EDFA for long-haul optical communication. International Journal of Innovative Research in Computer and Communication Engineering, 2(10), 6091–6095. ISSN (Online): 2320-9801, ISSN (Print): 2320-9798.Google Scholar
  3. 3.
    Tyagi, L. K., Jaiswal, A. K., Kumar, M., & Joshi, T. (2012). Performance analysis of four wave mixing based wavelength conversion in commercial optical fibers. International Journal of Scientific and Research Publications, 2(7), 1–5. ISSN: 2250-3153.Google Scholar
  4. 4.
    Pradhan, S., & Patnaik, B. (2016). Qualitative analysis of SPM & performance analysis of FWM in commercial optical fiber by using optisystem. ABHIYANTRIKI: An International Journal of Engineering & Technology, 3(5), 130–135. eISSN: 2394-627X, http://www.aijet.in.
  5. 5.
    Singh, R., Goel, A. K., & Singh, S. (2016). Analysis of third order dispersion and four wave mixing in 16 × 25 Gbps DWDM optical system with variable channel spacing. International Journal of Engineering Development and Research, 4(1), 715–721. (www.ijedr.org), ISSN: 2321-9939.
  6. 6.
    Mallick, B., Pradhan, S., & Prasad, B. (2016). An improved methodology to optimize four wave mixing effect in 32*40 Gbps DWDM optical systems. International Journal of Innovative Research in Computer and Communication Engineering, 4(4), 6861-6868. ISSN (Online): 2320-9801, ISSN (Print): 2320-9798.Google Scholar
  7. 7.
    Aziz, H. M., & Ebad Zahir (2015). Investigating a simulated model of 2.5 GHz 64 channel 140 km DWDM system using EDFA and Raman amplifier considering self-phase modulation. IOSR Journal of Electronics and Communication Engineering (IOSR-JECE), 10(1), Ver. III, 91–95. e-ISSN: 2278-2834, p- ISSN: 2278-8735.Google Scholar
  8. 8.
    Panda, A., & Mishra, D. P. (2014). Nonlinear effect of four wave mixing for WDM in radio-over-fiber systems. Quest Journals, Journal of Electronics and Communication Engineering Research, 2(4), 1–6. ISSN (Online): 2321-5941, www.questjournals.org.
  9. 9.
    OptiSystem Tutorials. (2014). Optical communication system design software version 13 (Vol. 1, pp. 1–500). https://dru5cjyjifvrg.cloudfront.net/wp-content/uploads/2015/03/OptiSystem_Tutorials_Volume_1.pdf.
  10. 10.
    Mukasa, K., Sugizaki, R., Hayami, S., & Ise, S. (2000). Dispersion-managed transmission lines with reverse-dispersion fiber. Furukawa Review, 19, 5–9.Google Scholar
  11. 11.
    Kumano, N., Mukasa, K., Sakano, M., & Moridaira, H. (2002). Development of a non-zero dispersion-shifted fiber with ultra-low dispersion slope. Furukawa Review, 22, 1–6.Google Scholar
  12. 12.
    Feza Büyükşahin Öncel, F. (2009). Modulation formats for wavelength division multiplexing (WDM) systems. A thesis submitted to the Graduate School of Natural and Applied Sciences of Middle East Technical University, Sep. 2009.Google Scholar
  13. 13.
    Geetha, G., Priya, I. L., & Meenakshi, M. (2013). Modeling of broadband light source for optical network applications using fiber non-linear effect. Journal of Theoretical and Applied Information Technology, 58(1), 1–11. org E-ISSN: 1817-3195, ISSN: 1992-8645 www.jatit.org.
  14. 14.
    Makoui, S. (2009). Dispersion flattened optical fiber design for large bandwidth and high-speed optical communications using optimization technique. Progress in Electromagnetics Research B, 13, 21–40.CrossRefGoogle Scholar
  15. 15.
    Binh, L. N., Chin, K.-Y., & Sharma, D. (2003). Design of dispersion flattened and compensating fibers for dispersion managed optical communication systems. Technical Report MECSE-27-2003, pp. 1–16.Google Scholar

Copyright information

© Springer Science+Business Media New York 2017

Authors and Affiliations

  • Ahmed Nabih Zaki Rashed
    • 1
  • Mohammed Salah F. Tabbour
    • 1
  1. 1.Electronics and Electrical Communications Engineering Department, Faculty of Electronic EngineeringMenoufia UniversityMenoufEgypt

Personalised recommendations