Journal of Thermal Analysis and Calorimetry

, Volume 136, Issue 4, pp 1817–1830 | Cite as

Performance analysis and development of a refrigeration cycle through various environmentally friendly refrigerants

Technical, economical and design challenges
  • Shahin Saleh
  • Vahid PirouzfarEmail author
  • Afshar Alihosseini


In this study, a refrigeration cycle was simulated with different refrigerants in a petrochemical plant in Iran. Using Aspen HYSYS Software, necessary modifications were checked as much as possible and optimum values for important parameters affecting cycle of the optimized simulators in the Aspen HYSYS were found. Having found the most economical refrigeration cycle, financial expenses were reduced in the refrigeration cycle. Then, results from the simulation by Aspen HYSYS and Icarus software were compared with actual values of the petrochemical plant under study, and the most efficient and economical strategies to achieve the desired cycle were suggested. Energy consumption of the compressors was optimized by creating a Joule–Thomson balance between VLV-100 and the compressor power of the refrigeration cycle, which reduces the cost of utilities in the refrigeration cycle. The aim of this study is process optimization of the refrigeration cycle economically and also use of the environmental friendly refrigerants.


Refrigeration cycle Simulation Energy optimization Joule–Thomson Economic considerations 





R-502 is an azeotropic blend of R-22 and R-115




Hyprotech system


Capital cost estimator


Peng–Robinson Stryjek and vera


Process flow diagram


Water and steam


  1. 1.
    Anand S, Tyagi SK. Exergy analysis and experimental study of vapor compression refrigeration cycle. J Therm Anal Calorim. 2012;110:961–71.CrossRefGoogle Scholar
  2. 2.
    Mahesh A, Kaushik SC. Solar adsorption refrigeration system using different mass of adsorbents. J Therm Anal Calorim. 2013;111:897–903.CrossRefGoogle Scholar
  3. 3.
    Kaushik SC, Panwar NL, Reddy VS. Thermodynamic evaluation of heat recovery through a Canopus heat exchanger for vapor compression refrigeration(VCR) system. J Therm Anal Calorim. 2012;110:1493–9.CrossRefGoogle Scholar
  4. 4.
    Anand S, Gupta A, Tyagi SK. Comparative thermodynamic analysis of a hybrid refrigeration system for promotion of cleaner technologies. J Therm Anal Calorim. 2014;117:1453–68.CrossRefGoogle Scholar
  5. 5.
    Gupta A, Anand Y, Anand S, Tyagi SK. Thermodynamic Optimization and chemical exergy quantification for absorption-based refrigeration system. J Therm Anal Calorim. 2015;122:893–905.CrossRefGoogle Scholar
  6. 6.
    Zolfaghari M, Pirouzfar V, Sakhaeinia H. Technical identification and economic evaluation of opportunities to recovery flare gas with various gas-processing plants. Energy. 2017;124:481–91.CrossRefGoogle Scholar
  7. 7.
    Saha B, Koyama S, Kashiwagi T, Akisawa A, Chua T. Waste heat driven dualmode, multi-stage, multi-bed regenerative adsorption system. Int J Refrig. 2003;26:749–57.CrossRefGoogle Scholar
  8. 8.
    American Society of Heating, Refrigerating and Air-Conditioning Engineers. Accessed 2016.
  9. 9.
    Samimi A. Micro-organisms of cooling tower problems and how to manage them. Int J Basic. 2013;4:705–15.Google Scholar
  10. 10.
    Parr P, Fred G, Taylor J. Incorporation of chromium in vegetation through root uptake and foliar absorption pathways. Environ Exp Bot. 1980;2:157–60.CrossRefGoogle Scholar
  11. 11.
    Tomczyk J, Silberstein E, Whitman B, Johnson B. Refrigeration and air conditioning technology. 8th ed. Boston: Cengage Learning; 2017.Google Scholar
  12. 12.
    Stanford HW III. HVAC water chillers and cooling towers fundamentals, application, and operation. Boca Raton: CRC Press; 2011.Google Scholar
  13. 13.
    Etoumi A, Jobson M, Emtir M. Shortcut model for predicting refrigeration cycle performance. Chem Eng Trans. 2015;45:217–22.Google Scholar
  14. 14.
    Badr O, Callaghan PWO, Probert SD. Vapour compression refrigeration system. Appl Energy. 1990;36:303–31.CrossRefGoogle Scholar
  15. 15.
