Biodegradable IPN Hydrogels Based on Pre-vulcanized Natural Rubber and Cassava Starch as Coating Membrane for Environment-Friendly Slow-Release Urea Fertilizer
- 44 Downloads
Biodegradable interpenetrating polymer network (IPN) hydrogels based on pre-vulcanized natural rubber (NR) and cassava starch (St) using sulphur (S) and glutaraldehyde (GA) as crosslinkers were developed in a solution form as a coating membrane for slow-release nitrogen fertilizer. The NR/St ratios affecting water swelling, water permeability and biodegradation were investigated. Results revealed that water swelling, water permeability and biodegradation of IPN NR/St hydrogels decreased with increasing NR content. The wax was used as outer coating shell to further improve the release characteristic of the coated urea. The urea bead (UB) coated with IPN NR/St and wax layers (W-IPN-CUB) exhibited exceptional release behavior up to 24 days in soil compared to native UB (3 days). The release mechanisms of W-IPN-CUB in both water and soil environments were a non-Fickian diffusion with n = 0.88 and 0.85, respectively, relating to the diffusion through porous membrane. Also, the W-IPN-CUB was able to slow the leaching of urea fertilizer and significantly improve the performances of corn and basil height compared to native UB (P < 0.05). Thus, the W-IPN-CUB material proved to be a good candidate material for slow release fertilizer which could be widely used in agricultural and horticultural applications.
KeywordsLatex Hydrogel Natural rubber Starch Fertilizer Solution
This work was supported by Grants from National Research Council of Thailand (NRCT, 2558A11702208) and Center of Excellence for Innovation in Chemistry (PERCH-CIC), Office of the Higher Education Commission, Ministry of Education (OHEC). Faculty of Science, Ubon Ratchathani University was also acknowledged for some financial support.
Compliance with Ethical Standards
Conflict of interest
The authors declare no competing financial interest.
- 22.Zohuriaan-Mehr MJ, Kabiri K (2008) Iran Polym J 17:451Google Scholar
- 34.Wittenbrook LS, Scheiderer EL (1978) US Patent 4,082,533 April 1978Google Scholar
- 35.Lubkowski K (2014) Environ Eng Manag 13(10):2573Google Scholar