Abstract
Wear particle analysis can be potentially developed as an effective method for assessment of osteoarthritis (OA). To achieve this goal, the surface morphological and mechanical properties of human wear particles extracted from the osteoarthritic synovial joints with different OA grades need to be studied. Atomic force microscopy (AFM) has been used for cartilage analysis owing to its high resolution and the capability of revealing both mechanical properties and surface topographical data in three-dimensions. Few studies have been conducted on human wear particles due to difficulties in obtaining the samples and technical challenges in preparing wear debris samples for AFM investigations in a hydrated environment. This work aimed to develop a suitable preparation technique to study the mechanical properties and surface morphology of human wear particles using AFM. Wear particles were separated from synovial fluid samples which were collected from OA patients and deposited on an aldehyde functional plasma polymer surface to immobilise wear particles. They were imaged for the first time using AFM. The nanoscaled surface topographies and nanomechanical properties of the particles were obtained in a hydrated mode. The methodology established in this study enables investigations of the surface morphology and mechanical properties of wear particles at the nanoscale for better understanding of OA and the possibility of developing a new diagnostic method based on the wear debris analysis technique.
This is a preview of subscription content, access via your institution.






References
- 1.
Stolz, M., Gottardi, R., Raiteri, R., Miot, S., Martin, I., Imer, R., Staufer, U., Raducanu, A., Düggelin, M., Baschong, W.: Early detection of aging cartilage and osteoarthritis in mice and patient samples using atomic force microscopy. Nat. Nanotechnol. 4, 186–192 (2009)
- 2.
Goldring, M.B., Goldring, S.R.: Ostearthritis. J. Cell. Physiol. 213, 626–634 (2007)
- 3.
Poole, A.R.: An introduction to the pathophysiology of osteoarthritis. Front. Biosci. 4, 662–670 (1999)
- 4.
Aigner, T., Schmitz, N., Haag, J.: Nanomedicine: AFM tackles osteoarthritis. Nat. Nanotechnol. 4, 144–145 (2009)
- 5.
Peng, Z., Wang, M.: Three dimensional surface characterization of human cartilages at a micron and nanometre scale. Wear (2012). doi:10.1016/j.wear.2012.11.056
- 6.
Mears, D.C., Hanley, E.N., Rutkowski, J., Rutkowski, R.: Ferrography: its application to the study of human knee joint wear. Wear 50, 115–125 (1978)
- 7.
Kuster, M., Podsiadlo, P., Stachowiak, G.: Shape of wear particles found in human knee joints and their relationship to osteoarthritis. Brit. J. Rheumatol. 37, 978–984 (1998)
- 8.
Zha, Z.-G., Yao, C–.C., Tu, M., Huang, Y.-X.: Correlation of the size and shape of the solid particles in synovial fluid and knee joint disease. Curr. Appl. Phys. 7, 112–115 (2007)
- 9.
Tian, Y., Wang, J., Peng, Z., Jiang, X.: A new approach to numerical characterisation of wear particle surfaces in three-dimensions for wear study. Wear 282–283, 59–68 (2012)
- 10.
Stachowiak, G., Podsiadlo, P.: Surface characterization of wear particles. Wear 225, 1171–1185 (1999)
- 11.
Crockett, R., Roos, S., Rossbach, P., Dora, C., Born, W., Troxler, H.: Imaging of the surface of human and bovine articular cartilage with ESEM and AFM. Tribol. Lett. 19, 311–317 (2005)
- 12.
Jurvelin, J., Muller, D., Wong, M., Studer, D., Engel, A., Hunziker, E.: Surface and subsurface morphology of bovine humeral articular cartilage as assessed by atomic force and transmission electron microscopy. J. Struct. Biol. 117, 45–54 (1996)
- 13.
Nikova, D.N., Pope, L.H., Bennink, M.L., van Leijenhorst-Groener, K.A., van der Werf, K., Greve, J.: Unexpected binding motifs for subnucleosomal particles revealed by atomic force microscopy. Biophys. J. 87, 4135–4145 (2004)
- 14.
