Skip to main content
Log in

Fabrication of hydrophobic regenerated activated carbon with high specific surface area

  • Composites & nanocomposites
  • Published:
Journal of Materials Science Aims and scope Submit manuscript

Abstract

Activated carbon (AC) has been widely used in the prevention and control of air and water pollution due to its excellent adsorption ability. However, the adsorption capacity of AC for targeting organic compounds is reduced because of the competitive adsorption of water molecules. The current study proposes hydrophobic modification and regeneration of waste AC as a solution to these issues. Using waste AC as raw material, SiO2 particles were introduced to increase its surface roughness and micropores of AC. Nonpolar alkyl chain groups were grafted on the surface of AC to improve its hydrophobic performance, and high-temperature regeneration was used to increase its specific surface area. The experimental results showed that the water contact angle of AC increased from 30° (hydrophilic) to 142° (hydrophobic) after modification, and it maintained an angle of 139° even after high-temperature regeneration. The specific surface area of hydrophobic AC increased from 290 to 1075 m2 g−1 and the equilibrium adsorption capacity of hydrophobic AC for methylene blue is 425.4 mg g−1 after regeneration. AC-adsorbed methylene blue also has excellent hydrophobicity (145°) and high specific surface area (1250 m2 g−1) after being modified and regenerated by the same methods. After being exposed to air for 600 days, the modified AC still has good hydrophobicity (125°). This indicates that our method of hydrophobic modification combined with regeneration has great significance to the recovery and utilization of waste AC.

Graphical abstract

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10

Similar content being viewed by others

References

  1. Bradley R, Smith M, Andreu A, Falco M (2011) Surface studies of novel hydrophobic active carbons. Appl Surf Sci 257:2912–2919

    Article  CAS  Google Scholar 

  2. Bjorklund K, Li LY (2016) Sorption of DOM and hydrophobic organic compounds onto sewage-based activated carbon. Water Sci Technol 74:852–860

    Article  CAS  Google Scholar 

  3. Kameda T, Horikoshi K, Kumagai S, Saito Y, Yoshioka T (2020) Adsorption of urea, creatinine, and uric acid onto spherical activated carbon. Sep Purif Technol 237:116367

    Article  CAS  Google Scholar 

  4. Wang W, Deng S, Li D, Ren L, Shan D, Wang B, Huang J, Wang Y, Yu G (2017) Sorption behavior and mechanism of organophosphate flame retardants on activated carbons. Chem Eng J 332:286–292

    Article  Google Scholar 

  5. You Y, Liu X (2019) Modeling of CO2 adsorption and recovery from wet flue gas by using activated carbon. Chem Eng J 369:672–685

    Article  CAS  Google Scholar 

  6. Aslan M, Zeiger M, Jackel N, Grobelsek I, Weingarth D, Presser V (2016) Improved capacitive deionization performance of mixed hydrophobic/hydrophilic activated carbon electrodes. J Phys Condens Matter 28:114003

    Article  CAS  Google Scholar 

  7. Zhao L, Wu C, Lu X, Ng D, Truong Y, Xie Z (2018) Activated carbon enhanced hydrophobic/hydrophilic dual-layer nanofiber composite membranes for high-performance direct contact membrane distillation. Desalination 446:59–69

    Article  CAS  Google Scholar 

  8. Coleman S, Coronado P, Maxwell R, Reynolds J (2003) Granulated activated carbon modified with hydrophobic silica aerogel-potential composite materials for the removal of uranium from aqueous solutions. Environ Sci Technol 37:2286–2290

    Article  CAS  Google Scholar 

  9. Liu Y, Gu Y, Hou Y, Yang Y, Deng S, Wei Z (2015) Hydrophobic activated carbon supported Ni-based acid-resistant catalyst for selective hydrogenation of phthalic anhydride to phthalide. Chem Eng J 275:271–280

    Article  CAS  Google Scholar 

  10. Om Prakash M, Gujjala R, Panchal M, Ojha S (2020) Mechanical characterization of arhar biomass based porous nano activated carbon polymer composites. Polym Composite 41:3113–3123

    Article  CAS  Google Scholar 

  11. Jaseela PK, Garvasis J, Joseph A (2019) Selective adsorption of methylene blue (MB) dye from aqueous mixture of MB and methyl orange (MO) using mesoporous titania (TiO2)-poly vinyl alcohol (PVA) nanocomposite. J Mol Liq 286:110908

