Preparation and characterization of high surface area activated carbon from pine wood sawdust by fast activation with H3PO4 in a spouted bed
- 191 Downloads
Activated carbons were produced from waste pine wood sawdust using fast activation with H3PO4 in a spouted bed. In this study, activation temperature was set as 800 °C, and activation time ranged from 1 to 15 min. Experimental results show that sawdust impregnated with higher mass ratio of H3PO4 would be agglomerated in spouted bed, and difficult to fluidize. Therefore, an amount of quartz sand was added to assist for good fluidization. Fluidization of particle can improve the BET surface area or micropore volume of activated carbons. High BET surface area activated carbons can be obtained with activation time of only 1–5 min by combining the fluidization and H3PO4 fast activation. The obtained activated carbons contained developed pore structure and abundant surface functional groups (carboxyl, carbonyl and P-containing groups) by SEM–EDS, FTIR and XPS techniques. The particles of impregnation ratio of 1:1 can achieve fluidization without adding the quartz sand, which was convenient for experimental operation and even industrial production, and the BET surface area can reach more than 1000 m2/g in activation time of only 5 min.
KeywordsPine wood sawdust Activated carbon Fluidization Fast activation Quartz sand
The research is supported by International Joint Research and Development Project of Tianjin Talent Introduction and Science and Technology Cooperation Plan (14RCGFGX00850).
- 48.Macías-García A, Gómez CM, Alfaro DM, Alexandre FM, Martínez NJ (2016) Study of the adsorption and electroadsorption process of Cu(II) ions within thermally and chemically modified activated carbon. J Hazard Mater 2016:46–55Google Scholar
- 52.Terzyk AP (2001) The influence of activated carbon surface chemical composition on the adsorption of acetaminophen (paracetamol) in vitro: part II. TG, FTIR, and XPS analysis of carbons and the temperature dependence of adsorption kinetics at the neutral pH. Colloid Surf A 177:23–45CrossRefGoogle Scholar