Journal of Polymer Research

, Volume 18, Issue 6, pp 2335–2340 | Cite as

Polylactic acid (PLA)/banana fiber (BF) biodegradable green composites

Original Paper
First Online:
Received:
Accepted:

Abstract

In this study, polylactic acid (PLA)/banana fiber (BF) composites were prepared by melt blending method. The BF was conjugated onto PLA chains through the use of a coupling agent and chemical modification. Consequently, the thermal stability and mechanical properties of the PLA were dramatically elevated through the incorporation of BF. Mechanical tests showed that the tensile and flexural strengths of the composites markedly increased with the fiber content, reaching 78.6 and 65.4 MPa when reinforced with 40 phr fiber, approximately 2 and 1.66 times higher, produced by pristine PLA. However, the impact strengths of composites are somewhat decreased with the increased content of fibers. The addition of 40 phr BF into the composite increased the HDT of pure PLA from 62 °C to 139 °C; an improvement of about 122%. Apart from enhancing the mechanical properties and thermal stability, the incorporation of BF can reduce the production cost of materials while meeting the demands of environmental protection agencies.

Keywords

Polylactic acid (PLA) Banana fiber Green composite Coupling agent 
This is a preview of subscription content, log in to check access.

Notes

Acknowledgements

The authors thank the National Science Council of Taiwan for its financial support (NSC 97-2221-E-324-001). We are also very thankful to the Taiwan Banana Research Institute for supplying the banana fibers used in this study.

