Experimental characterization of gasoline sprays under highly evaporating conditions
- 134 Downloads
An experimental investigation of multistream gasoline sprays under highly evaporating conditions is carried out in this paper. Temperature increase of fuel and low engine pressure could lead to flash boiling. The spray shape is normally modified significantly under flash boiling conditions. The spray plumes expansion along with reduction in the axial momentum causes the jets to merge and creates a low-pressure area below the injector’s nozzle. These effects initiate the collapse of spray cone and lead to the formation of a single jet plume or a big cluster like structure. The collapsing sprays reduces exposed surface and therefore they last longer and subsequently penetrate more. Spray plume momentum increase, jet plume reduction and spray target widening could delay or prevent the closure condition and limit the penetration (delayed formation of the cluster promotes evaporation). These spray characteristics are investigated experimentally using shadowgraphy, for five and six hole injectors, under various boundary conditions. Six hole injectors produce more collapsing sprays in comparison to five hole injector due to enhanced jet to jet interactions. The spray collapse tendency reduces with increase in injection pressure due high axial momentum of spray plumes. The spray evaporation rates of five hole injector are observed to be higher than six hole injectors. Larger spray cone angles of the six hole injectors promote less penetrating and less collapsing sprays.
Compliance with ethical standards
Statement of conflict of interest
On behalf of all authors, the corresponding author states that there is no conflict of interest.
- 1.Alkidas AC, El Tahry SH (2003) Contributors to the fuel economy advantage of DISI engines over PFI engines. SAE Tech Pap Ser. doi: https://doi.org/10.4271/2003-01-3101
- 6.Khan M (2014) RANS and LES of multi-hole sprays for the mixture formation in piston engines. Doctoral Dissertation, Ecole Centrale de LyonGoogle Scholar
- 7.Montanaro A, Allocca L (2015) Flash boiling evidences of a multi-hole GDI spray under engine conditions by Mie-scattering measurements. SAE Tech Pap Ser. doi: https://doi.org/10.4271/2015-01-1945
- 8.Khan MM, Hélie J, Gorokhovski M, Sheikh NA (2017) Experimental and numerical study of flash boiling in gasoline direct injection sprays. Appl Therm Eng 123:377–389. https://doi.org/10.1016/j.applthermaleng.2017.05.102 CrossRefGoogle Scholar
- 11.Khan M, Hélie J, Gorokhovski M, Sheikh NA (2017) Air entrainment in high pressure multihole gasoline direct injection sprays. J Appl Fluid Mech 10:1223–1234. https://doi.org/10.18869/acadpub.jafm.73.241.27628 CrossRefGoogle Scholar
- 13.Zeng Y, Lee C (2000) Modeling of spray vaporization and air-fuel mixing in gasoline direct-injection engines. SAE Tech Pap Ser. doi: https://doi.org/10.4271/2000-01-0537
- 18.Montanaro A, Allocca L, Lazzaro M (2017) Iso-octane spray from a GDI multi-hole injector under non- and flash boiling conditions. SAE Tech Pap Ser. doi: https://doi.org/10.4271/2017-01-2319
- 21.Schmitz I, Ipp W, Leipertz A (2002) Flash boiling effects on the development of gasoline direct-injection engine sprays. SAE Tech Pap Ser. doi: https://doi.org/10.4271/2002-01-2661
- 23.Khan MM, Helie J, Gorokhovski M, et al (2012) Numerical analysis of multihole gasoline direct injection sprays. 12th International Conference on Liquid Atomization and Spray Systems, HeidelbergGoogle Scholar