Advertisement

Measurement Techniques

, Volume 57, Issue 3, pp 266–272 | Cite as

Investigation of the Procedure Error of Coordinate Measurements of the Geometric Parameters of Machine Parts

  • S. E. Ped’
Article

Techniques of simulation modeling of the procedure errors of coordinate measurements are described. Results of such modeling for the diameter and coordinates of the center of the profiles of cylindrical surfaces and deviations from rectilinearity of machine parts for a limited number of points uniformly distributed on the profile are presented.

Keywords

machine parts geometric parameters coordinate measurements 

References

  1. 1.
    S. N. Grigor’ev et al., “Experience of STANKIN Moscow State Technological University in the development of plate-measuring engines of submicron precision,” Kontrol. Diagnost., No. 12, 25–30 (2012).Google Scholar
  2. 2.
    P. N. Emel’yanov, S. Ye. Ped., and I. Ye. Kholin, “Development of a numerically programmed controlled reference plate-measuring engine,” Inform.-Izmerit. Upravl. Sist., 10, No. 8, 68–73 (2012).Google Scholar
  3. 3.
    S. Ye. Ped’ and Ye.V. Darienko, “Error estimates in coordinate measurements of the cross section parameters of cylindrical surfaces,” Izmer. Tekhn., No. 8, 17–19 (2011); Measur. Techn., 54, No. 8, 874–878 (2011).Google Scholar
  4. 4.
    N. N. Markov, Measurement Assurance in Machine Construction, Izd. STANKIN, Moscow (1995).Google Scholar
  5. 5.
    X. L. Wen, Q. G. Xia, and Y. B. Zhao, “An effective genetic algorithm for circularity error unified evaluation,” J. Mach. Tools Manuf., No. 46, 1770–1777 (2006).Google Scholar
  6. 6.
    M. S. Shunmugam, “On assessment of geometric errors,” J. Prod. Res., No. 24 (2), 413–425 (1986).Google Scholar
  7. 7.
    GOST 31254–2004, Basic Standards of Interchangeability. Geometric Elements. General Terms and Definitions.Google Scholar
  8. 8.
    GOST 53442–2009, Basic Standards of Interchangeability. Characteristics of Geometric Articles. Tolerances of Form, Orientation, Position, and Wobble. 272Google Scholar

Copyright information

© Springer Science+Business Media New York 2014

Authors and Affiliations

  1. 1.STANKIN Moscow State Technological UniversityMoscowRussia

Personalised recommendations