Catalytic methane reforming into synthesis gas over developed composite materials prepared by combustion synthesis
- 82 Downloads
In this work, the results of carbon dioxide reforming and partial oxidation of CH4 on the catalysts prepared by solution combustion synthesis (SCS) and impregnation of moisture capacity methods are presented. Investigation of the activity of catalysts produced from initial mixture of Co(NO3)2-Μg(NO3)2-H3BO3 and glycine/urea of different composition was carried out for the production of synthesis gas and comparison of carbon dioxide reforming and partial oxidation of methane. Co(ΝΟ3)2 + Mg(NO3)2 + H3BO3 catalyst containing glycine has a higher activity than the catalyst containing urea. The CH4 conversion reaches 54.6%, and the conversion of CO2 increases to 51.7%, while the yield of H2 and CO is 54.1% and 51.3%, respectively, at 900 °C. It was found that CoMg3O4 spinel formation is due to magnesium cations substitution of cobalt cations. Mg2+ ions are replaced by ions of Co2+, as a consequence CoMg3O4 lattice parameters increase, since the ionic radius of Mg2+ (0.66 Å) less than Cο2+ (0.72 Å). Some advantage of SCS catalysts in comparison with catalysts prepared by the traditional impregnation method in the processes of dry reforming and partial oxidation of methane was shown.
KeywordsSCS Combustion synthesis Catalysts Dry reforming Partial oxidation Methane
This publication has been made within the project AP05132348 “Development of modern modified fuels and hydrocarbons for various purposes from gaseous material on new generation composite materials” which is funded by the Ministry of Education and Science of the Republic of Kazakhstan.
- 1.Souza G, Ruoso C, Marcilio NR, Perez-Lopez OW (2016) Dry reforming of methane over Mg-Co-Al mixed-oxides catalysts: effect of Mg content and reduction conditions. Chem Eng Commun 203:783–790Google Scholar
- 19.Merzhanov AG (1997) Worldwide evolution and present status of SHS as a branch of modern R&D. Int J Self-Propag High-Temp Synth 6:119–163Google Scholar
- 20.Gladoun (Xanthopoulou) (1994) Self-propagation high-temperature synthesis of catalysts and supports. G Int J Self-Propag High-Temp Synth 3:51–58Google Scholar
- 21.Pramono A, Kommel L, Kollo L, Veinthal R (2016) The aluminum based composite produced by self propagating high temperature synthesis. Mater. Sci. (Medžiagotyra) 22:41–43Google Scholar
- 22.Bonneau PR, Wiley JB, Kaner RB (1995) Metathetical precursor route to molybdenum disulfide. Inorg Synth 30:33–37Google Scholar
- 26.Niyomwas S, Chaichana N, Memongkol N, Wannasin J (2008) The effects of milling time on the synthesis of titanium diboride powder by self-propagating high temperature synthesis. Songklanakarin J Sci Technol 30:233–238Google Scholar
- 33.Tungatarova S, Xanthopoulou G, Karanasios K, Baizhumanova T, Zhumabek M, Kaumenova G (2017) New composite materials prepared by solution combustion synthesis for catalytic reforming of methane. Chem Eng Trans 61:1921–1926Google Scholar