Advertisement

Effect of multipath reflection on BER performance of indoor MIMO-VLC system

  • Ajit Kumar
  • S. K. Ghorai
Article
  • 67 Downloads

Abstract

In the present work, the bit error rate (BER) performance due to multipath reflections, namely, line-of-sight (LOS), LOS plus first reflection (L-R1), LOS with first and second reflection (L-R1–R2) for the indoor MIMO-VLC system has been analysed. In the simulation, two cases have been considered. In case 1, the separation between receivers has been increased from 10 to 20 cm whereas, in case 2, the separation between LEDs has been changed from 0.2 to 0.6 m in the interval of 0.2 m. For case 1, it has been found that there is a significant effect on BER performance for higher order reflection than LOS and lower order reflection when the spatial separation between receivers is increased and hence higher order reflection should not be ignored. We have investigated impulse response, root-mean square delay, BER and bit rate performance for case 2 and it has been observed that the spatial separation between LEDs improves BER but reduces coherence bandwidth of the channel. If the coherence bandwidth becomes less than the signal bandwidth then it may result in signal distortion thereby causing inter-symbol interference. Hence, the optimal spatial separation between LEDs should be chosen for the MIMO-VLC system.

Keywords

MIMO VLC BER Diffuse reflection Bit rate RMS delay Condition number 

Notes

Acknowledgements

This research work is supported by University Grant Commission (Ministry of Human Resource Development), Grant/Award Number: F.15-9(JUNE)/2015(NET).

References

  1. Azhar, A.H., Tran, T.A., Brien, D.O.: A gigabit/s indoor wireless transmission using MIMO-OFDM visible-light communications. IEEE Photonics Technol. Lett. 25(2), 171–174 (2013)CrossRefADSGoogle Scholar
  2. Barry, J.R., Kahn, J.M., Krause, W.J., Lee, E.A., Messerschmitt, D.G.: Simulation of multipath impulse response for indoor wireless optical channels. IEEE J. Sel. Areas Commun. 11(3), 367–379 (1993)CrossRefGoogle Scholar
  3. Burton, A., Minh, H.L., Ghassemlooy, Z., Bentley, E., Botella, C.: Experimental demonstration of 50-Mb/s visible light communications using 4 × 4 MIMO. IEEE Photonics Technol. Lett. 26(9), 945–948 (2014)CrossRefADSGoogle Scholar
  4. Chen, C., Zhong, W., Wu, D.: Non-hermitian symmetry orthogonal frequency division multiplexing for multiple-input multiple-output visible light communications. IEEE/OSA J Opt Commun Netw 9(1), 36–44 (2017)CrossRefGoogle Scholar
  5. Fath, T., Hass, H.: Performance comparison of MIMO techniques for optical wireless communications in indoor environments. IEEE Trans. Commun. 61(2), 733–742 (2013)CrossRefGoogle Scholar
  6. Gfeller, F.R., Bapst, U.: Wireless in-house data communication via diffuse infrared radiation. Proc. IEEE 67(11), 1474–1486 (1979)CrossRefGoogle Scholar
  7. Gu, W., Aminikashani, M., Deng, P., Kavehrad, M.: Impact of multipath reflections on the performance of indoor visible light positioning systems. J. Lightwave Technol. 34(10), 2578–2587 (2016)CrossRefADSGoogle Scholar
  8. Gupta, A.K., Chockalingam, A.: Performance of MIMO modulation schemes with imaging receivers in visible light communication. J. Lightwave Technol. 36(10), 1912–1927 (2018)CrossRefADSGoogle Scholar
  9. Hong, Y., Wu, T., Chen, L.K.: On the performance of adaptive MIMO-OFDM indoor visible light communications. IEEE Photonics Technol. Lett. 28(8), 907–910 (2016)CrossRefADSGoogle Scholar
  10. Huang, H., Fing, L., Guo, P., Yang, A., Ni, G.: Iterative positioning algorithm to reduce the impact of diffuse reflection on an indoor visible light positioning system. Opt. Eng. 55(6), 066117-1–066117-7 (2016)CrossRefADSGoogle Scholar
  11. Lian, J., Brandt-Pearce, M.: Multiuser MIMO indoor visible light communication system using spatial multiplexing. J. Lightwave Technol. 35(23), 5024–5033 (2017)CrossRefADSGoogle Scholar
  12. López-Hernandez, F.J., Jimeniz, R.P., Santamaria, A.: Modified Monte Carlo scheme for high-efficiency simulation of the impulse response on diffuse IR wireless indoor channels. Electron. Lett. 34(19), 1819–1820 (1998)CrossRefGoogle Scholar
  13. Miramirkhani, F., Uysal, M.: Channel modeling and characterization for visible light communications. IEEE Photonics J. 7(6), 1–16 (2015)CrossRefGoogle Scholar
  14. Nuwanpriya, A., Ho, S.-W., Chen, C.S.: Indoor MIMO visible light communications: novel angle diversity receivers for mobile users. IEEE J. Sel. Areas Commun. 33(9), 1780–1792 (2015)CrossRefGoogle Scholar
  15. Park, K.M., Oubei, H.G., Alheadary, W.S., Ooi, B., Alouini, M.: A novel mirror-aided non-imaging receiver for indoor 2 × 2 MIMO-visible light communication systems. IEEE Trans Wirel Commun 16(9), 5630–5643 (2017)CrossRefGoogle Scholar
  16. Wang, T.Q., He, C., Armstrong, J.: Performance analysis of aperture-based receivers for MIMO IM/DD visible light communications. J. Lightwave Technol. 35(9), 1513–1523 (2017)CrossRefADSGoogle Scholar

Copyright information

© Springer Science+Business Media, LLC, part of Springer Nature 2018

Authors and Affiliations

  1. 1.Department of Electronics and Communication EngineeringBirla Institute of Technology, MesraRanchiIndia

Personalised recommendations