    Siva V, Panwar N, Kaushik S. Exergetic analysis of a vapour compression refrigeration system with R134a, R143a, R152a, R404A, R407C, R410A, R502 and R507A. Clean Technol Environ Policy. 2012;14:47–53.CrossRefGoogle Scholar
  16. 16.
    Lopis R, Cabello R, Torrela E. A dynamic model of a shell-and-tube condenser operating in a vapor compression refrigeration plant. Int J Therm Sci. 2008;47:926–34.CrossRefGoogle Scholar
  17. 17.
    Wang FQ, Maidment GG, Missenden JF, Tozer RM. A novel special distributed method for dynamic refrigeration system simulation. Int J Refrig. 2007;30:887–903.CrossRefGoogle Scholar
  18. 18.
    Gerstenmaier SF, Francova M, Kowalski M, Lisal M, Nezbeda I, Smith RW. Molecular-level computer simulation of a vapor-compression refrigeration cycle. Fluid Phase Equilib. 2007;259:195–200.CrossRefGoogle Scholar
  19. 19.
    Zhang Y, Chen J, He J, Wu C. Comparison on the optimum performances of the irreversible Brayton refrigeration cycles with regeneration and non-regeneration. Appl Therm Eng. 2007;27:401–7.CrossRefGoogle Scholar
  20. 20.
    Kang H, Choi K, Park Ch, Kim Y. Effects of accumulator heat exchangers on the performance of a refrigeration system. Int J Refrig. 2007;30:282–9.CrossRefGoogle Scholar
  21. 21.
    Leducq D, Guilparta J, Trystram G. Non-linear predictive control of a vapor compression cycle. Int J Refrig. 2006;29:761–72.CrossRefGoogle Scholar
  22. 22.
    Sarkar J, Bhattacharyya S. Overall conductance and heat transfer area minimization of refrigerators and heat pumps with finite heat reservoirs. Energy Convers Manag. 2007;48:803–8.CrossRefGoogle Scholar
  23. 23.
    Jensen JB, Skogestad S. Control and optimal symposium on computer aided process engineering. (ES-CAPE); 2005.Google Scholar
  24. 24.
    Kim JH, Cho JM, Lee H, Lee JS, Kim MS. Circulation concentration of CO2/propane mixtures and the effect of their charge on the cooling performance in an air-conditioning system. Int J Refrig. 2007;30:43–9.CrossRefGoogle Scholar
  25. 25.
    Rajapaksha L. Influence of special attributes of zeotropic refrigerant mixtures on design and operation of vapor compression refrigeration. Energy Convers Manag. 2007;48:539–45.CrossRefGoogle Scholar
  26. 26.
    Sarkar J, Bhattacharyya S, Ramgopal M. Optimization of critical CO2 heat pump cycle for simultaneous cooling and heating application. Int J Refrig. 2004;27:830–8.CrossRefGoogle Scholar
  27. 27.
    Dossat RJ. Principles of refrigeration. New York: Wiley; 1961.Google Scholar
  28. 28.
    Seif K, Menna M, Elnabawy AO. Semi-empirical correlation for binary interaction parameters of the peng-robinson equation of state with the van der waals mixing rules for the prediction of high-pressure vapor-liquid equilibrium. J Adv Res. 2013;4:137–45.CrossRefGoogle Scholar
  29. 29.
    Jaubert JN, Privat R. Relationship between the binary interaction parameters (Kij) of the Peng–Robinson and those of the Soave–Redlich–Kwong equations of state: application to the definition of the PR2SRK model. Fluid Phase Equilib. 2010;295:26–37.CrossRefGoogle Scholar
  30. 30.
    Geist JM, Lashmet PK. Miniature Joule–Thomson refrigeration system. Adv Cryog Eng. 1960;5:324–31.Google Scholar
  31. 31.
    Schoen M. The Joule–Thomson effect in confined fluids. Physica A. 1999;270:353–79.CrossRefGoogle Scholar
  32. 32.
    Matin NS, Haghighi B. Calculation of the Joule–Thomson inversion curves from cubic equations of state. Fluid Phase Equilib. 2000;175:273–84.CrossRefGoogle Scholar
  33. 33.
    Maric I. The Joule–Thomson effect in natural gas flow-rate measurements. Flow Meas Instrum. 2005;16:387–95.CrossRefGoogle Scholar
  34. 34.
    Chacín A, Vázquez JM, Müller EA. Molecular simulation of the Joule–Thomson inversion curve of carbon dioxide. Fluid Phase Equilib. 1999;1999(165):147–55.CrossRefGoogle Scholar
  35. 35.
    Fredrichkson K, Nellis G, Klein S. A design method for mixed gas Joule–Thomson refrigeration cryosurgical probes. Int J Refrig. 2006;29:700–15.CrossRefGoogle Scholar

Copyright information

© Akadémiai Kiadó, Budapest, Hungary 2018

Authors and Affiliations

  1. 1.Department of Chemical EngineeringCentral Tehran Branch, Islamic Azad UniversityTehranIran

Personalised recommendations