    Article  CAS  Google Scholar 

  12. Mechi N, Khemis IB, Dotto GL, Franco D, Sellaoui L, Lamine AB (2019) Investigation of the adsorption mechanism of methylene blue (MB) on Cortaderia selloana flower spikes (FSs) and on C. selloana flower spikes derived carbon fibers (CFs). J Mol Liq 280:268–273

    Article  CAS  Google Scholar 

  13. Liu Z, Chen G, Hua F, Li X (2020) Synthesis of mesoporous magnetic MnFe2O4@CS-SiO2 microsphere and its adsorption performance of Zn2+ and MB studies. J Environ Manage 263:110377

    Article  CAS  Google Scholar 

  14. Qiu J, Feng Y, Zhang X, Jia M, Yao J (2017) Acid-promoted synthesis of UiO-66 for highly selective adsorption of anionic dyes: adsorption performance and mechanisms. J Coll Interf Sci 499:151–158

    Article  CAS  Google Scholar 

  15. Dizge N, Aydiner C, Demirbas E, Kobya M, Kara S (2008) Adsorption of reactive dyes from aqueous solutions by fly ash: kinetic and equilibrium studies. J Hazard Mater 150:737–746

    Article  CAS  Google Scholar 

  16. Ravikumar K, Krishnan S, Ramalingam S, Balu K (2007) Optimization of process variables by the application of response surface methodology for dye removal using a novel adsorbent. Dyes Pigments 72:66–74

    Article  Google Scholar 

  17. Muthukumar M, Sargunamani D, Selvakumar N (2005) Statistical analysis of the effect of aromatic, azo and sulphonic acid groups on decolouration of acid dye effluents using advanced oxidation processes. Dyes Pigments 65:151–158

    Article  CAS  Google Scholar 

  18. Pereira MFR, Soares SF, Órfão JJ, Figueiredo JL (2003) Adsorption of dyes on activated carbons: influence of surface chemical groups. Carbon 41:811–821

    Article  CAS  Google Scholar 

  19. Qiao X, Hu F, Tian F, Hou D, Li D (2016) Equilibrium and kinetic studies on MB adsorption by ultrathin 2D MoS2 nanosheets. RSC Adv 6:11631

    Article  CAS  Google Scholar 

  20. Kaur H, Bansiwal A, Hippargi G, Pophali GR (2017) Effect of hydrophobicity of pharmaceuticals and personal care products for adsorption on activated carbon: adsorption isotherms, kinetics and mechanism. Environ Sci Pollut Res 25:20473–20485

    Article  Google Scholar 

  21. Li Z, Jin Y, Chen T, Tang F, Cai J, Ma J (2021) Trimethylchlorosilane modified activated carbon for the adsorption of VOCs at high humidity. Sep Purif Technol 272:118659

    Article  CAS  Google Scholar 

  22. Ding H, Zhu Y, Wu Y, Zhang J, Deng H, Zheng H, Liu Z, Zhao C (2020) In situ regeneration of phenol-saturated activated carbon fiber by an electro-peroxymonosulfate process. Environ Sci Technol 54:10944–10953

    Article  CAS  Google Scholar 

  23. Yagmur E, Turkoglu S, Banford A, Aktas Z (2017) The relative performance of microwave regenerated activated carbons on the removal of phenolic pollutants. J Clean Prod 149:1109–1117

    Article  CAS  Google Scholar 

  24. Sun Z, Wang M, Fan J, Zhou Y, Zhang L (2020) Regeneration performance of activated carbon for desulfurization. Appl Sci 10:6107

    Article  CAS  Google Scholar 

  25. Li L, Liu S, Liu J (2011) Surface modification of coconut shell based activated carbon for the improvement of hydrophobic VOC removal. J Hazard Mater 192:683–690

    Article  CAS  Google Scholar 

  26. Li X, Zhang L, Yang Z, He Z, Ran J (2020) Hydrophobic modified activated carbon using PDMS for the adsorption of VOCs in humid condition. Sep Purif Technol 239:116517

