Structural and phase transformations in the tribosynthesis area of copper-based self-lubricating composite material
- 61 Downloads
- 4 Citations
The paper examines the structural self-organization and adaptation of the surface layers of self-lubricating composite antifriction material (SCAM) IPM-304 to friction conditions. It is shown that temperature jumps and elastoplastic deformation are observed in the tribological contact area in SCAM performance in vacuum under friction. These factors and the difference in thermal expansion coefficients of the matrix and lead, for example, cause partial melting, isolation, layer-by-layer change in shape and size, plasticization, and rearrangement of the antifriction and reinforcing components in thin layers of the friction surface. This results in layer-by-layer changes in the chemical and phase composition, structure, and mechanical properties of surface layers. That is, tribosynthesis proceeds on the material layer responsible for the improvement of SCAM tribotechnical characteristics: decrease in friction coefficient and increase in wear resistance.
Keywords
self-lubricating antifriction composite material composition structure synthesis mechanism temperature melting localization rearrangement plasticization structural self-organization friction coefficient wear resistance mechanical propertiesPreview
Unable to display preview. Download preview PDF.
References
- 1.A. G. Kostornov, O. I. Fushchich, T. M. Chevychelova, et al., “Friction, wear, and targeted synthesis of rubbing surfaces of self-lubricating composites,” Powder Metall. Met. Ceram., 46, No. 3–4, 111–117 (2007).CrossRefGoogle Scholar
- 2.B. N. Dey and M. A. Quader, “An X-ray study of the Cu56Sn10 phase alloy,” Indian J. Physics, 38, 398 (1964).Google Scholar
- 3.A. G. Kostornov, “Modern ideas of friction and wear of tribotechnical systems and targeted synthesis of composite antifriction materials for specific performance conditions,” in: Proc. Int. Conf. on Materials and Coatings in Extreme Conditions: Research, Application, Ecologically Friendly Production and Disposal [in Russian] (September 13–17, 2004, Katsiveli, Crimea), Akademperiodika, Kiev (2004), pp. 306–307.Google Scholar
- 4.A. G. Kostornov, Yu. M. Simeonova, O. I. Fushchich, et al., “Determining effect of the tribosynthesis of new structures in friction area on performance properties of antifriction materials,” in: Issues of Friction and Wear (Collected Scientific Papers) [in Ukrainian], Issue 46, Nats. Aviats. Univ., Kiev (2006), pp. 109–121.Google Scholar
- 5.A. G. Kostornov, Yu. M. Simeonova, O. I. Fushchich, et al., “Effects of factors governing dry friction on structure formation for the tribological synthesis zone in composites based on copper,” Powder Metall. Met. Ceram., 45, No. 3−4, 118–123 (2006).CrossRefGoogle Scholar
- 6.A. G. Kostornov, O. I. Fushchich, V. F. Gorban’, et al., “Dependence of antifriction p-properties of self-lubricating copper-based composite on the elastoplastic characteristics of tribosynthesis region,” Powder Metall. Met. Ceram., 47, No. 11−12, 674–679 (2008).CrossRefGoogle Scholar