Soft lithography fabrication of index-matched microfluidic devices for reducing artifacts in fluorescence and quantitative phase imaging
- 233 Downloads
Microfluidic devices are widely used for biomedical applications based on microscopy or other optical detection methods. However, the materials commonly used for microfabrication typically have a high refractive index relative to water, which can create artifacts at device edges and limit applicability to applications requiring high-precision imaging or morphological feature detection. Here we present a soft lithography method to fabricate microfluidic devices out of MY133-V2000, a UV-curable, fluorinated polymer with low refractive index that is close to that of water (n = 1.33). The primary challenge in the use of this material (and fluorinated materials in general) is the low adhesion of the fluorinated material; we present several alternative fabrication methods we have tested to improve inter-layer adhesion. The close match between the refractive index of this material and aqueous solutions commonly used in biomedical applications enables fluorescence imaging at microchannel or other microfabricated edges without distortion. The close match in refractive index also enables quantitative phase microscopy imaging across the full width of microchannels without error-inducing artifacts for measurement of cell biomass. Overall, our results demonstrate the utility of low-refractive index microfluidics for biological applications requiring high-precision optical imaging.
KeywordsMicrofluidic device Microfabrication Refractive index Fluorescence imaging Quantitative phase imaging
The authors would like to thank Yu-Chun Kung (NantWorks) for assistance in microfabrication and Dr. Ribas’s laboratory (UCLA) for providing cell lines. Mask and primary SU-8 mold fabrication was performed in the UCLA California NanoSystems Institute’s Integrated Systems Nanofabrication Cleanroom with the assistance of cleanroom staff. This work was supported by the UCLA Jonsson Comprehensive Cancer Center, the Broad Stem Cell Research Center at UCLA, and the National Institutes of Health (K25CA157940). This material is based upon work supported by the National Science Foundation Graduate Research Fellowship Program under Grant No. 114408.
- Mazzoccoli JP, Feke DL, Baskaran H, Pintauro PN (2010) Mechanical and cell viability properties of crosslinked low-and high-molecular weight poly (ethylene glycol) diacrylate blends. J Biomed Mater Res A 93:558–566Google Scholar