Advertisement

Journal of Wood Science

, Volume 64, Issue 6, pp 720–729 | Cite as

Transverse shrinkage variations within tree stems of Melia azedarach planted in northern Vietnam

  • Doan Van Duong
  • Junji Matsumura
Original Article
  • 53 Downloads

Abstract

This study quantified variations within tree stems in tangential shrinkage (αT), radial shrinkage (αR), and tangential/radial shrinkage ratio (αT/αR) of Melia azedarach grown in two different sites in northern Vietnam. The overall values of αT, αR, and αT/αR were 7.05%, 4.38%, and 1.64, respectively. The variation pattern in αT and αR was found to increase gradually from pith to bark and this trend was similar on both sites. In radial direction, the αT/αR decreased significantly from 10 to 50% of the radial length from pith before approaching a constant value toward the outside. The transverse shrinkage variation with height was very small and without statistical significance. There were strong positive relationships between transverse shrinkage and basic density (BD). This implies that the selection for high wood density may lead to increase wood transverse shrinkage. In addition, the αT and αR had significant positive linear relationships with both acoustic wave velocity (VL) and dynamic modulus of elasticity of log (DMOElog). This result suggests that it might be possible to sort lumber with large transverse shrinkage by stress wave method for M. azedarach planted in northern Vietnam.

Keywords

Melia azedarach Transverse shrinkage Non-destructive evaluation Radial position 

Notes

Acknowledgements

The first author was funded by Vietnam government for a Doctor course at Graduate School of Bioresource and Bioenvironmental Sciences, Kyushu University, Fukuoka, Japan.

Compliance with ethical standards

Conflict of interest

The authors declare no conflict of interest.