    Article  CAS  Google Scholar 

  27. Oz M, Lorke DE, Petroianu GA (2009) Methylene blue and Alzheimer’s disease. Biochem Pharmacol 78:927–932

    Article  CAS  Google Scholar 

  28. Shah-Khan MG, Lovely J, Degnim AC (2012) Safety of methylene blue dye for lymphatic mapping in patients taking selective serotonin reuptake inhibitors. Am J Surg 204:798–799

    Article  CAS  Google Scholar 

  29. Radhi MM, Jaffar Al-Mulla EA, Hoiwdy WH (2012) Effect of temperature on frying oils: infrared spectroscopic studies. Res Chem Intermed 39:3173–3179

    Article  Google Scholar 

  30. Zhu X, Wang D, Ni Y, Wang J, Nie C, Yang C, Lu X, Qiu J, Li L (2020) Cleaner approach to fine coal flotation by renewable collectors prepared by waste oil transesterification. J. Clean. Prod. 252:119822

    Article  CAS  Google Scholar 

  31. Badii K, Church JS, Golkarnarenji G, Naebe M, Khayyam H (2016) Chemical structure based prediction of PAN and oxidized PAN fiber density through a non-linear mathematical model. Polym Degrad Stabil 131:53–61

    Article  CAS  Google Scholar 

  32. Rodríguez-Hermida S, Tsang MY, Vignatti C, Stylianou KC, Guillerm V, Pérez-Carvajal J, Teixidor F, Viñas C (2016) Switchable surface hydrophobicity-hydrophilicity of a metal-organic framework. Angew Chem Int Ed 55:16049–16053

    Article  Google Scholar 

  33. Huang G, Yang Q, Xu Q, Yu S, Jiang H (2016) Polydimethylsiloxane coating for a palladium MOF composite: highly improved catalytic performance by surface hydrophobization. Angew Chem Int Ed 55:7379–7383

    Article  CAS  Google Scholar 

  34. Peng C, Chen Z, Tiwari MK (2018) All-organic superhydrophobic coatings with mechanochemical robustness and liquid impalement resistance. Nat Mater 17:355–360

    Article  CAS  Google Scholar 

  35. Schute K, Louven Y, Detoni C, Rose M (2016) selective liquid phase adsorption of biogenic HMF on hydrophobic spherical activated carbons. Chem Ing Tech 88:355–362

    Article  CAS  Google Scholar 

  36. Ono Y, Futamura R, Hattori Y, Sakai T, Kaneko K (2017) Adsorption-desorption mediated separation of low concentrated D2O from water with hydrophobic activated carbon fiber. J Coll Interface Sci 508:14–17

    Article  CAS  Google Scholar 

  37. Mu´ller E.A., Gubbins K.E, (1998) Molecular simulation study of hydrophilic and hydrophobic behavior of activated carbon surfaces. Carbon 36:1433–1438

    Article  Google Scholar 

  38. Gonçalves M, Molina-Sabio M, Rodriguez-Reinoso F (2010) Adsorption of non-ionic surfactants on hydrophobic and hydrophilic carbon surfaces. J Anal Appl Pyrolysis 89:17–21

    Article  Google Scholar 

  39. Zou X, Zhang H, Chen T, Li H, Meng C, Xia Y, Guo J (2019) Preparation and characterization of polyacrylamide/sodium alginate microspheres and its adsorption of MB dye. Colloids Surf A 567:184–192

    Article  CAS  Google Scholar 

  40. Li W, Wei H, Liu Y, Li S, Wang G, Han H (2021) Fabrication of novel starch-based composite hydrogel microspheres combining Diels-Alder reaction with spray drying for MB adsorption. J Environ Chem Eng 9:105929

    Article  CAS  Google Scholar 

Download references

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Yanbin Cui.

Ethics declarations

Conflict of interest

The authors declare that they have no conflict of interest.

Additional information

Handling Editor: Annela M. Seddon.

Publisher's Note

Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.

Supplementary Information

Below is the link to the electronic supplementary material.

Supplementary file1 (MP4 1460 KB)

Supplementary file2 (MP4 1379 KB)

Supplementary file3 (MP4 62 KB)

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Li, W., Zhang, Q., Zhang, J. et al. Fabrication of hydrophobic regenerated activated carbon with high specific surface area. J Mater Sci 56, 19969–19982 (2021). https://doi.org/10.1007/s10853-021-06525-6

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s10853-021-06525-6

Navigation