Advertisement

Journal of Materials Science

, Volume 41, Issue 18, pp 6077–6080 | Cite as

Cyclic indentation of an elastic-perfectly plastic material

  • Fuqian Yang
  • Aditi Saran
Letter

Fundamental knowledge of the indentation deformation of materials is critical to evaluating dynamic behavior of materials in using the indentation technique. Early studies on the contact of materials provided analytical treatments for both elastic [1, 2, 3, 4, 5, 6] and plastic response [7] subjected to dynamic loading. Despite valuable insight into the indentation deformation of materials from analytical approaches, it is difficult to apply these methods in the analysis of the indentation of elastoplastic materials. Consequently, numerical techniques [8, 9, 10] were advanced to account for complicated geometries and to establish realistic models. The review of literature indicates that the majority of analytical and numerical solutions of various indentation problems involving elastic and elastoplastic materials have focused on the contact deformation under quasi-static conditions. The obtained solutions might not be applicable to dynamic indentation problems. This has imposed a...

Keywords

Plastic Zone Indentation Depth Finite Element Mesh Indentation Load Static Indentation 

Notes

Acknowledgement

This work is supported by NSF through a grant CMS-0508989, supported by Kentucky Science and Engineering Foundation through a grant KSEF-148–502-03-73, and partially supported by General Motors Corporation.

References

  1. 1.
    Pekeris CL (1955) Proc Natl Acad Sci USA 41:469CrossRefGoogle Scholar
  2. 2.
    Lamb H (1904) Phil Trans Royal Soc A203:1CrossRefGoogle Scholar
  3. 3.
    Miller GF, Pursey H (1954) Proc Royal Soc A223:521CrossRefGoogle Scholar
  4. 4.
    Arnold RN, Bycroft CN, Warburton GB (1955) Trans ASME J Appl Mech 22:391Google Scholar
  5. 5.
    Robertson IA (1966) Proc Cambridge Phil Soc 62:547CrossRefGoogle Scholar
  6. 6.
    Gladwell GML (1968) J Sound Vibr 8:215CrossRefGoogle Scholar
  7. 7.
    Tirupataiah Y, Sundararajan G (1991) J Mech Phys Solids 39:243CrossRefGoogle Scholar
  8. 8.
    Lu J, Suresh S, Ravichandran G (2003) J Mech Phys Solids 51:1923CrossRefGoogle Scholar
  9. 9.
    Yang FQ, Li JCM, Shih CW (1995) Mater Sci Eng A 201:50CrossRefGoogle Scholar
  10. 10.
    Yang FQ (1998) Int J Mech Sci 40:87CrossRefGoogle Scholar
  11. 11.
    Chakrabarty J (2006) Theory of Plasticity. 3rd edn. Butterworth-Heinemann, New York Google Scholar
  12. 12.
    ABAQUS users manual version 5.3, Hibbitt, Karlsson, Sorensen, Inc., Providence, Rhode Island, USA (1994)Google Scholar
  13. 13.
    Bhattacharya AK, Nix WD (1988) Inter J Solids Struc 24:881CrossRefGoogle Scholar
  14. 14.
    Li JCM, Chu SNG (1979) Script Metall 13:1021CrossRefGoogle Scholar

Copyright information

© Springer Science+Business Media, LLC 2006

Authors and Affiliations

  1. 1.Department of Chemical and Materials EngineeringUniversity of KentuckyLexingtonUSA

Personalised recommendations