Advertisement

Penetration depth measurement in high quality \(\)thin films

  • E. Farber
  • G. Deutscher
  • J. P. Contour
  • E. Jerby

Abstract:

The parallel plate resonator method has been used for measuring high quality \(\) (YBCO) thin films, which have low temperature residual losses comparable to those previously obtained in single crystals. The surface resistance and the real part of the conductivity show a non-monotonic behaviour with a broad peak around 45 K. The penetration depth and the real part of the conductivity vary linearly at low temperatures. The lowest penetration depth linear fitting has a slope value of \(\) to \(\) up to 20 K which is lower than previous measurements on YBCO single crystals. An interpretation of this smaller slope in terms of the generally accepted d-wave order parameter symmetry presents difficulties.

PACS. 74.25.Nf Response to electromagnetic fields (nuclear magnetic resonance, surface impedance, etc.) - 74.72.Bk Y-based cuprates - 74.76.Bz High-Tc films 

Preview

Unable to display preview. Download preview PDF.

Unable to display preview. Download preview PDF.

Copyright information

© EDP Sciences, Springer-Verlag 1998

Authors and Affiliations

  • E. Farber
    • 1
  • G. Deutscher
    • 1
  • J. P. Contour
    • 3
  • E. Jerby
    • 2
  1. 1.School of Physics and Astronomy, Raymond and Beverly Sackler Faculty of Exact Science, Tel Aviv University, Ramat Aviv 69978, IsraelIL
  2. 2.Department of Physical Electronics, Faculty of Engineering, Tel Aviv University, Ramat Aviv 69978, IsraelIL
  3. 3.UMR CNRS/Thomson-CSF,91404 Orsay, FranceFR

Personalised recommendations