Rock Mechanics and Rock Engineering

, Volume 42, Issue 2, pp 175–228 | Cite as

Analytical and Numerical Study of the Mechanics of Rockbolt Reinforcement around Tunnels in Rock Masses

  • C. Carranza-Torres


This paper addresses the problem of quantifying the mechanical contribution of rockbolts installed systematically around tunnels excavated in rock masses. The mechanical contribution referred to here is that of increased stress confinement and decreased tunnel convergences as compared with corresponding stresses and displacements obtained for non-reinforced tunnels. The problem is treated analytically first by presenting a closed-form solution for stress and displacement distributions around a circular tunnel excavated in elastic material and reinforced by grouted or anchored rockbolts. The analytical solution assumes that rockbolts are regularly spaced around the tunnel and that axi-symmetry conditions of geometry and loading apply. The results obtained with the closed-form solution are shown to be equivalent to the results of the same problem solved with traditional numerical methods. Based on the analytical and numerical results and by introducing dimensionless ratios that allow to quantify the increase of radial stresses and the decrease of radial displacements in the reinforced region of the tunnel, the paper shows that reinforcement can have a significant mechanical effect (i.e., increasing the confinement and decreasing the convergences) in tunnels excavated in rock masses of poor to very poor quality. The paper analyzes then the mechanical contribution of rockbolt reinforcement when the rock mass is assumed to behave elasto-plastically. For this case, it is shown that rockbolt reinforcement can also have a critical effect in controlling the extent of the plastic failure zone and the convergences of the tunnel.

Keywords: Tunnel, reinforcement, rockbolt, convergence-confinement, elasticity, elasto-plasticity, numerical modelling, rock mass, Hoek–Brown failure criterion, Geological Strength Index 


Unable to display preview. Download preview PDF.

Unable to display preview. Download preview PDF.