References

  1. 1.
    Mohanty AK, Wibowo A, Misra AM et al (2003) Composites: Part A 35:363CrossRefGoogle Scholar
  2. 2.
    Baley C (2002) Composites: Part A 33:939CrossRefGoogle Scholar
  3. 3.
    van Voorn B, Smit HHG, Sinke RJ et al (2001) Composites: Part A 32:1271CrossRefGoogle Scholar
  4. 4.
    Hill CAS, Khalil HPS (2000) J Appl Polym Sci 78:1685CrossRefGoogle Scholar
  5. 5.
    Deshpande AP, Rao MB, Rao CL (2000) J Appl Polym Sci 76:83CrossRefGoogle Scholar
  6. 6.
    Oksman KL, Berglund WLA (2002) J Appl Polym Sci 84:2358CrossRefGoogle Scholar
  7. 7.
    Thwe MM, Liao K (2002) Composites: Part A 33:43CrossRefGoogle Scholar
  8. 8.
    Stael GC, Tavares MIB (2000) Polym Test 19:251CrossRefGoogle Scholar
  9. 9.
    Pothan LA, Oommen Z, Thomas S (2003) Comp Sci Technol 63:283CrossRefGoogle Scholar
  10. 10.
    Pothan LA, Thomas S (2003) Comp Sci Technol 63:1231CrossRefGoogle Scholar
  11. 11.
    Rong MZ, Zhang MQ, Liu Y et al (2001) Comp Sci Technol 61:1437CrossRefGoogle Scholar
  12. 12.
    Garlotta D (2001) J Polym Environ 9:63CrossRefGoogle Scholar
  13. 13.
    Hartmann HM (1998) High molecular weight polylactic acid polymers. In: Kaplan DL (ed) Biopolymers from renewable resources. Springer-Verlag, Berlin, p 367Google Scholar
  14. 14.
    Wu TM, Wu CY (2006) Polym Degrad Stab 91:2198CrossRefGoogle Scholar
  15. 15.
    Wu CS (2005) Macromol Biosci 5:352CrossRefGoogle Scholar
  16. 16.
    Pluta M (2004) Polymer 45:8239CrossRefGoogle Scholar
  17. 17.
    Kulinski Z, Piorkowska E (2005) Polymer 46:10290CrossRefGoogle Scholar
  18. 18.
    Pluta M, Paul MA, Alexandre M et al (2002) J Appl Polym Sci 86:1497CrossRefGoogle Scholar
  19. 19.
    Ray SS, Yamada K, Ogami A et al (2002) Macromol Rapid Commun 23:943CrossRefGoogle Scholar
  20. 20.
    Ray SS, Yamada K, Okamoto M et al (2002) Nano Lett 2:1093CrossRefGoogle Scholar
  21. 21.
    Ray SS, Yamada K, Okamoto M et al (2003) Polymer 44:857CrossRefGoogle Scholar
  22. 22.
    Masirek R, Kulinski Z, Chionna D et al (2007) J Appl Polym Sci 105:255CrossRefGoogle Scholar
  23. 23.
    Plackett D, Andersen TL, Pedersen WB et al (2003) Comp Sci Technol 63:1287CrossRefGoogle Scholar
  24. 24.
    Shibata M, Ozawa K, Teramoto N et al (2003) Macromol Mater Eng 288:35CrossRefGoogle Scholar
  25. 25.
    Pan P, Zhu B, Kai W et al (2007) J Appl Polym Sci 105:1511CrossRefGoogle Scholar
  26. 26.
    Huda MS, Drza LTl, Mohanty AK et al (2008) Comp Sci Technol 68:424CrossRefGoogle Scholar
  27. 27.
    Shih YF, Lee WC, Jeng RJ et al (2006) J Appl Polym Sci 99:188CrossRefGoogle Scholar
  28. 28.
    Wang KH, Wu TM, Shih YF et al (2008) Polym Eng Sci 48:1833CrossRefGoogle Scholar
  29. 29.
    Shih YF, Huang CC, Chen PW (2010) Mater Sci Eng A 527:1516CrossRefGoogle Scholar
  30. 30.
    Shih YF (2007) Mater Sci Eng A 445–446:289–295Google Scholar
  31. 31.
    Britcher L, Kehoe D, Matisons T et al (1995) Macromolecules 28:3110CrossRefGoogle Scholar
  32. 32.
    Pouchert CJ, (Ed.) (1985) The Aldrich Library of infrared spectra, 3rd edn. Aldrich Chemical Company, Milwaukee: 62(123): 1535.Google Scholar
  33. 33.
    Botev M, Betchev H, Bikiaris D et al (1999) J Appl Polym Sci 74:523CrossRefGoogle Scholar
  34. 34.
    Sandi AR, Caulfield DF, Stark NM et al. (1999) In Proceedings of Fifth International Conference on Wood Fiber-Plastic Composites. Forest products Society: Madison, WIGoogle Scholar
  35. 35.
    Fornes TD, Paul DR (2003) Polymer 44:3945CrossRefGoogle Scholar
  36. 36.
    Huda MS, Drzal LT, Misra M, Mohanty AK, Williams K, Mielewski DF (2005) Ind Eng Chem Res 44:5593CrossRefGoogle Scholar
  37. 37.
    Kori Y, Kitagawa K, Hamada H (2005) J Appl Polym Sci 98:603CrossRefGoogle Scholar
  38. 38.
    Pan P, Zhu B, Kai W et al (2007) J Appl Polym Sci 105:1511CrossRefGoogle Scholar
  39. 39.
    Shih YF, Jeng RJ (2002) J Appl Polym Sci 86:1904CrossRefGoogle Scholar
  40. 40.
    Wu CS, Liu YL, Hsu KL (2003) Polymer 44:565CrossRefGoogle Scholar
  41. 41.
    Shih YF, Wang YT, Jeng RJ et al (2004) Polym Degrad Stab 86:339CrossRefGoogle Scholar
  42. 42.
    Pearce EM, Leipins R (1975) Environ Health Perspect 11:59Google Scholar

Copyright information

© Springer Science+Business Media B.V. 2011

Authors and Affiliations

  1. 1.Department of Applied ChemistryChaoyang University of TechnologyTaichungTaiwan

Personalised recommendations