References

  1. 1.
    Zobel BJ, Van Buijtenen JP (1989) Wood variation, its causes and control. Springer, HeidelbergCrossRefGoogle Scholar
  2. 2.
    Koga S, Zang SY (2004) Inter-tree and intra-tree variations in ring width and wood density components in balsam fir (Abies balsamea). Wood Sci Technol 38:149–162CrossRefGoogle Scholar
  3. 3.
    Wang E, Chen T, Pang S, Karalus A (2008) Variation in anisotropic shrinkage of plantation grown Pinus radiata wood. Maderas. Ciencia y tecnologia 10:243–249Google Scholar
  4. 4.
    Forest Products Laboratory (2010) Wood handbook-wood as an engineering material. General technical report FPL-GTR-190. United States Department of Agriculture Forest Service. MadisonGoogle Scholar
  5. 5.
    Dundar T, Wang X, As N, Avci E (2016) Potential of ultrasonic pulse velocity for evaluating the dimensional stability of oak and chestnut wood. Ultrasonics 66:86–90CrossRefPubMedGoogle Scholar
  6. 6.
    Skaar C (1988) Wood-water relations. Springer, Berlin Heidelberg, pp 122–176Google Scholar
  7. 7.
    Yamashita K, Hirakawa Y, Nakatani H, Ikeda M (2009) Longitudinal shrinkage variations within trees of sugi (Cryptomeria japonica) cultivars. J Wood Sci 55:1–7CrossRefGoogle Scholar
  8. 8.
    Yamashita K, Hirakawa Y, Nakatani H, Ikeda M (2009) Tangential and radial shrinkage variation within trees in sugi (Cryptomeria japonica) cultivars. J Wood Sci 55:161–168CrossRefGoogle Scholar
  9. 9.
    Wang X, Simpson WT (2006) Using acoustic analysis to presort warp-prone ponderosa pine 2 by 4 s before kiln-drying. Wood Fiber Sci 38:206–214Google Scholar
  10. 10.
    Dundar T, Wang X, Ross RJ (2013) Prediction of transverse shrinkages of young-growth Sitka spruce (Picea sitchensis) and western hemlock (Tsuga heterophylla) with ultrasonic measurements. Wood Mat Sci Eng 8:234–241CrossRefGoogle Scholar
  11. 11.
    EL-Juhany LI (2011) Evaluation of some wood quality measures of eight-year-old Melia azedarach trees. Turk J Agric For 35:165–171Google Scholar
  12. 12.
    Harrison NA, Boa E, Carpio ML (2003) Characterization of phytoplasmas detected in Chinaberry trees with symptoms of leaf yellowing and decline in Bolivia. Plant Pathol 52:147–157CrossRefGoogle Scholar
  13. 13.
    Orwa C, Jamnadass RH, Kindt R, Mutua A, Simons A (2009) Agroforestree database: a tree species reference and selection guide version 4.0. http://www.worldagroforestry.org. Accessed 10 Sept 2017
  14. 14.
    Nghia NH (2007) Atlas of Vietnam’s forest tree species. Agric Publ House 1:242Google Scholar
  15. 15.
    Duong DV, Missanjo E, Matsumura J (2017) Variation in intrinsic wood properties of Melia azedarach L. planted in northern Vietnam. J Wood Sci 63:560–567CrossRefGoogle Scholar
  16. 16.
    JIS Z2101-1994 (2000) Methods of test for woods (in Japanese). Japanese Standard Association, TokyoGoogle Scholar
  17. 17.
    R-software and all packages used are available from CRAN at https://cran.r-project.org. Accessed 07 Aug 2017
  18. 18.
    Forestry and Forest Products Research Institute (1975) The properties of tropical woods 21: evaluation of wood properties and wood processing suitabilities of timber from Southeast Asia and the Pacific regions. Bull Gov For Exp Station 277:87–130Google Scholar
  19. 19.
    Pramana GSJ (1998) Holzeigenschaften und Verwendungsmöglichkeiten von Melia azedarach L. aus forstlichem Anbau auf Java (in German). Dissertation, Universität Göttingen. Cuvillier XXI, GöttingenGoogle Scholar
  20. 20.
    Venson I, Guzman JAS, Talavera FJF, Richter HG (2008) Biological, physical and mechanical wood properties of Paraiso (Melia azedarach) from a roadside planting at Huaxtla, Jalisco, Mexico. J Trop For Sci 20:38–47Google Scholar
  21. 21.
    Botero FA (1956) Métodos de ensaios adotados no IPT para o estudo de madeiras nacionais. In: Tabelas e resultados obtidos para madeiras nacionais (in Spanish). Instituto de Pesquisas Tecnologicas, São Paul, Boletim No. 131Google Scholar
  22. 22.
    Coronel EO (1989) Estudio y determinación de las propiedades físico-mecánicas de las maderas del Parque Chaqueño. Valores y variaciones, 1a Parte (in Spanish). Universidad Nacional de Santiago del Estero, Serie de Publicaciones No. 8906Google Scholar
  23. 23.
    Ofori J, Brentuo B (2005) Green moisture content, basic density, shrinkage and drying characteristics of the wood of Cedrela odorata grown in Ghana. J Trop For Sci 17:211–223Google Scholar
  24. 24.
    Kord B, Kialashaki A, Kord B (2010) The within-tree variation in wood density and shrinkage, and their relationship in Populus euramericana. Turk J Agric For 34:121–126Google Scholar
  25. 25.
    Anoop EV, Jijeesh CM, Sindhumathi CR, Jayasree CE (2014) Wood physical, anatomical and mechanical properties of big leaf Mahogany (Swietenia macrophylla Roxb) a potential exotic for south India. Res J Agric For Sci 2:7–13Google Scholar
  26. 26.
    Shanavas A, Kumar BM (2006) Physical and mechanical properties of three agroforestry tree species from Kerala, India. J Trop Agric 44:23–30Google Scholar
  27. 27.
    IAWA Committee (1989) IAWA list of microscopic features for hardwood identification. IAWA J 10:219–332CrossRefGoogle Scholar
  28. 28.
    Fu Z, Zhao J, Yang Y, Cai Y (2016) Variation of drying strains between tangential and radial directions in Asian white birch. Forests 7:59CrossRefGoogle Scholar
  29. 29.
    Dahlblom O, Petersson H, Ormarsson S (1999) Characterization of shrinkage. European project FAIR CT 96-1915, improved Spruce timber utilization. Division of Structural Mechanics, Lund Institute of Technology, Lund University, ScaniaGoogle Scholar
  30. 30.
    Anagnost SE, Mark RE, Hanna RB (2005) S2 orientation of microfibrils in softwood tracheids and hardwood fibers. IAWA J 26:325–338CrossRefGoogle Scholar
  31. 31.
    Montes CS, Beaulieu J, Hernander RE (2007) Genetic variation in wood shrinkage and its correlations with tree growth and wood density of Calycophyllum spruceanum at an early wood in the Peruvian Amazon. Can J For Res 37:966–976CrossRefGoogle Scholar
  32. 32.
    Yang JL, Fife D, Ilic J, Blackwell P (2002) Between-site and between-provenance differences in shrinkage properties of 10-year-old Eucalyptus globulus Labill. Aust For 65:220–226CrossRefGoogle Scholar
  33. 33.
    Istikowati WT, Ishiguri F, Aiso H, Hidayati F, Tanabe J, Iizuka K, Sutiya B, Wahiudy I, Yokota S (2014) Physical and mechanical properties of woods from three native fast-growing species in a secondary forest in south Kalimantan, Indonesia. For Prod J 64:48–54Google Scholar
  34. 34.
    Wu YQ, Hayashi K, Liu Y, Cai Y, Sugimori M (2006) Relationships of anatomical characteristics versus shrinkage and collapse properties in plantation-grown eucalypt wood from China. J Wood Sci 52:187–194CrossRefGoogle Scholar
  35. 35.
    Sadegh AN, Kiaei M, Samariha A (2012) Experimental characterization of shrinkage and density of Tamarix aphylla wood. Cellulose Chem Technol 46:369–373Google Scholar
  36. 36.
    Pliura A, Yu Q, Zhang SY, Mackay J, Perinet P, Bousquet J (2005) Variation in wood density and shrinkage and their relationship to growth of selected young poplar hybrid crosses. For Sci 51:472–482Google Scholar

Copyright information

© The Japan Wood Research Society 2018

Authors and Affiliations

  1. 1.Graduate School of Bioresource and Bioenvironmental SciencesKyushu UniversityFukuokaJapan
  2. 2.Faculty of ForestryThai Nguyen University of Agriculture and ForestryThai NguyenVietnam
  3. 3.Laboratory of Wood Science, Faculty of AgricultureKyushu UniversityFukuokaJapan

Personalised recommendations