  1. Aydan Ö (1989) The stabilisation of rock engineering structures by rockbolts. Ph.D. Thesis, Department of Geotechnical Engineering, Nagoya University, JapanGoogle Scholar
  2. Barton NR (1987) Predicting the behaviour of underground openings in rock. Manuel Rocha Memorial Lecture, Lisbon. Oslo: Norwegian Geotech. Inst.Google Scholar
  3. Barton, NR, Lien, R, Lunde, J 1974Engineering classification of rock masses for the design of tunnel supportRock Mech6189239CrossRefGoogle Scholar
  4. Bieniawski, ZT 1973Engineering classification of jointed rock massesTrans S Afr Inst Civ Engrs15335344Google Scholar
  5. Bieniawski ZT (1974) Geomechanics classification of rock masses and its application in tunnelling. In: Proc. of the Third Congress of the International Society of Rock Mechanics, Denver, Vol. 2(A), pp 27–32Google Scholar
  6. Bieniawski ZT (1976) Rock mass classification in rock engineering. In: Bieniawski Z (ed) Proc. of the Symposium Exploration for Rock Engineering, 1. Cape Town, Balkema, pp 97–106Google Scholar
  7. Bobet, A 2006A simple method for analysis of point anchored rockbolts in circular tunnels in elastic groundRock Mech Rock Engng39315338CrossRefGoogle Scholar
  8. Bobet A (2007) Elastic solution for deep tunnels. Application to excavation damage zone and rockbolt support. Rock Mech Rock Engng, DOI: 10.1007/s00603-007-0140-0 (Online version)Google Scholar
  9. Brady, BHG, Brown, ET 2004Rock mechanics for underground mining3Kluwer Academic PublishersDordrecht/Boston/LondonGoogle Scholar
  10. Brown ET (1981) Putting the NATM into perspective. Tunnels and Tunnelling, pp 13–17Google Scholar
  11. Brown ET (1999) Rock mechanics and the Snowy Mountain Scheme. In: The Spirit of the Snowy. ATSE Symposium, November 1999. Australian Academy of Technological Sciences and Engineering (Available for downloading at
  12. Carranza-Torres, C 2003Dimensionless graphical representation of the elasto-plastic solution of a circular tunnel in a Mohr-Coulomb materialRock Mech Rock Engng36237253Google Scholar
  13. Carranza-Torres, C, Fairhurst, C 2000Application of the convergence-confinement method of tunnel design to rock-masses that satisfy the Hoek–Brown failure criterionTunn Undergr Sp Tech15187213CrossRefGoogle Scholar
  14. Carranza-Torres, C, Zhao, J 2009Analytical and numerical study of the effect of water pore pressure on the mechanical response of cylindrical lined tunnels in elastic and elasto-plastic porous mediaInt J Rock Mech Min Sci46531547CrossRefGoogle Scholar
  15. Donovan, K, Pariseau, WG, Cepak, M 1984Finite element approach to cable bolting in steeply dipping VCR stopesSociety of Mining EngineersNew York6590Google Scholar
  16. Fairhurst C, Carranza-Torres C (2002) Closing the circle. In: Labuz J, Bentler J (eds) Proceedings of the 50th Annual, Geotechnical Engineering Conference, St. Paul, Minnesota, February 22, 2002. University of Minnesota. (Available for downloading at
  17. Farmer, IW 1975Stress distribution along a resin grouted rock anchorInt J Rock Mech Min Sci Geomech Abstr12347351CrossRefGoogle Scholar
  18. Freeman TJ (1978) The behaviour of fully-bonded rock bolts in the Kielder experimental tunnel. Tunnels and Tunnelling, June, pp 37–40Google Scholar
  19. Graziani A (2000) Evaluation of rockbolt effectiveness in reducing tunnel convergence in squeezing rocks. Rivista Italiana di Geotecnica (1): 64–72Google Scholar
  20. Graziani A, Ribacchi R (1994) Analisi della stabilityà di gallerie profonde e degli effetti del bullonamento. In: Barla G (ed) Conferenze di Meccanica e Ingegneria delle Rocce, MIR, Vol. 5, Torino, Italy, pp 1–16Google Scholar
  21. Grimstad E, Barton N (1993) Updating the Q-System for NMT. In: Kompen O, et al. (eds) Proc. Int. Symp. on Sprayed Concrete – Modern use of wet mix sprayed concrete for underground support, Fagernes. Norwegian Concrete Association, OsloGoogle Scholar
  22. Hoek E (2007) Model to demonstrate how rockbolts work. In: Practical Rock Engineering. (Available for downloading at Hoek’s Corner,
  23. Hoek, E, Brown, ET 1980Underground excavations in rockThe Institute of Mining and MetallurgyLondonGoogle Scholar
  24. Hoek, E, Brown, ET 1997Practical estimates of rock mass strengthInt J Rock Mech Min Sci3411651186CrossRefGoogle Scholar
  25. Hoek, E, Diederichs, MS 2006Empirical estimation of rock mass modulusInt J Rock Mech Min Sci43203215CrossRefGoogle Scholar
  26. Hoek, E, Kaiser, PK, Bawden, WF 1995Support of underground excavations in hard rockBalkemaRotterdamGoogle Scholar
  27. Hoek E, Carranza-Torres C, Corkum B (2002) Hoek–Brown failure criterion, 2002 edn. In: Proceedings of NARMS-TAC 2002, Mining Innovation and Technology. Toronto, 10 July 2002, University of Toronto, pp 267–273 (Available for downloading at Hoek’s Corner,
  28. Hoek E, Carranza-Torres C, Diederichs MS, Corkum B (2008) Integration of geotechnical and structural design in tunnelling. In: Proceedings University of Minnesota 56th Annual Geotechnical Engineering Conference, Minneapolis, 29 February 2008, pp 1–53 (Available for downloading at Hoek’s Corner,