Outerbridge, R., Dunlop, J.: The problem of chondromalacia patellae. Clin. Orthop. Relat. R 110, 177–196 (1975)
- 15.
Kirk, T.B.: Wear in synovial joints. Department of mechanical engineering. Ph.D. thesis, The University of Western Australia (1992)
- 16.
Peng, Z.: Osteoarthritis diagnosis using wear particle analysis technique: investigation of correlation between particle and cartilage surface in walking process. Wear 262, 630–640 (2007)
- 17.
Vasilev, K., Michelmore, A., Griesser, H.J., Short, R.D.: Substrate influence on the initial growth phase of plasma-deposited polymer films. Chem Commun, 3600–3602 (2009)
- 18.
Vasilev, K., Michelmore, A., Martinek, P., Chan, J., Sah, V., Griesser, H.J., Short, R.D.: Early stages of growth of plasma polymer coatings deposited from nitrogen and oxygen-containing monomers. Plasma Process Polym. 7, 824–835 (2010)
- 19.
Coad, B.R., Vasilev, K., Diener, K.R., Hayball, J.D., Short, R.D., Griesser, H.J.: Immobilized streptavidin gradients as bioconjugation platforms. Langmuir 28, 2710–2717 (2012)
- 20.
Derjaguin, B.V., Muller, V.M., Toporov, Y.P.: Effect of contact deformations on the adhesion of particles. J. Colloid Interf. Sci. 53, 314–326 (1975)
- 21.
Mendel, K., Eliaz, N., Benhar, I., Hendel, D., Halperin, N.: Magnetic isolation of particles suspended in synovial fluid for diagnostics of natural joint chondropathies. Acta. Biomater. 6, 4430–4438 (2010)
- 22.
Hakshur, K., Benhar, I., Bar-Ziv, Y., Halperin, N., Segal, D., Eliaz, N.: The effect of hyaluronan injections into human knees on the number of bone and cartilage wear particles captured by bio-ferrography. Acta. Biomater. 7, 848–857 (2011)
- 23.
Diener, K.R., Christo, S.N., Griesser, S.S., Sarvestani, G.T., Vasilev, K., Griesser, H.J., Hayball, J.D.: Solid-state capture and real-time analysis of individual T cell activation via self-assembly of binding multimeric proteins on functionalized materials surfaces. Acta Biomater. 8, 99–107 (2012)
- 24.
Wang, M., Peng, Z., Wang, J., Jiang, X.: Wear characterisation of articular cartilage surfaces at a nano-scale using atomic force microscopy. Tribol. Int. 63, 235–242 (2013)
- 25.
Nordin, M., Frankel, V.H.: Basic Biomechanics of the Musculoskeletal System, 4th edn. Lippincott Williams and Wilkins, Philadelphia (2012)
Acknowledgments
The authors would like to thank Dr. James Price for providing the clinical samples and associated data. The authors acknowledge the assistance of Laurice Baxter, Emma Horrocks, Peter Bui, Tyler Chin, Yuan Tian in the sample collection process. The authors want to thank Hongjiang Yu for his assistance in the size distribution analysis. Thanks also go to the Advanced Analytical Centre at James Cook University and Mark Wainwright Analytical Centre (Biomedical imaging facility) at the University of New South Wales, Australia for their support in providing the AFM facility for the study. China Scholarship Council (CSC) is acknowledged for providing Meiling Wang’s Ph.D. scholarship during this study. Finally, the authors would like to thank the Australian Research Council (ARC) for funding the Project (DP1093975).
Conflict of interest
There is no conflict of interest in this study.
Author information
Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Wang, M., Peng, Z., Vasilev, K. et al. Investigation of Wear Particles Generated in Human Knee Joints Using Atomic Force Microscopy. Tribol Lett 51, 161–170 (2013). https://doi.org/10.1007/s11249-013-0160-8
Received:
Accepted:
Published:
Issue Date:
Keywords
- Wear particle preparation
- Atomic force microscopy
- Surface morphology
- Nanomechanical property