  29. Hudson, JA, Harrison, JP 2000Engineering rock mechanics1Elsevier Science Ltd.OxfordGoogle Scholar
  30. Hyett, AJ, Bawden, WF, Reichert, RD 1992The effect of rock mass confinement on the bond strength of fully grouted cable groutsInt J Rock Mech Min Sci Geomech Abstr29503524CrossRefGoogle Scholar
  31. Hyett, AJ, Moosavi, M, Bawden, WF 1996Load distribution along fully grouted bolts, with emphasis on cable bolt reinforcementInt J Numer Anal Methods Geomech20517544CrossRefGoogle Scholar
  32. Indraratna, B, Kaiser, PK 1990aAnalytical model for the design of grouted rock boltsInt J Numer Anal Methods Geomech14227251CrossRefGoogle Scholar
  33. Indraratna, B, Kaiser, PK 1990bDesign for grouted rock bolts based on the convergence control methodInt J Rock Mech Min Sci Geomech Abstr27269281CrossRefGoogle Scholar
  34. Itasca (2005) FLAC. Fast Lagrangian Analysis of Continua. Version 5.0. ( Minneapolis, Minnesota
  35. Jaeger, JC, Cook, NGW, Zimmerman, R 2007Fundamentals of rock mechanics4Blackwell PublishingMassachusettsGoogle Scholar
  36. Kaiser, P, McCreath, DR, Tannant, D 1996aCanadian rockburst support handbookGeomechanics Research CentreSudbury, CanadaGoogle Scholar
  37. Kaiser, P, Tannant, D, McCreath, DR 1996bDrift support in burst-prone groundThe Canadian Institute of Mining, Metallurgy and Petroleum (CIM) Bulletin89131138Google Scholar
  38. Labiouse, V 1996Ground response curves for rock excavations supported by ungrouted tensioned rockboltsRock Mech Rock Engng291938CrossRefGoogle Scholar
  39. Lang, TA 1961Theory and practice of rock boltingTrans Soc Min Engrs Am Inst Min Metall Petrolm Engrs220333348Google Scholar
  40. Lang TA (1962) Notes on Rock Mechanics and Engineering for Rock Construction, University of California at Berkeley, Vol. I and II, 1962–1964Google Scholar
  41. Lang TA, Bischoff JA (1984) Stability of reinforced rock structures. In: Hudson JA, Brown ET (eds) Design and performance of underground excavations. ISRM Symposium-Cambridege, UK, pp 11–18Google Scholar
  42. Li, C, Stillborg, B 1999Analytical models for rock boltsInt J Rock Mech Min Sci3610131029Google Scholar
  43. Littlejohn, GS, Bruce, DA 1975Rock Anchors: State-of-the-Art. Part I, DesignGround Engineering, Foundation Publications Ltd.Essex, EnglandGoogle Scholar
  44. Oreste, P 2008Distinct analysis of fully grouted bolts around a circular tunnel considering the congruence of displacements between the bar and the rockInt J Rock Mech Min Sci4510521067CrossRefGoogle Scholar
  45. Oreste, PP, Peila, D 1996Radial passive rockbolting in tunneling design with a new convergence-confinement modelInt J Rock Mech Min Sci Geomech Abstr33443454CrossRefGoogle Scholar
  46. Pacher F (1964) Deformationsmessungen in versuchsstollen als mittel zur erforschung des gebirgsverhaltens und zur bemessung des ausbaues. Felsmechanik und Ingenieurs-geologie Supplementum (4): 149–161Google Scholar
  47. Panet M (1995) Calcul des Tunnels par la Méthode de Convergence-Confinement. Press de l’école Nationale des Ponts et ChausséesGoogle Scholar
  48. Papanastassopoulou-Tsatsanifou F (1983) Investigation of effect of rockbolts on stress distribution around underground excavations. In: Proceedings of the International Symposium on Rock Bolting, Abisko, Sweden, Balkema, pp 55–63Google Scholar
  49. Pells, PJN 2008What happened to the mechanics in rock mechanics and the geology in engineering geology?J S Afr I Min Metall108309323Google Scholar
  50. Rabcewicz, LV 1964The new Austrian tunnelling methodWater Power16453515Google Scholar
  51. Reed, MB, Grasso, P, Rizzi, D, Rabajoli, G 1993Improvement of rock properties by bolting in the plastic zone around a tunnel: a numerical studyInt J Rock Mech Min Sci Geomech Abstr30567571CrossRefGoogle Scholar
  52. Rocscience (2002) RocLab, Version 1.0. ( Toronto, Ontario
  53. Rocscience (2006) Version 6. ( Toronto, Ontario
  54. St. John CM, Van Dillen DE (1983) Rockbolts: a new numerical representation and its application in tunnel design. In: Proceedings of the 24th U.S. Symposium on Rock Mechanics, pp 13–25Google Scholar
  55. Stillborg, B 1994Professional users handbook for rock boltingTrans Tech PublicationsGermanyGoogle Scholar
  56. Tanimoto C (1980) Tunnelling in rock with rockbolts and shotcrete. Ph.D. Thesis, Department of Civil Engineering. Kyoto University, JapanGoogle Scholar
  57. Van Dillen DE, St. John CM (1984) An analysis of ground support through fully grouted rockbolts. In: Dowding CH, Singh MM (eds) Proceedings of the 25th Symposium on Rock Mechanics, Northwestern University, pp 231–237Google Scholar
  58. Windsor, CR 1997Rock reinforcement systemsInt J Rock Mech Min Sci34919951CrossRefGoogle Scholar
  59. Windsor, CR, Thompson, AG 1993Rock reinforcement – technology, testing, design and evaluationHudson, JA eds. Comprehensive Rock EngineeringPergamon PressOxford451484Google Scholar

Copyright information

© Springer-Verlag 2009

Authors and Affiliations

  1. 1.Department of Civil EngineeringUniversity of MinnesotaDuluth CampusUSA

Personalised recommendations